VEHICLE COMMUNICATION SYSTEM QUESTIONS WITH CORRECT ANS!!
what is the resistance of the terminating resistor on networks equipped with one start connector? -
(answer)60 ohms
with the bus active and no faults present, what voltages should be measured on CAN-C(+)? -
(answer)approximately 3.2v
what Atlantis-high network uses splice block connectors? - (answer)CAN-BH
with the bus active and no faults present, what voltages should be measured on CAN-B(-)? -
(answer)approximately 0.4v
which resource should be used first for troubleshooting DRB III Emulator concerns? - (answer)wiTECH
knowledge base
with the bus active and no faults present, what voltages should be measured on LIN? - (answer)7.0v-
10.0v
what electrical architecture requires the use of the mopar diagnostic pod (MPD) for diagnostics? -
(answer)Atlantis-high
which of the following scan tool functions ate prevented if a security gateway (SGW) becomes locked?
select all that apply. - (answer)start an actuator
run a system test
flash program a module
with the bus active and no faults present, what voltages should be measured on CAN-C(-)? -
(answer)approximately 1.8v
what Atlantis vehicles uses splice block connectors on their CAN buses? select all that apply. -
(answer)ga alfa glulia
what is the resistance of the terminating resistor on networks equipped with one start connector? -
(answer)60 ohms
with the bus active and no faults present, what voltages should be measured on CAN-C(+)? -
(answer)approximately 3.2v
what Atlantis-high network uses splice block connectors? - (answer)CAN-BH
with the bus active and no faults present, what voltages should be measured on CAN-B(-)? -
(answer)approximately 0.4v
which resource should be used first for troubleshooting DRB III Emulator concerns? - (answer)wiTECH
knowledge base
with the bus active and no faults present, what voltages should be measured on LIN? - (answer)7.0v-
10.0v
what electrical architecture requires the use of the mopar diagnostic pod (MPD) for diagnostics? -
(answer)Atlantis-high
which of the following scan tool functions ate prevented if a security gateway (SGW) becomes locked?
select all that apply. - (answer)start an actuator
run a system test
flash program a module
with the bus active and no faults present, what voltages should be measured on CAN-C(-)? -
(answer)approximately 1.8v
what Atlantis vehicles uses splice block connectors on their CAN buses? select all that apply. -
(answer)ga alfa glulia
