Guide
c. Gas shut
off valve
and
electrical
shunt
accessibilit
y
d. A liquid
1. Which duty is not the responsibility of a level I tight
Inspec- tor? continuou
A) Handle citizen complaints related to fire s external
weld
and life safety.
B) Perform plans reviews. 4. A
C)Interpret and apply adopted codes and independe
standards.
nt, non-
D) Determine occupancy loads for single-use
profit
build- ings.
organizatio
2. Most of the consensus standards that relate to n that tests
fire and life safety are developed by the products
following organi- zations except: for their
ASTM International, intended
National Fire Protection Assoc., use and
American National Standards certifies
Institute, Underwriters Laboratories them as
safe
3. Regarding Commercial Kitchen Hood Systems, describes:
pipe penetrations of the exhaust hood A) ASTM
require what? Internatio
a. Minimum 18 inch clearance to combustible nal
materi- als B) American
National
b. Printed manufacturer guidelines of spacing
Standards
on the pipe itself Institute
, TCFP Fire Inspector Class – Exam Prep & Study
Guide
Perform plans reviews.
American National Stan- dards Institute
A liquid tight continuous external weld
Underwriters Laboratories Inc.
, TCFP Fire Inspector Class – Exam Prep & Study
Guide
C)Underwriters Laboratories Inc.
D) Standards Council of Canada
5. Which is not one of the three general types of drawings Aerial view
used to show structure, facility, or site information?
A. Plot plan
B. Aerial view
C. Floor plan
D. Elevation view
6. Structural lumber has a moisture 19%
content of
% or
less. 25%
19%
15%
12%
7. Which of the following occupancies does not fall under Post oflce
state and local regulations?
A).Day care
B). Jail
C).Post office
D).Medical facility
8. The typical life cycle of a model code 3-5
edition is
years.
a. 5-7
b. 2-3
c. 7-10
d. 3-5
, TCFP Fire Inspector Class – Exam Prep & Study
Guide
9. For Dry systems exceeding 500 gallons, there must be Not more than
60 seconds
a quick opening device installed unless water is deliv-