EXAM LATEST UPDATED VERSION QUESTIONS AND
VERIFIED CORRECT ANSWERS JUST RELEASED
When performing a single-sided plastic repair, a technician should V-out a groove into
the plastic body part:
Answer Choices:
Select the Correct Answer
All the way through the part
50% through the part
75% through the part
90% through the part - answer>>>75% through the part.
Explanation:
When repairing a plastic bumper part using an approved plastic repair material, a
technician should cut a groove into the part to allow adhesion and contact to the
substrate. The groove should be approximately 75% of the total thickness of the part
being repaired.
Metal fillers contain different ingredients that provide fillers with special properties.
Technician A says petroleum gives fillers more moisture resistance. Technician B says wax
gives fillers more moisture resistance. Who is right?
,Answer Choices:
Select the Correct Answer
Technician A only
Technician B only
Both technicians are correct
Neither technician is correct
Neither technician is correct .
Explanation:
Neither technician is right. Fiberglass offers more resistance to moisture. -
answer>>>Neither technician is correct .
Explanation:
Neither technician is right. Fiberglass offers more resistance to moisture.
A front-wheel drive vehicle was damaged in a collision, the right front wheel taking most
of the impact. The estimate lists the replacement of the tire, wheel, steering knuckle and
sub-frame. Technician A says the outer CV-joint should not be replaced because the boot
,is not ripped. Technician B says the condition of the boot is not an indication of damage
to the CV-joint. Who is right?
Answer Choices:
Select the Correct Answer
Technician A only
Technician B only
Both technicians are correct
Neither technician is correct - answer>>>Technician B only is correct.
Explanation:
While a torn boot (known as a "bellows boot") would indicate possible damage due to
lack of lubrication of a CV-joint, it does not necessarily mean the joint is damaged by way
of impact. The rubber boot covers the joints to avoid the entrance of dust and dirt that
may damage the joints. The criteria for replacing a CV-joint would include obvious
physical damage, such as broken parts, and the introduction of foreign matter into the
joint itself or the splines.
Each licensed appraiser must, when requested, display his or license to:
, Answer Choices:
Select the Correct Answer
The owner of the vehicle being inspected.
The repair garage representative.
An authorized representative of the Insurance Department.
All responses listed are correct. - answer>>>All responses listed are correct. is correct.
Explanation:
Each appraiser, while engaged in appraisal duties, must carry the license issued to him or
her by the Insurance Department and must display it, upon request, to an owner whose
vehicle is being inspected, to the repair shop representative involved or to any
authorized representative of the Insurance Department.
To become a licensed appraiser in the state of Pennsylvania, you must be: