1
Alberta Welding First Year Apprenticeship &
Industry Training (AIT) Final Exam (Latest
Update ) Questions & Answers |
100% Correct | Grade A.
1. Which of the following is an abbreviation of a Non destructive
test ?: UT
2. In common fabricating practice, there are how many basic joint types?:
5
3. Single "V" butt joints are used on material thicknesses of:: 3/8" -1" (9.5
-25.4mm)
4. A small change in sling angle can drastically affect the:: sling load.
5. The power sources used for pulsed spray transfer are:: DC synergic,
microprocessor-controlled.
6. If you must apply force to a suspended load, always pull the load
towards you.:
, 7. When installing clips, the saddle side of the clip must be placed on the::
Live side of the wire
8. When balancing a No. 2 welding tip and the acetylene torch needle
valve is fully open, the acetylene regulator should be adjusted so that
the flame blows away from the tip _______ inch. (Oxygen needle valve
is closed): 1/4
9. Which ferrous-based metals cannot be cut satisfactorily with an oxy-
fuel cutting torch?: stainless
10. What is the total number of hours in the first period Welder Training
Profile?: 240
11. When starting a cut on plate, the preheat cones should be held:: about
3 mm (1/8") above the surface.
12. What is the main purpose of the contact tube?: transfers the welding
current to the filler wire
13. A steamed vessel is safest to weld on when it is cooled down to room
temperature .: False
14. Three basic oxy/acetylene flame types are known as:: carbonizing,
neutral, oxidizing
Alberta Welding First Year Apprenticeship &
Industry Training (AIT) Final Exam (Latest
Update ) Questions & Answers |
100% Correct | Grade A.
1. Which of the following is an abbreviation of a Non destructive
test ?: UT
2. In common fabricating practice, there are how many basic joint types?:
5
3. Single "V" butt joints are used on material thicknesses of:: 3/8" -1" (9.5
-25.4mm)
4. A small change in sling angle can drastically affect the:: sling load.
5. The power sources used for pulsed spray transfer are:: DC synergic,
microprocessor-controlled.
6. If you must apply force to a suspended load, always pull the load
towards you.:
, 7. When installing clips, the saddle side of the clip must be placed on the::
Live side of the wire
8. When balancing a No. 2 welding tip and the acetylene torch needle
valve is fully open, the acetylene regulator should be adjusted so that
the flame blows away from the tip _______ inch. (Oxygen needle valve
is closed): 1/4
9. Which ferrous-based metals cannot be cut satisfactorily with an oxy-
fuel cutting torch?: stainless
10. What is the total number of hours in the first period Welder Training
Profile?: 240
11. When starting a cut on plate, the preheat cones should be held:: about
3 mm (1/8") above the surface.
12. What is the main purpose of the contact tube?: transfers the welding
current to the filler wire
13. A steamed vessel is safest to weld on when it is cooled down to room
temperature .: False
14. Three basic oxy/acetylene flame types are known as:: carbonizing,
neutral, oxidizing
