8/27/25, 5:25 AM Med Gas Study Guide Exam Questions & Answers | 100% Verified solutions |Questions with Correct Answers 2025 latest update!! …
Med Gas Study Guide Exam Questions & Answers
| 100% Verified solutions |Questions with Correct
Answers 2025 latest update!!
Save
Terms in this set (249)
When is the initial pressure After blowdown of a distribution piping
test conducted, by a
medical gas installer, on a
nitrous oxide system?
In those portions of Polymeric
systems intended to
handle oxygen at
pressures greater than 350
psi the interconnecting
hose shall NOT contain
________ materials?
In a Category 1 Dental and Color coding & non-standard pressure
Gas Vacuum Piping
system, which of the
following is an NFPA 99
requirement for the
labeling of pipes?
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 1/48
,8/27/25, 5:25 AM Med Gas Study Guide Exam Questions & Answers | 100% Verified solutions |Questions with Correct Answers 2025 latest update!! …
Which of the following Cut ends shall be rolled smooth or deburred
treatments shall be
performed before brazing
cut ends of a tube to be
installed in a medical gas
piping system?
Manifolds for gas Local, master
cylinders shall actuate
a(an) _______ signal and shall
activate an indicator at all
_______ alarm panels to
indicate when or just
before changeover from
one header to the other.
In a non-anesthetizing Station outlet/inlet
area, on which side of a
zone valve shall the
pressure/vacuum sensor
be located?
What is the purpose of Assure that all ambient air has been removed from the
using an oxygen analyzer pipeline
during the piping purge
prior to brazing?
A medical gas master or Audible and visual
area alarm panel shall be
set to actuate a(an) _____
indicator when the
communication with an
alarm-initiating device is
disconnected.
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 2/48
,8/27/25, 5:25 AM Med Gas Study Guide Exam Questions & Answers | 100% Verified solutions |Questions with Correct Answers 2025 latest update!! …
When an EOSC becomes Providing four connection points to both master
the temporary supply alarms
source, a facility will
monitor the system by use
of which of the following?
Which of the following installation by anyone other than 6010 certified
conditions must be met personnel is NOT permitted
where medical gas and
vacuum systems are
installed by non-certified
personnel?
Which of the following Medical air compressor supply sources
systems shall NOT be
permitted to be located in
an outdoor enclosure?
Metallic flexible joints are suitable for service at 150 psig or above
being used in the pipeline
for vibration control.
Which of the following is
NOT required of such
joints?
who shall witness the the authority having jurisdiction, or its designee
installer-performed
standing vacuum test?
the medical air 25 feet
compressor intake shall
be located a minimum of
how many feet from any
exhaust or plumbing
vents?
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 3/48
, 8/27/25, 5:25 AM Med Gas Study Guide Exam Questions & Answers | 100% Verified solutions |Questions with Correct Answers 2025 latest update!! …
the gas produced by upstream
evaporation from the
secondary header in a
cryogenic liquid cylinder
system shall enter the
supply system ________ of
the final line regulator.
with the approval of the pediatric
Authority Having
Jurisdiction, in which areas
shall the zone valves be
permitted to be secured
to prevent inappropriate
access?
factory installed inlet NPS 1/4, 3/8 in. O.D.
tubes on station outlets
shall be NOT less than
__________with 0.3 inch
minimum inside diameter.
which of these operations testing a system component with a leak detector
would not breach the solution
vacuum system?
except for valves in zone latched or locked in operation position
valve boxes, all valves
shall be located in
secured areas such as
locked pipe chases, or be
__________.
medical gas Central in an unlocked location
Supply systems are NOT
permitted to be located
where?
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 4/48
Med Gas Study Guide Exam Questions & Answers
| 100% Verified solutions |Questions with Correct
Answers 2025 latest update!!
Save
Terms in this set (249)
When is the initial pressure After blowdown of a distribution piping
test conducted, by a
medical gas installer, on a
nitrous oxide system?
In those portions of Polymeric
systems intended to
handle oxygen at
pressures greater than 350
psi the interconnecting
hose shall NOT contain
________ materials?
In a Category 1 Dental and Color coding & non-standard pressure
Gas Vacuum Piping
system, which of the
following is an NFPA 99
requirement for the
labeling of pipes?
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 1/48
,8/27/25, 5:25 AM Med Gas Study Guide Exam Questions & Answers | 100% Verified solutions |Questions with Correct Answers 2025 latest update!! …
Which of the following Cut ends shall be rolled smooth or deburred
treatments shall be
performed before brazing
cut ends of a tube to be
installed in a medical gas
piping system?
Manifolds for gas Local, master
cylinders shall actuate
a(an) _______ signal and shall
activate an indicator at all
_______ alarm panels to
indicate when or just
before changeover from
one header to the other.
In a non-anesthetizing Station outlet/inlet
area, on which side of a
zone valve shall the
pressure/vacuum sensor
be located?
What is the purpose of Assure that all ambient air has been removed from the
using an oxygen analyzer pipeline
during the piping purge
prior to brazing?
A medical gas master or Audible and visual
area alarm panel shall be
set to actuate a(an) _____
indicator when the
communication with an
alarm-initiating device is
disconnected.
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 2/48
,8/27/25, 5:25 AM Med Gas Study Guide Exam Questions & Answers | 100% Verified solutions |Questions with Correct Answers 2025 latest update!! …
When an EOSC becomes Providing four connection points to both master
the temporary supply alarms
source, a facility will
monitor the system by use
of which of the following?
Which of the following installation by anyone other than 6010 certified
conditions must be met personnel is NOT permitted
where medical gas and
vacuum systems are
installed by non-certified
personnel?
Which of the following Medical air compressor supply sources
systems shall NOT be
permitted to be located in
an outdoor enclosure?
Metallic flexible joints are suitable for service at 150 psig or above
being used in the pipeline
for vibration control.
Which of the following is
NOT required of such
joints?
who shall witness the the authority having jurisdiction, or its designee
installer-performed
standing vacuum test?
the medical air 25 feet
compressor intake shall
be located a minimum of
how many feet from any
exhaust or plumbing
vents?
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 3/48
, 8/27/25, 5:25 AM Med Gas Study Guide Exam Questions & Answers | 100% Verified solutions |Questions with Correct Answers 2025 latest update!! …
the gas produced by upstream
evaporation from the
secondary header in a
cryogenic liquid cylinder
system shall enter the
supply system ________ of
the final line regulator.
with the approval of the pediatric
Authority Having
Jurisdiction, in which areas
shall the zone valves be
permitted to be secured
to prevent inappropriate
access?
factory installed inlet NPS 1/4, 3/8 in. O.D.
tubes on station outlets
shall be NOT less than
__________with 0.3 inch
minimum inside diameter.
which of these operations testing a system component with a leak detector
would not breach the solution
vacuum system?
except for valves in zone latched or locked in operation position
valve boxes, all valves
shall be located in
secured areas such as
locked pipe chases, or be
__________.
medical gas Central in an unlocked location
Supply systems are NOT
permitted to be located
where?
https://quizlet.com/1068803070/med-gas-study-guide-exam-questions-answers-100-verified-solutions-questions-with-correct-answers-2025-latest-up… 4/48
