Page 1 of 30
OSHA 510 TEST EXAM/ OSHA 510 STUDY GUIDE
RECENT AND MOST COMPLETE VERSION ALL 350
QUESTIONS AND VERIFIED ANSWERS/ BEST
GRADED A+
The material used in rollover - ANSWER: protection structures must have
the capability of
preforming at what degree - ANSWER: Fahrenheit0
who must have the authority to stop and refuse to handle crane load
until a
qualified person has determine that safety has been - ANSWER:
assured?Crane
Operator
During crane operations when signaling is required, if the signals are
interrupted - ANSWER:
the crane operator shouldSafely stop operation requiring
signals until they are reestablished
____ is/are responsible to train signal persons to meet the 1926.1428 standards
ANSWER: The employer
Page 12 of 30
Rigging equipment for material handling shall be - ANSWER:
inspectedPrior to
use on each shift and as necessary during use
min approach - ANSWER: distance10 feet up to 50kV
04 inches for - ANSWER: every 1kV above 50 kVmin
approach - ANSWER: distance scissor pointsare a hazard
that needs to be gaurded - ANSWER: how does roll over happen?when the
center of gravity passes over the baseline of stability
ROPS only allows rolls of ___ degrees, keeping operators in protective zone
ANSWER: 90
4 major causes of crane - ANSWER: accidentsinstability lack of
communication lack of training inadequate maintenance or
inspection of equipment cranes must be on a firm supporting surface and level
with ____ % - ANSWER: 1 maintain _____ foot min. approach distance of
powerline safety. - ANSWER: 20
inspection requirements 1926.1412 the employer must
maintain record of - ANSWER:
inspections? T or FT
Page 13 of 30
on crane fall height - ANSWER: is?15 feet
, stay out of the swing radius of the crane - make sure there are ____
guards showing - ANSWER: swing radiusBarrier
a ____ person must inspect all machinery and equipment
prior to each use, and during use, to make sure it is in - ANSWER: safe
operating conditionqualified hoisting personnel cannot exceed ___ % of rated
capacity of the crane ANSWER: 50 hoisting proof test to ____ % of
platform rated capacity.125 attach _____ to load to - ANSWER:
reduce the chances of getting fingers crushed handles - ANSWER:
bagged material - ANSWER: storedstacked back by stepping back layer and
cross-keying the bags at least every 10 ft height
bricks - ANSWER: stackingno more than 7 ft high, taper back a loose brick
stack after it is 4 ft high
lumber - ANSWER: stacksdo not exceed 20 feet, if handled manually no
more than 16ft
steel chains for - ANSWER: hoistingmust have tag telling proper status
from manufacture Page 14 of 30 hook ringsmust have the rated
capacity at least equal to that of the chain.
_____ is - ANSWER: the only method allowed to attach end fittings to webbing,
or to form eyes
- ANSWER: Stitching
use ____ chutes when you drop material outside - ANSWER:
of a building enclosed
OSHA - ANSWER: Missionassure safe and healthful working conditions for
working men and women by setting and enforcing standards and by
providing training, outreach, education and assistance
Format Standards - ANSWER: Title, Part, Section/Subpart, Revision year
safety standard - ANSWER: reduce on-the-job injuries health standard -
ANSWER: limited development of occupational
disease - ANSWER:
29 General 1910 General Industry standardsConditions
not covers by specific industry standard may be covered by
GI standards - ANSWER:
Consensus standardswidely agreed-upon guidelines, such as
those developed by the National Fire Protection Association and others.
Not OSHA. - ANSWER: propriety standardsprepared by professional
experts within specific industries, professional, societies, and associations &
determines by straight membership vote, not consensus
Page 15 of 30
General Duty Clause - ANSWER: 5(a)(1)hazard must be reconized by
employers industry, employers obligation to provide
employment free from hazard, used when no standard exists,
abatement methods - ANSWER: recognized by industries reporting
fatal or catastrophesneeds to be reported within 8 hours after
death or hospitalization and - ANSWER: oral report to area office-by phone or
OSHA 510 TEST EXAM/ OSHA 510 STUDY GUIDE
RECENT AND MOST COMPLETE VERSION ALL 350
QUESTIONS AND VERIFIED ANSWERS/ BEST
GRADED A+
The material used in rollover - ANSWER: protection structures must have
the capability of
preforming at what degree - ANSWER: Fahrenheit0
who must have the authority to stop and refuse to handle crane load
until a
qualified person has determine that safety has been - ANSWER:
assured?Crane
Operator
During crane operations when signaling is required, if the signals are
interrupted - ANSWER:
the crane operator shouldSafely stop operation requiring
signals until they are reestablished
____ is/are responsible to train signal persons to meet the 1926.1428 standards
ANSWER: The employer
Page 12 of 30
Rigging equipment for material handling shall be - ANSWER:
inspectedPrior to
use on each shift and as necessary during use
min approach - ANSWER: distance10 feet up to 50kV
04 inches for - ANSWER: every 1kV above 50 kVmin
approach - ANSWER: distance scissor pointsare a hazard
that needs to be gaurded - ANSWER: how does roll over happen?when the
center of gravity passes over the baseline of stability
ROPS only allows rolls of ___ degrees, keeping operators in protective zone
ANSWER: 90
4 major causes of crane - ANSWER: accidentsinstability lack of
communication lack of training inadequate maintenance or
inspection of equipment cranes must be on a firm supporting surface and level
with ____ % - ANSWER: 1 maintain _____ foot min. approach distance of
powerline safety. - ANSWER: 20
inspection requirements 1926.1412 the employer must
maintain record of - ANSWER:
inspections? T or FT
Page 13 of 30
on crane fall height - ANSWER: is?15 feet
, stay out of the swing radius of the crane - make sure there are ____
guards showing - ANSWER: swing radiusBarrier
a ____ person must inspect all machinery and equipment
prior to each use, and during use, to make sure it is in - ANSWER: safe
operating conditionqualified hoisting personnel cannot exceed ___ % of rated
capacity of the crane ANSWER: 50 hoisting proof test to ____ % of
platform rated capacity.125 attach _____ to load to - ANSWER:
reduce the chances of getting fingers crushed handles - ANSWER:
bagged material - ANSWER: storedstacked back by stepping back layer and
cross-keying the bags at least every 10 ft height
bricks - ANSWER: stackingno more than 7 ft high, taper back a loose brick
stack after it is 4 ft high
lumber - ANSWER: stacksdo not exceed 20 feet, if handled manually no
more than 16ft
steel chains for - ANSWER: hoistingmust have tag telling proper status
from manufacture Page 14 of 30 hook ringsmust have the rated
capacity at least equal to that of the chain.
_____ is - ANSWER: the only method allowed to attach end fittings to webbing,
or to form eyes
- ANSWER: Stitching
use ____ chutes when you drop material outside - ANSWER:
of a building enclosed
OSHA - ANSWER: Missionassure safe and healthful working conditions for
working men and women by setting and enforcing standards and by
providing training, outreach, education and assistance
Format Standards - ANSWER: Title, Part, Section/Subpart, Revision year
safety standard - ANSWER: reduce on-the-job injuries health standard -
ANSWER: limited development of occupational
disease - ANSWER:
29 General 1910 General Industry standardsConditions
not covers by specific industry standard may be covered by
GI standards - ANSWER:
Consensus standardswidely agreed-upon guidelines, such as
those developed by the National Fire Protection Association and others.
Not OSHA. - ANSWER: propriety standardsprepared by professional
experts within specific industries, professional, societies, and associations &
determines by straight membership vote, not consensus
Page 15 of 30
General Duty Clause - ANSWER: 5(a)(1)hazard must be reconized by
employers industry, employers obligation to provide
employment free from hazard, used when no standard exists,
abatement methods - ANSWER: recognized by industries reporting
fatal or catastrophesneeds to be reported within 8 hours after
death or hospitalization and - ANSWER: oral report to area office-by phone or
