CCNP SWITCH EXAM QUESTIONS
WITH 100% CORRECT ANSWERS
What type of queuing provides the best quality for voice applications? - Answer-priority
queuing
Refer to the exhibit. What is the problem between the connection on Switch1 and
Switch2? - Answer-encapsulation mismatch
Refer to the exhibit. The exhibit contains the configuration for a Cisco access device.
How will someone dialing in be authenticated? - Answer-RADIUS server and, if that
fails, local username and password
Which multilayer switching forwarding method does Cisco Express Forwarding (CEF)
use? - Answer-topology-based switching
Refer to the exhibit. A network administrator wants to verify the proper operations of the
packet load sharing between a group of redundant routers that are configured with
GLBP. On the basis of the provided output, which router is the Active Virtual Forwarder
(AVF) for Host2? - Answer-the router with an IP address of 10.1.1.2
What is required for SLA to capture one-way delays? - Answer-Network Time Protocol
(NTP)
What is the most common method of configuring inter-VLAN routing on a Layer 3
switch? - Answer-Configure switch virtual interfaces. The result is that the router will
have a virtual interface in each VLAN.
Refer to the exhibit. The indicated configuration was established on the HSRP standby
router RTB. However, the console message %IP-4-DUPADDR started appearing almost
immediately on the RTB router. Given the output of the show standby brief command on
RTA, what is the cause of the problem? - Answer-The group number 50 is missing in
the Router RTB configuration commands.
Which statement correctly explains the process of mitigating ARP attacks on a switch
where dynamic ARP inspection (DAI) has been configured? - Answer-The intercepted
packets are verified against the DHCP snooping binding table for valid IP-to-MAC
bindings.
, Refer to the exhibit. What feature does an SNMP manager need to be able to set a
parameter on ACSw1? - Answer-a manager who is using host 192.168.0.5
Which statement is true concerning the core layer within the hierarchical design model?
- Answer-Routing should be configured without traffic filtering, address translation, or
other packet manipulation at the core.
When a port security violation occurs on a switch port, the switch sends a syslog
message but does not shut down the port. What port security mode is in effect? -
Answer-restrict
Which three steps are required to configure interfaces as routed ports on a multilayer
Catalyst switch? (Choose three.) - Answer-Enable IP routing globally.
Assign IP addresses to routed ports.
Disable Layer 2 functionality on interfaces that will be configured as routed ports.
A bridging loop occurs in a network and disrupts user connectivity. What action should
be taken by a network administrator to restore connectivity? - Answer-Disable ports that
should be in the blocking state.
Which three actions can cause problems with a VTP implementation? (Choose three.) -
Answer-using a non-trunk link to connect switches
using non-Cisco switches
using lowercase on one switch and uppercase on another switch for domain names
Refer to the exhibit. What two conclusions can be made based on the output? (Choose
two.) - Answer-Switch DLS1 is not the root bridge for VLAN 1.
The Cost column in the lower part of the exhibit is not the cumulative root path cost.
Which QoS requirement should be taken into account when implementing VoIP in a
campus environment? - Answer-The QoS requirements should accommodate the
smooth demand on bandwidth, low latency, and delay for voice traffic.
When troubleshooting GLBP in an environment with a VLAN that spans multiple access
layer switches, a network engineer discovers that suboptimal paths are being used for
upstream traffic. What is the recommended solution? - Answer-Use HSRP instead of
GLBP.
Refer to the exhibit. What happens if interface gigabitEthernet 5/1 on SwitchA stops
receiving UDLD packets? - Answer-UDLD changes the port state to err-disable.
How should a switch port be configured for a connection to a standalone wireless
access point that provides multiple VLAN-separated SSIDs? - Answer-as a trunk port
WITH 100% CORRECT ANSWERS
What type of queuing provides the best quality for voice applications? - Answer-priority
queuing
Refer to the exhibit. What is the problem between the connection on Switch1 and
Switch2? - Answer-encapsulation mismatch
Refer to the exhibit. The exhibit contains the configuration for a Cisco access device.
How will someone dialing in be authenticated? - Answer-RADIUS server and, if that
fails, local username and password
Which multilayer switching forwarding method does Cisco Express Forwarding (CEF)
use? - Answer-topology-based switching
Refer to the exhibit. A network administrator wants to verify the proper operations of the
packet load sharing between a group of redundant routers that are configured with
GLBP. On the basis of the provided output, which router is the Active Virtual Forwarder
(AVF) for Host2? - Answer-the router with an IP address of 10.1.1.2
What is required for SLA to capture one-way delays? - Answer-Network Time Protocol
(NTP)
What is the most common method of configuring inter-VLAN routing on a Layer 3
switch? - Answer-Configure switch virtual interfaces. The result is that the router will
have a virtual interface in each VLAN.
Refer to the exhibit. The indicated configuration was established on the HSRP standby
router RTB. However, the console message %IP-4-DUPADDR started appearing almost
immediately on the RTB router. Given the output of the show standby brief command on
RTA, what is the cause of the problem? - Answer-The group number 50 is missing in
the Router RTB configuration commands.
Which statement correctly explains the process of mitigating ARP attacks on a switch
where dynamic ARP inspection (DAI) has been configured? - Answer-The intercepted
packets are verified against the DHCP snooping binding table for valid IP-to-MAC
bindings.
, Refer to the exhibit. What feature does an SNMP manager need to be able to set a
parameter on ACSw1? - Answer-a manager who is using host 192.168.0.5
Which statement is true concerning the core layer within the hierarchical design model?
- Answer-Routing should be configured without traffic filtering, address translation, or
other packet manipulation at the core.
When a port security violation occurs on a switch port, the switch sends a syslog
message but does not shut down the port. What port security mode is in effect? -
Answer-restrict
Which three steps are required to configure interfaces as routed ports on a multilayer
Catalyst switch? (Choose three.) - Answer-Enable IP routing globally.
Assign IP addresses to routed ports.
Disable Layer 2 functionality on interfaces that will be configured as routed ports.
A bridging loop occurs in a network and disrupts user connectivity. What action should
be taken by a network administrator to restore connectivity? - Answer-Disable ports that
should be in the blocking state.
Which three actions can cause problems with a VTP implementation? (Choose three.) -
Answer-using a non-trunk link to connect switches
using non-Cisco switches
using lowercase on one switch and uppercase on another switch for domain names
Refer to the exhibit. What two conclusions can be made based on the output? (Choose
two.) - Answer-Switch DLS1 is not the root bridge for VLAN 1.
The Cost column in the lower part of the exhibit is not the cumulative root path cost.
Which QoS requirement should be taken into account when implementing VoIP in a
campus environment? - Answer-The QoS requirements should accommodate the
smooth demand on bandwidth, low latency, and delay for voice traffic.
When troubleshooting GLBP in an environment with a VLAN that spans multiple access
layer switches, a network engineer discovers that suboptimal paths are being used for
upstream traffic. What is the recommended solution? - Answer-Use HSRP instead of
GLBP.
Refer to the exhibit. What happens if interface gigabitEthernet 5/1 on SwitchA stops
receiving UDLD packets? - Answer-UDLD changes the port state to err-disable.
How should a switch port be configured for a connection to a standalone wireless
access point that provides multiple VLAN-separated SSIDs? - Answer-as a trunk port
