Asphalt 1 Test Review Questions and Answers Best rated A+ Guaranteed Success Latest Update

A thin layer of mix will cool at the same rate whether it is sunny or cloudy False Choose an answer 1 True 2 False Don't know? 8/8/25, 3:23 PM Asphalt 1 Test Review Flashcards | Quizlet be compacted in the longitudinal direction unless the roller cannot compact the joint because site restriction then it is permissible to be compacted transversely False An approximate "rule of thumb" is for every _______ percent increase in air voids above (6 to 7%) about _______ percent of the pavement life may be loss 1 and 10 An end plate (or end gate or edger plate) is attached to the end of the screed to restrict the outward movement of the mix around the end of the screed True An extremely high paver speed - more than ______, for thick lift, may cause a lack of responsiveness of the screed 83 feet per minute Butt joints are acceptable when traffic will not pass over the joint prior to the next paving operation True 8/8/25, 3:23 PM Asphalt 1 Test Review Flashcards | Quizlet wheels, are kept moist with water, and only enough fuel oil to avoid picking up material False Elimination of segregation is the responsibility of Those who produce and lay assault mix State Highway Departments who approve the design of the mix and inspect the final product Manufacturers who designed the market machinery for the paving industry. For asphalt mixes, it can be expected that approximately ______ to _____ percent of the theoretical maximum density of the mix will be realized in the mix when it passes out from under a vibratory paver screed 70 to 80 If the air voids are above ______ percent for a SM- 9.5A, the mix will be permeable to air and water, and will not have the required durability 7 to 8 If the mat is being laid down at a facer rate, then it can be rolled, the solution should be to ______ Slow down the paver Use larger, wider rollers. Use more rollers 8/8/25, 3:23 PM Asphalt 1 Test Review Flashcards | Quizlet end of the paving, a butt joint will be permitted, provided proper compaction is achieved False If traffic will pass over the transverse joint, constructive slubbed wage, at least_____feet per inch of pavement depth, ahead of end of the full debt payment to provide for proper compassion and protection of the full depth pavement 3 It typically takes ___t ow lengths (the length between the toe point, and the screed) after a desired level is input for a screed to arrive at the new level 5 Cold lane A previously paved lane Hot lane A lane being currently placed Joint overlap The width, that the hot lane overlaps the cold lane The low-density areas on radiographic image are created by This area is typically at the outer edge of the cold lane taper in the joint overlap area