8/7/25, 8:54 PM ASE (Entry level technician prep) - Electrical A6
ASE A6 ENTRY LEVEL TECHNICIAN ELECTRICAL PREP
EXAM 2025 -2026 LATEST VERSION WITH COMPLETE
QUESTIONS AND ACCURATE DETAILED ANSWERS
\VERIFIED 100%
All of the following Answer B is correct! An oscilloscope converts electrical
statements about using a signals into a visual image representing voltage chanes
lab scope for diagnosis over a specific period of time. B is a false statement
are correct
EXCEPT:
A) An upward movement
of the trace means the
voltage has increased
and a downward
movement means the
voltage has decreased.
B) The size and clarity of
the trace is dependent
on the cleanness of the
connection and the
component or circuit being
tested.
C) A flat waveform means
the voltage is staying at
that level.
D) As the trace moves across
the screen of the
oscilloscope, time is
/ 1/27
,8/7/25, 8:54 PM ASE (Entry level technician prep) - Electrical A6
represented.
/ 2/27
, 8/7/25, 8:54 PM ASE (Entry level technician prep) - Electrical A6
During an output test Answer A is correct! A shorted diode in a gneerator will
using the full-field method, typically cause the amperage output to be about
a 100-ampere alternator one-third less than normal.
with an integral regulator
produces 60 amperes.
The cause of the low
alternator output could
be:
A) a shortened diode in the
alternator
B) a broken brush lead
wire in the
alternator.
C) an open circuit in the voltage
regulator.
a defective alternator
D)
capacitor.
The charging system voltage Answer D is correct! Obviously 16.2 volts from the
on a vehicle is charging station is too much for a 12-volt battery.
16.2V. This condition may
Answer A is correct. B is also correct - the high voltage
cause all the following
could cause damage to electronic components. With
problems EXCEPT:
an overcharged battery, gassing does
increase, so C is also correct.
A) an overcharged battery.
B) burned-out electrical
components.
C)electrolyte gassing in
the battery.
D)reduced headlight brilliance
/ 3/27
ASE A6 ENTRY LEVEL TECHNICIAN ELECTRICAL PREP
EXAM 2025 -2026 LATEST VERSION WITH COMPLETE
QUESTIONS AND ACCURATE DETAILED ANSWERS
\VERIFIED 100%
All of the following Answer B is correct! An oscilloscope converts electrical
statements about using a signals into a visual image representing voltage chanes
lab scope for diagnosis over a specific period of time. B is a false statement
are correct
EXCEPT:
A) An upward movement
of the trace means the
voltage has increased
and a downward
movement means the
voltage has decreased.
B) The size and clarity of
the trace is dependent
on the cleanness of the
connection and the
component or circuit being
tested.
C) A flat waveform means
the voltage is staying at
that level.
D) As the trace moves across
the screen of the
oscilloscope, time is
/ 1/27
,8/7/25, 8:54 PM ASE (Entry level technician prep) - Electrical A6
represented.
/ 2/27
, 8/7/25, 8:54 PM ASE (Entry level technician prep) - Electrical A6
During an output test Answer A is correct! A shorted diode in a gneerator will
using the full-field method, typically cause the amperage output to be about
a 100-ampere alternator one-third less than normal.
with an integral regulator
produces 60 amperes.
The cause of the low
alternator output could
be:
A) a shortened diode in the
alternator
B) a broken brush lead
wire in the
alternator.
C) an open circuit in the voltage
regulator.
a defective alternator
D)
capacitor.
The charging system voltage Answer D is correct! Obviously 16.2 volts from the
on a vehicle is charging station is too much for a 12-volt battery.
16.2V. This condition may
Answer A is correct. B is also correct - the high voltage
cause all the following
could cause damage to electronic components. With
problems EXCEPT:
an overcharged battery, gassing does
increase, so C is also correct.
A) an overcharged battery.
B) burned-out electrical
components.
C)electrolyte gassing in
the battery.
D)reduced headlight brilliance
/ 3/27
