➢ GCAP INDUSTRIAL AMMONIA REFRIGERATION TRAINING 2024-2025
EXAM |ACTUAL EXAM
Class D fire extinguisher <<<100%CorreCtanswers>>Fire extinguisher used
on burning or combustible metals
EPCRA <<<100%CorreCtanswers>>Emergency Planning and Community
Right-to-Know Act
USEPA <<<100%CorreCtanswers>>United States Environmental Protection
Agency
CFR <<<100%CorreCtanswers>>Code of Federal Regulations
PSM <<<100%CorreCtanswers>>Process Safety Management (OSHA)
RMP <<<100%CorreCtanswers>>Risk management plan (EPA)
PHA (under PSM program) <<<100%CorreCtanswers>>process hazard
analysis
Arc Flash <<<100%CorreCtanswers>>Phenomenon where a flash over of
electrical current leaves its intended path and travels through the air from one
conductor to another, or to ground.
, Screw Compressor <<<100%CorreCtanswers>>A compressor that uses
_________-type components to compress refrigerant. Offering continuous
compression of vapor as it passes through meshed lobes. These are normally
used in large systems.
Rotary vane compressor <<<100%CorreCtanswers>>A compressor with an
off-center rotor which rotates within a cylinder sliding blades against cylinder
walls compressing vapor.
Condenser <<<100%CorreCtanswers>>any device for reducing gases or
vapors to liquid or solid form
condenser types <<<100%CorreCtanswers>>Water cooled, air cooled, or
evaporative
wet bulb <<<100%CorreCtanswers>>The temperature after evaporation
occurs with wet wick over thermometer. lowest condensing temperature
attainable in an evaporative condenser.
Accumulator <<<100%CorreCtanswers>>A closed vessel in the low side of
the system used to separate vapor and liquid refrigerant. also known as surge
drum, knock out drum, slop pot, suction trap or suction line _______________.
EXAM |ACTUAL EXAM
Class D fire extinguisher <<<100%CorreCtanswers>>Fire extinguisher used
on burning or combustible metals
EPCRA <<<100%CorreCtanswers>>Emergency Planning and Community
Right-to-Know Act
USEPA <<<100%CorreCtanswers>>United States Environmental Protection
Agency
CFR <<<100%CorreCtanswers>>Code of Federal Regulations
PSM <<<100%CorreCtanswers>>Process Safety Management (OSHA)
RMP <<<100%CorreCtanswers>>Risk management plan (EPA)
PHA (under PSM program) <<<100%CorreCtanswers>>process hazard
analysis
Arc Flash <<<100%CorreCtanswers>>Phenomenon where a flash over of
electrical current leaves its intended path and travels through the air from one
conductor to another, or to ground.
, Screw Compressor <<<100%CorreCtanswers>>A compressor that uses
_________-type components to compress refrigerant. Offering continuous
compression of vapor as it passes through meshed lobes. These are normally
used in large systems.
Rotary vane compressor <<<100%CorreCtanswers>>A compressor with an
off-center rotor which rotates within a cylinder sliding blades against cylinder
walls compressing vapor.
Condenser <<<100%CorreCtanswers>>any device for reducing gases or
vapors to liquid or solid form
condenser types <<<100%CorreCtanswers>>Water cooled, air cooled, or
evaporative
wet bulb <<<100%CorreCtanswers>>The temperature after evaporation
occurs with wet wick over thermometer. lowest condensing temperature
attainable in an evaporative condenser.
Accumulator <<<100%CorreCtanswers>>A closed vessel in the low side of
the system used to separate vapor and liquid refrigerant. also known as surge
drum, knock out drum, slop pot, suction trap or suction line _______________.
