Michigan State Brakes Certification Exam |
Updated Questions and Correct Answers |
Graded A+ | Latest Version
The front brakes of a car equipped with disc brakes in the front and drum brakes
in the rear, grab quickly as light pressure is applied to the brake pedal, which of
the following could be the cause of the problem? ---------CORRECT ANSWER---------
--------Defective metering valve
The brake warning light on the dash stays on all the time, which of the following
could be the cause of the problem? ---------CORRECT ANSWER-----------------A
problem in the hydraulic circuit
Which of the following would be the LEAST likely cause for an intermittent
problem in an ABS system? ---------CORRECT ANSWER-----------------Open wheel
sensor circuit
The brake lights on a car do not light when the brake pedal is depressed, which of
the following is the LEAST likely cause of the problem? ---------CORRECT ANSWER--
---------------A burned out bulb.
, Which of the following incorrect service procedures could cause brake pedal
pulsation? ---------CORRECT ANSWER-----------------incorrect run-out on the car
brake lathe
What type of rotor surface provides the best braking with new pads? ---------
CORRECT ANSWER-----------------A smooth, flat surface
Which of the following is a quick way to isolated a defective master cylinder?
There are no external leaks in the system. ---------CORRECT ANSWER-----------------
pump up the brake pedal, then hold it firm. if the pedal slowly drops to the floor,
the master cylinder may be defective.
A common cause of pedal pulsation during brake application is: ---------CORRECT
ANSWER-----------------NOT caused by improperly torqued wheels, damaged
backing plates, or lubricated shims
The car is at reset. When you slowly apply the brake pedal you hear a squeaking
noise at the rear of the vehicle. what could cause this noise? ---------CORRECT
ANSWER-----------------dry backing plate contact surfaces
While test driving a car, the mechanic finds that the right front brake "grabs". The
most likely cause of this problem is: ---------CORRECT ANSWER-----------------brake
fluid or grease on the brake linings
Updated Questions and Correct Answers |
Graded A+ | Latest Version
The front brakes of a car equipped with disc brakes in the front and drum brakes
in the rear, grab quickly as light pressure is applied to the brake pedal, which of
the following could be the cause of the problem? ---------CORRECT ANSWER---------
--------Defective metering valve
The brake warning light on the dash stays on all the time, which of the following
could be the cause of the problem? ---------CORRECT ANSWER-----------------A
problem in the hydraulic circuit
Which of the following would be the LEAST likely cause for an intermittent
problem in an ABS system? ---------CORRECT ANSWER-----------------Open wheel
sensor circuit
The brake lights on a car do not light when the brake pedal is depressed, which of
the following is the LEAST likely cause of the problem? ---------CORRECT ANSWER--
---------------A burned out bulb.
, Which of the following incorrect service procedures could cause brake pedal
pulsation? ---------CORRECT ANSWER-----------------incorrect run-out on the car
brake lathe
What type of rotor surface provides the best braking with new pads? ---------
CORRECT ANSWER-----------------A smooth, flat surface
Which of the following is a quick way to isolated a defective master cylinder?
There are no external leaks in the system. ---------CORRECT ANSWER-----------------
pump up the brake pedal, then hold it firm. if the pedal slowly drops to the floor,
the master cylinder may be defective.
A common cause of pedal pulsation during brake application is: ---------CORRECT
ANSWER-----------------NOT caused by improperly torqued wheels, damaged
backing plates, or lubricated shims
The car is at reset. When you slowly apply the brake pedal you hear a squeaking
noise at the rear of the vehicle. what could cause this noise? ---------CORRECT
ANSWER-----------------dry backing plate contact surfaces
While test driving a car, the mechanic finds that the right front brake "grabs". The
most likely cause of this problem is: ---------CORRECT ANSWER-----------------brake
fluid or grease on the brake linings
