ABC Wastewater test 3 – General
Turbidity in wastewater is caused by
A. color
B. dissolved calcium
C. hardness
D. finely divided suspended material - CORRECT ANSWER-D. finely divided
suspended material
The gas most commonly associated with septic wastewater is
A. carbon dioxide
B. carbon monoxide
C. hydrogen sulfide
D. methane - CORRECT ANSWER-C. hydrogen sulfide
How many cubic meters per second in 10 MGD?
A. 0.44
B. 1.44
C. 4.73
D. 24.62 - CORRECT ANSWER-A. 0.44
Mechanical ventilation of a lift station is required to
A. lower temperatures to reduce proportion of hydrogen sulfide
B. reduce chlorine demand
C. reduce corrosion
D. increase DO in raw wastewater - CORRECT ANSWER-C. reduce corrosion
A wet well probe is usually used for ________ determination(s) of level.
A. approximate
B. dual point
C. continuous
D. single point - CORRECT ANSWER-D. single point
A pump is delivering at less than the expected rate of discharge. Which of the causes
listed below is incorrect?
A. speed of motor too low
B. pump not primed
,C. impeller clogged
D. discharge head too low - CORRECT ANSWER-D. discharge head too low
Metal pipes often fail because of
A. back siphonage
B. browning movement
C. galvanic action
D. reverse osmosis - CORRECT ANSWER-C. galvanic action
When a fire hydrant is operated, it should be
A. just opened enough to have a flow
B. opened fully
C. opened halfway
D. regulated to flow required - CORRECT ANSWER-B. opened fully
If the pump bearings on horizontal centrifugal pumps are over lubricated, the most
important effect is that the extra lubricant
A. will result in smoother and more efficient operation of the pump
B. will not make any difference in the operation of the pump
C. will be wasted
D. shaft or shaft sleeve will be damaged - CORRECT ANSWER-D. shaft or shaft sleeve
will be damaged
If packing is not maintained properly,
A. cavitation damage will result
B. impeller will corrode
C. loss of suction due to air being allowed to enter pump
D. shaft or shaft sleeve will be damaged - CORRECT ANSWER-C. loss of suction due
to air being allowed to enter pump
Air flow through a trickling filter when the influent is warmer than the air temperature is
A. upward through the filter
B. downward through the filter
C. inadequate and may require forced air ventilation
D. improved by decreasing the recirculation - CORRECT ANSWER-A. upward through
the filter
An active sludge in the aeration tank with an abundant available food supply will have a
relatively
A. high oxygen uptake and fast settling rate
B. high oxygen uptake and slow settling rate
C. low oxygen uptake and fast settling rate
D. low oxygen uptake and slow settling rate - CORRECT ANSWER-B. high oxygen
uptake and slow settling rate
The reaction of chlorine and ammonia produces a compound which is called
,A. ammonium chloride
B. chloral hydrate
C. chloramine
D. hydrazine - CORRECT ANSWER-C. chloramine
A malfunctioning gas chlorination system has normal gas pressure, no feed rate
indicated on rotometer, and no injector vacuum. What is the most likely cause of the
problem?
A. air leak upstream of rotameter
B. gas line plugged
C. injector clogged
D. pressure reducing valve diaphragm ruptured - CORRECT ANSWER-C. injector
clogged
What is the impact of increased viscosity on the effectiveness of mixed media filters?
Mixed media filters are
A. affected only if temperature also changes
B. less effective
C. more effective
D. not affected - CORRECT ANSWER-B. less effective
The precipitate in coagulation with alum is aluminum
A. bicarbonate
B. carbonate
C. hydroxide
D. sulfate - CORRECT ANSWER-C. hydroxide
Given the following data, what is the most likely cause of the mechanically cleaned bar
screen problem?
DATA: Above normal water differential across bar screen
Drive motor shaft turning
Drive sprocket, chain, rake not moving
Less than normal flow on bar screen downstream side
Bar screen mode selector in automatic position
Normal seasonal flow (influent) coming into bar screen
Alarm systems operating normally
A. low influent (incoming) level
B. raw wastewater pumping units out of service
C. sheared pin or disengaged clutch
D. none of the above - CORRECT ANSWER-C. sheared pin or disengaged clutch
The least amount of chemical used to remove turbidity is known as the
A. coagulation range
B. combination dosage
C. efficiency range
D. dosage - CORRECT ANSWER-D. dosage
, The method of sludge handling resulting in a supernatant with the highest BOD is
A. aerobic digestion
B. anaerobic digestion
C. centrifugation
D. vacuum filtration - CORRECT ANSWER-C. centrifugation
Sodium chloride is used in the low pressure wet oxidation unit's
A. water softener
B. steam generator
C. deaerator
D. chemical feed tank - CORRECT ANSWER-A. water softener
The quantity of volatile solids in the content of the sludge is an indirect measure of the
A. amount of the sample that will evaporate upon standing
B. "food" available for the bacteria in the digester
C. number of bacteria in the digester
D. primary effluent suspended solids - CORRECT ANSWER-B. "food" available for the
bacteria in the digester
Which solids cannot be removed by vacuum filtration?
A. dissolved solids
B. setteable solids
C. suspended solids
D. total solids - CORRECT ANSWER-A. dissolved solids
Belt filter press are operated as a __________ process.
A. batch
B. continuous
C. either one, depending on circumstances - CORRECT ANSWER-B. continuous
Given the data below, what is the most likely cause of the activated sludge diffused
aeration system problem?
DATA: Blower air rate output high
Organic load normal
Hydraulic load normal
Borderline low dissolved oxygen
Low turbulence throughout aeration tank
A. aeration system piping leaking
B. excessive air bubble shearing by diffusers
C. return sludge rate too high
D. underaeration because of low blower speed - CORRECT ANSWER-A. aeration
system piping leaking
Given the data below, what is the most likely cause of the extended aeration facility
problem?
Turbidity in wastewater is caused by
A. color
B. dissolved calcium
C. hardness
D. finely divided suspended material - CORRECT ANSWER-D. finely divided
suspended material
The gas most commonly associated with septic wastewater is
A. carbon dioxide
B. carbon monoxide
C. hydrogen sulfide
D. methane - CORRECT ANSWER-C. hydrogen sulfide
How many cubic meters per second in 10 MGD?
A. 0.44
B. 1.44
C. 4.73
D. 24.62 - CORRECT ANSWER-A. 0.44
Mechanical ventilation of a lift station is required to
A. lower temperatures to reduce proportion of hydrogen sulfide
B. reduce chlorine demand
C. reduce corrosion
D. increase DO in raw wastewater - CORRECT ANSWER-C. reduce corrosion
A wet well probe is usually used for ________ determination(s) of level.
A. approximate
B. dual point
C. continuous
D. single point - CORRECT ANSWER-D. single point
A pump is delivering at less than the expected rate of discharge. Which of the causes
listed below is incorrect?
A. speed of motor too low
B. pump not primed
,C. impeller clogged
D. discharge head too low - CORRECT ANSWER-D. discharge head too low
Metal pipes often fail because of
A. back siphonage
B. browning movement
C. galvanic action
D. reverse osmosis - CORRECT ANSWER-C. galvanic action
When a fire hydrant is operated, it should be
A. just opened enough to have a flow
B. opened fully
C. opened halfway
D. regulated to flow required - CORRECT ANSWER-B. opened fully
If the pump bearings on horizontal centrifugal pumps are over lubricated, the most
important effect is that the extra lubricant
A. will result in smoother and more efficient operation of the pump
B. will not make any difference in the operation of the pump
C. will be wasted
D. shaft or shaft sleeve will be damaged - CORRECT ANSWER-D. shaft or shaft sleeve
will be damaged
If packing is not maintained properly,
A. cavitation damage will result
B. impeller will corrode
C. loss of suction due to air being allowed to enter pump
D. shaft or shaft sleeve will be damaged - CORRECT ANSWER-C. loss of suction due
to air being allowed to enter pump
Air flow through a trickling filter when the influent is warmer than the air temperature is
A. upward through the filter
B. downward through the filter
C. inadequate and may require forced air ventilation
D. improved by decreasing the recirculation - CORRECT ANSWER-A. upward through
the filter
An active sludge in the aeration tank with an abundant available food supply will have a
relatively
A. high oxygen uptake and fast settling rate
B. high oxygen uptake and slow settling rate
C. low oxygen uptake and fast settling rate
D. low oxygen uptake and slow settling rate - CORRECT ANSWER-B. high oxygen
uptake and slow settling rate
The reaction of chlorine and ammonia produces a compound which is called
,A. ammonium chloride
B. chloral hydrate
C. chloramine
D. hydrazine - CORRECT ANSWER-C. chloramine
A malfunctioning gas chlorination system has normal gas pressure, no feed rate
indicated on rotometer, and no injector vacuum. What is the most likely cause of the
problem?
A. air leak upstream of rotameter
B. gas line plugged
C. injector clogged
D. pressure reducing valve diaphragm ruptured - CORRECT ANSWER-C. injector
clogged
What is the impact of increased viscosity on the effectiveness of mixed media filters?
Mixed media filters are
A. affected only if temperature also changes
B. less effective
C. more effective
D. not affected - CORRECT ANSWER-B. less effective
The precipitate in coagulation with alum is aluminum
A. bicarbonate
B. carbonate
C. hydroxide
D. sulfate - CORRECT ANSWER-C. hydroxide
Given the following data, what is the most likely cause of the mechanically cleaned bar
screen problem?
DATA: Above normal water differential across bar screen
Drive motor shaft turning
Drive sprocket, chain, rake not moving
Less than normal flow on bar screen downstream side
Bar screen mode selector in automatic position
Normal seasonal flow (influent) coming into bar screen
Alarm systems operating normally
A. low influent (incoming) level
B. raw wastewater pumping units out of service
C. sheared pin or disengaged clutch
D. none of the above - CORRECT ANSWER-C. sheared pin or disengaged clutch
The least amount of chemical used to remove turbidity is known as the
A. coagulation range
B. combination dosage
C. efficiency range
D. dosage - CORRECT ANSWER-D. dosage
, The method of sludge handling resulting in a supernatant with the highest BOD is
A. aerobic digestion
B. anaerobic digestion
C. centrifugation
D. vacuum filtration - CORRECT ANSWER-C. centrifugation
Sodium chloride is used in the low pressure wet oxidation unit's
A. water softener
B. steam generator
C. deaerator
D. chemical feed tank - CORRECT ANSWER-A. water softener
The quantity of volatile solids in the content of the sludge is an indirect measure of the
A. amount of the sample that will evaporate upon standing
B. "food" available for the bacteria in the digester
C. number of bacteria in the digester
D. primary effluent suspended solids - CORRECT ANSWER-B. "food" available for the
bacteria in the digester
Which solids cannot be removed by vacuum filtration?
A. dissolved solids
B. setteable solids
C. suspended solids
D. total solids - CORRECT ANSWER-A. dissolved solids
Belt filter press are operated as a __________ process.
A. batch
B. continuous
C. either one, depending on circumstances - CORRECT ANSWER-B. continuous
Given the data below, what is the most likely cause of the activated sludge diffused
aeration system problem?
DATA: Blower air rate output high
Organic load normal
Hydraulic load normal
Borderline low dissolved oxygen
Low turbulence throughout aeration tank
A. aeration system piping leaking
B. excessive air bubble shearing by diffusers
C. return sludge rate too high
D. underaeration because of low blower speed - CORRECT ANSWER-A. aeration
system piping leaking
Given the data below, what is the most likely cause of the extended aeration facility
problem?