Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 4 out of 84 pages
Exam (elaborations)

BC Owner Builder Exam Questions and Answers

Document preview thumbnail
Preview 4 out of 84 pages

BC Owner Builder Exam Questions and Answers

Content preview

BC Owner Builder Exam


If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of entry and exit must be
located:



a) within 8 m (25 ft) of the workers and the excavation must be

safely supported or sloped to the entry and exit location.

b) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to the entry
and exit location.

c) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to the entry
and exit location.

d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to the entry
and exit location. - Answer-a



If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of entry and exit must be
located:




a) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to the entry
and exit location.

b) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to the entry
and exit location.

c) within 8 m (25 ft) of the workers and the excavation must be

safely supported or sloped to the entry and exit location.

d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to the entry
and exit location. - Answer-c

,What is the design and construction that prevents

water from ever entering?



a) Principle of driving rain deterrent

b) Principle of driving rain deflection

c) Principle of rainwater deterrent

d) Principle of rainwater deflection - Answer-d



The higher grit number is equivalent to:

a) a finer abrasive, which creates smoother surface

finishes.

b) a finer abrasive, which creates a rougher surface finish.

c) a rougher abrasive, which creates smoother surface

finishes.

d) a rougher abrasive, which creates a rougher surface finish. - Answer-a



The vertical height of any flight of stairs shall not exceed

a) 4.5 m or 15 ft

b) 3.7 m or 12 ft

c) 3.5 m or 11.5 ft

d) 2.8 m or 9 ft - Answer-b



Extend the ladder at least ____ above the landing platform or the point of support.

,a) 1.5 m (5 ft)

b) 2 m (6.3 ft)

c) 1 m (3 ft)

d) .5 m (1.5 ft) - Answer-c



for every four feet in height, the base of the ladder should be moved ___ foot out from the wall or
structure. - Answer-1



Use a ___ ratio for setting ladders (approximately 75 degrees) to determine how far out the base of the
ladder should be moved in relation to the height of the ladder against the wall. - Answer-4:1



To be effective, mechanical ventilation systems must be able to

a) Distribute ventilation air to most rooms of the house and exhaust air from kitchens, bathrooms, and
laundry rooms.

b) Exhaust air from kitchens, bathrooms, and laundry rooms.

c) Distribute ventilation air to bedrooms and common spaces

d) Distribute ventilation air to most bedrooms and exhaust air from bathrooms and laundry rooms. -
Answer-a



____________ performs routine remote and physical inspections on gas work and gas equipment in
commercial, industrial, and residential premises.

a) Worksafe BC

b) Regional District Building Inspectors

c) Technical Safety BC - Answer-c



If your property is in Technical Safety BC jurisdiction, homeowners can apply for an electrical
homeowner permit.

, T or F? - Answer-T



Shingles should overlap the valley lining by at least ____

a) 12 inches.

b) 6 inches.

c) 2 inches.

d) 5 inches. - Answer-b



The moisture trapped within the membranes will form bubbles on the surface of the flat roof. As
moisture builds up on the roof, the bubbles will eventually grow and pop, forming a blister. The
moisture is formed by ___________

a) excessive heat and poor attic ventilation.

b) excessive cold and poor attic ventilation.

c) excessive heat and excessive attic ventilation.

d) excessive cold and excessive attic ventilation. - Answer-a



If any condensation forms on the inside of your skylight, the weep holes allow the water to drain out of
your home. The condensation can end up dripping into your home instead if ____

a) too many holes are present.

b) these holes are not properly caulked.

c) these holes are blocked by debris.

d) the holes are installed on the downward slope - Answer-c



The weep holes in skylights allow the _______

a) air exchange

b) water to drain out of your home

c) condensation to get trapped

Document information

Uploaded on
July 9, 2025
Number of pages
84
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers
$35.27

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
Zanaya
4.5
(12)
Sold
77
Followers
29
Items
10176
Last sold
1 day ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions