Millwright Level 2 - Bearings
FINAL EXAM 2025/2026 BANK
NEWEST ACTUAL EXAM 2
VERSIONS (VERSION A AND B)
WITH COMPLETE QUESTIONS
AND CORRECT VERIFIED
ANSWERS (
Save
Terms in this set (67)
What are the Base, Base bolt slots, cap and cap
principle parts bolt holes.
of a friction
bearing
housing?
,What are Cast Iron, Cast Steel, Fabricated
friction bearing Steel.
housings made Choice depends on the Load, The
from adn what Rotational Speed, the Direction of
factors Pull and the Support Design
influence the
choice of
housing?
How are friction In a fraction of their nominal size.
bearing
dimensions
expressed?
Do all new If they are from the same
bearings of the manufacturer.
same shaft size
have the same
base-to-eye
measurement?
What factors Load, Rotational Speed, Direction
influence the of the Pull and support Design
choice of
bearings?
, a) Where Speed and Load are low.
What are the
Where load is applied on the top
applications for
part of the bearing.
the following
b) Where load is applied on the
bearings?
bottom portion of the bearing.
a)Solid
Different bolt numbers for loads.
Bearings
c)When load is applied parallel to,
b)Split bearings
or at a slight angle to, the
c)Angle
horizontal. Or when the bearing is
bearings
mounted on the vertical support
d)Integrated
d)Where the bearings are an
Bearings
integral part of the machine.
How does Position of the top half may affect
friction bearing the bearing tolerances and load
joint design positions.
affect its
integrity?
What qualities Softer than the shaft material, low
should a good coefficient of friction, wear-
bearing resistant, a good heat conductor
material have? and remain relatively stable with
(5 points) heat changes, readily available.
FINAL EXAM 2025/2026 BANK
NEWEST ACTUAL EXAM 2
VERSIONS (VERSION A AND B)
WITH COMPLETE QUESTIONS
AND CORRECT VERIFIED
ANSWERS (
Save
Terms in this set (67)
What are the Base, Base bolt slots, cap and cap
principle parts bolt holes.
of a friction
bearing
housing?
,What are Cast Iron, Cast Steel, Fabricated
friction bearing Steel.
housings made Choice depends on the Load, The
from adn what Rotational Speed, the Direction of
factors Pull and the Support Design
influence the
choice of
housing?
How are friction In a fraction of their nominal size.
bearing
dimensions
expressed?
Do all new If they are from the same
bearings of the manufacturer.
same shaft size
have the same
base-to-eye
measurement?
What factors Load, Rotational Speed, Direction
influence the of the Pull and support Design
choice of
bearings?
, a) Where Speed and Load are low.
What are the
Where load is applied on the top
applications for
part of the bearing.
the following
b) Where load is applied on the
bearings?
bottom portion of the bearing.
a)Solid
Different bolt numbers for loads.
Bearings
c)When load is applied parallel to,
b)Split bearings
or at a slight angle to, the
c)Angle
horizontal. Or when the bearing is
bearings
mounted on the vertical support
d)Integrated
d)Where the bearings are an
Bearings
integral part of the machine.
How does Position of the top half may affect
friction bearing the bearing tolerances and load
joint design positions.
affect its
integrity?
What qualities Softer than the shaft material, low
should a good coefficient of friction, wear-
bearing resistant, a good heat conductor
material have? and remain relatively stable with
(5 points) heat changes, readily available.
