2026\NEWEST VERSION WITH COMPLETE
QUESTIONS AND ACCURATE DETAILED ANSWERS
\VERIFIED ANSWERS ALREADY GRADED A+
solve: +1,056,312
-863 x -1224
Calculate the resistance in 14.4 Ohms
a circuit if the voltage is 24
VDC and 40 watts of
power are consumed.
What will happen to the The current will double
current in a circuit of
constant voltage if the
resistance is halved?
How should ohmmeters Connected in parallel across the load with one lead
be used to take of the load to be measured disconnected.
measurements in a circuit?
How should voltmeters be Connected in parallel across the load to be measured
used to take disconnected
measurements in a circuit?
What will happen to the The current will be halved
current of a constant
voltage if the resistance is
doubled?
,Calculate the voltage in a 19.575
circuit with 87 ohms of
resistance and .225
amperes of current
flowing in it.
,If the current is 120mA and 29.4 Watts
the voltage is 245 VDC,
what is the amount of
power consumed by this
circuit?
If a circuit is rated to use 21.74 amps
1478 Watts and the source
voltage is 68 volts, what is
the resistance in the
circuit?
How should ammeters be connected in series with the circuit
used to take
measurements in a circuit?
What does the Double Pole- Double Throw- Normal Open Switch
designation DPDTNO
switch represent?
Switches are generally Voltage, Current
rated by the maximum ____
across the contacts when
the switch is open and the
maximum _ through the
switch when it is closed.
What type of resistor is Wire Wound Adjustable Resistor
often found in door
operators where it can be
used to control the
voltage available to the
motor fields?
What is the maximum 3760 ohms
amount of resistance that
would be found on a 4.7K
ohm resistor with 20%
tolerance?
, All electrical tools should regularly
be checked...
You are putting up a 144 feet
stringer of lights in a hoist
way with lights spaced at
6 foot intervals. If using
100 watt light bulbs, how
many feet of the houstway
can you cover before
tripping the breaker on a
20A circuit?
The __ is the same across voltage
all branches of a parallel
circuit.
You are taking a night call 90Ohm, 75Ohm, and 50Ohm wired in series
and your troubleshooting
leads you to find a burnt
out resistor. The original
resistor was 215Ohms. You
do not have a 215Ohm
resistor on site. Which
combination of resistors
could you use to get the
car running again?
The ease with which Permeability
magnetic lines of force
distrubute themselves
throughout a material is
known as ____
The point at which a given Saturation
piece of material contains
all the lines of force it can
hold is called ____.