OSHA 10-Hour Final Exam (3 Latest Versions) includes accurate and verified questions covering workplace safety fundamentals, hazard recognition, personal protective equipment (PPE), fire prevention, fall protection, electrical safety, and workers

1


OSHA 10-Hour Final Exam (3 Latest Versions) includes
accurate and verified questions covering workplace safety
fundamentals, hazard recognition, personal protective
equipment (PPE), fire prevention, fall protection, electrical
safety, and workers' rights under OSHA regulations.
Designed for general industry and construction workers
completing the OSHA 10 certification course.


VERSION 1


What are two US government agencies that are good resources
for safety and health information? - ANSWER-OSHA and
NIOSH


OSHA requires fall protection when working near the edge of a
trench or excavation that is _________ or more in depth. -
ANSWER-6 feet


3. Every supported scaffold and its components must support,
without failure, its own weight and at least _______ the intended
load. - ANSWER-4 times

,2


4. During an OSHA inspection: - ANSWER-You have the right
to talk to the inspector privately


5. The OSHA standards for Construction and General Industry
are found in: - ANSWER-Parts 1926 and 1910


6. When the employer receives an OSHA citation, it must be: -
ANSWER-Posted for 3 days or until the violation is fixed


7. What does OSHA require employers to post for 3 days? -
ANSWER-OSHA citations and abatement verification notices


8. What section of the OSH Act does the Whistleblower
Program reference? - ANSWER-Section 11(c)


9. OSHA requires fall protection at different heights for
construction and general industry however, regardless of the fall
distance, which of the following is most - ANSWER-A. Fall
protection must be provided when working over dangerous
equipment
B. Fall protection must be provided when working over
dangerous machinery
C. Both A and B are correct

,3


D. None of the above


10. Employees must not work on scaffold surfaces until: -
ANSWER-It is determined to have strength and structural
integrity to support intended loads


11. From your choices below, what would you consider to be a
"major" fall hazard in construction? - ANSWER-A. Roof edges
and floor openings
B. Steel erection
C. Improper scaffold construction
D. Unsafe use of portable ladders
E. All the above


12. Climbing on the cross braces of scaffolds is allowed: -
ANSWER-Never


13. If there are defects found during the inspection of personal
fall protection equipment, or if the equipment has been used in
an arrest, it must be: - ANSWER-Removed immediately from
service

, 4


14. More than 33% of fatalities in construction are from a
combination of falls from: - ANSWER-Roofs


15. Examples of fall hazards that have resulted in deaths on the
jobsite include: - ANSWER-A. Falls to the ground or lower
levels
B. Falls through existing floor or roof openings C. Falls through
the floor or roof surface
D. Falls on the same level
E. All the above


16. How can YOU prevent a fall from a ladder? - ANSWER-A.
Choose the right ladder for the job
B. Tie the top and bottom of the ladder to fixed points when
necessary
C. Don't carry tools or other materials in-hand while climbing
the ladder
D. All the above


17. Three major components of a Personal Fall Arrest System
(PFAS) include; anchor and the anchorage connector; full body
harness; and: - ANSWER-Connecting device (lanyard with
shock absorber/retractable lifeline, snap hooks)