Traffic Signal Technician Level
1 Comprehensive Questions
(Frequently Most Tested) and
Verified Answers
What is the primary function of the IMAS? - Answer: Safety Education
IMSA Stands for - Answer: International Municipal Signal Association
Which of the following is NOT an IMSA certification? - Answer: Traffic Signal Level III Bridge Technician
Which of the following are potential safety hazards? - Answer: overhead and underground power, gas,
aerial lift equipment. Tra
What are the sections of a ramp mete signal - Answer: Circular red, circular green
PPE stands for - Answer: Personal Protective Equipment
A work zone supervisor is responsible for which of the following tasks: - Answer: Ensure advance
warning devices have not been removed or relocated.
Which of the following is NOT a sentence type in the MUTCD?
Standards; requirement that have to be followed.
Guidance; recommendations that are to be followed unless there I good reason not to.
Objectives; reasons behind the standards and guidance.
Support; additional information to clarify the standards and guidance. - Answer: Objectives; reasons
behind the standards and guidance
, Which of the following is an example configuration fo an Emergency - Vehicle Traffic Control Signals? -
Answer: Thee section traffic signal with circular red, circular yellow, and smaller circular yellow
indications.
The following phases are typically assigned to the major-street through movements: - Answer: 2 and 6
There green interval is made up of which three components? - Answer: Minimum green, passage time,
maximum green
What are the three typical types of recall features of a traffic signal controller? - Answer: Minimum,
Maximum, Pedestrian
In a coordination plan, what is the number of seconds given to each phase at the intersection? - Answer:
split
which of the following traffic signal coordination methods is typically the least expensive? - Answer:
Time-Based Coordination
Which of the following is a definition for cycle length? - Answer: The elapsed time between the start of a
specific display until that display comes up again.
Which of the following is a characteristic of sequential phases? - Answer: they cannot occur at the same
time.
Which of th following is a definition for initial green time - Answer: Minimum time that that the green
indication myst be displayed
The only point in the cycle of a coordinated traffic signal controller where the major street phase is
allowed to end is called - Answer: Yield point
Which of ht following is NOT a common mode of operation for timing plans in a signal system? - Answer:
Traffic Related
1 Comprehensive Questions
(Frequently Most Tested) and
Verified Answers
What is the primary function of the IMAS? - Answer: Safety Education
IMSA Stands for - Answer: International Municipal Signal Association
Which of the following is NOT an IMSA certification? - Answer: Traffic Signal Level III Bridge Technician
Which of the following are potential safety hazards? - Answer: overhead and underground power, gas,
aerial lift equipment. Tra
What are the sections of a ramp mete signal - Answer: Circular red, circular green
PPE stands for - Answer: Personal Protective Equipment
A work zone supervisor is responsible for which of the following tasks: - Answer: Ensure advance
warning devices have not been removed or relocated.
Which of the following is NOT a sentence type in the MUTCD?
Standards; requirement that have to be followed.
Guidance; recommendations that are to be followed unless there I good reason not to.
Objectives; reasons behind the standards and guidance.
Support; additional information to clarify the standards and guidance. - Answer: Objectives; reasons
behind the standards and guidance
, Which of the following is an example configuration fo an Emergency - Vehicle Traffic Control Signals? -
Answer: Thee section traffic signal with circular red, circular yellow, and smaller circular yellow
indications.
The following phases are typically assigned to the major-street through movements: - Answer: 2 and 6
There green interval is made up of which three components? - Answer: Minimum green, passage time,
maximum green
What are the three typical types of recall features of a traffic signal controller? - Answer: Minimum,
Maximum, Pedestrian
In a coordination plan, what is the number of seconds given to each phase at the intersection? - Answer:
split
which of the following traffic signal coordination methods is typically the least expensive? - Answer:
Time-Based Coordination
Which of the following is a definition for cycle length? - Answer: The elapsed time between the start of a
specific display until that display comes up again.
Which of the following is a characteristic of sequential phases? - Answer: they cannot occur at the same
time.
Which of th following is a definition for initial green time - Answer: Minimum time that that the green
indication myst be displayed
The only point in the cycle of a coordinated traffic signal controller where the major street phase is
allowed to end is called - Answer: Yield point
Which of ht following is NOT a common mode of operation for timing plans in a signal system? - Answer:
Traffic Related