SHP final Questions with Detailed
Verified Answers for Accuracy
The firefighter may be installed next to a stand-alone battery smoke
detector
✓✓ True
When performing a full system test, you may bypass any open doors
or windows
✓✓ False
When programming an skey1,you must
✓✓ Always enable the emergency
When running power to the take345,polarity doesn't apply
✓✓ False
When programming the emergency key for the skey1,which
zone/sensor type is used.
✓✓ Audible alarm (7)
When installing a smkt3,you must use the included screws and
anchors
✓✓ True
When installing the firefighter, it is required to test the customers
existing smoke detectors
✓✓ True
pg. 1
, When installing a Dw21, where is the approved location for the
sensor
✓✓ Between 6"(15cm) and 2'(61cm) from floor
When installing a dw11 on a vinyl or metal frame, what should
primarily use to mount the sensor
✓✓ Provided double sided tape
Which of the following materials can you use to group multiple
ground terminals in a takeover.
✓✓ Beans & wire caps
Which of the following sensors are you not allowed to program using
a translator
✓✓ Smoke detector
When installing the take345, you must always test the new 12v
battery before using it.
✓✓ True
What is the output voltage of transformer used to power the sky
control
✓✓ 16.5
What is the minimum distance for placement of a co3 from the
corners of the wall
✓✓ 12"
The smkt3 has 2 function:smoke and heat detection
pg. 2
Verified Answers for Accuracy
The firefighter may be installed next to a stand-alone battery smoke
detector
✓✓ True
When performing a full system test, you may bypass any open doors
or windows
✓✓ False
When programming an skey1,you must
✓✓ Always enable the emergency
When running power to the take345,polarity doesn't apply
✓✓ False
When programming the emergency key for the skey1,which
zone/sensor type is used.
✓✓ Audible alarm (7)
When installing a smkt3,you must use the included screws and
anchors
✓✓ True
When installing the firefighter, it is required to test the customers
existing smoke detectors
✓✓ True
pg. 1
, When installing a Dw21, where is the approved location for the
sensor
✓✓ Between 6"(15cm) and 2'(61cm) from floor
When installing a dw11 on a vinyl or metal frame, what should
primarily use to mount the sensor
✓✓ Provided double sided tape
Which of the following materials can you use to group multiple
ground terminals in a takeover.
✓✓ Beans & wire caps
Which of the following sensors are you not allowed to program using
a translator
✓✓ Smoke detector
When installing the take345, you must always test the new 12v
battery before using it.
✓✓ True
What is the output voltage of transformer used to power the sky
control
✓✓ 16.5
What is the minimum distance for placement of a co3 from the
corners of the wall
✓✓ 12"
The smkt3 has 2 function:smoke and heat detection
pg. 2
