Engineering Graphics Exam Questions With Correct Answers.

Engineering Graphics Exam Questions With
Correct Answers

Consider /the /detail /drawings /of /the /two /parts /of /an /assembly /shown /above. /An /analysis /of
/the /functionality /of /the /parts /has /been /performed, /and /it /has /been /determined /that /the


/most /important /requirement /is /that /Part /1 /mates /well /with /Part /2. /Based /on /this


/information, /what /would /be /the /best /geometric /controls /to /be /applied /in /the /boxes /with /a


/red /question /mark? /- /verified /answer(s)-✔✔Each /box /with /red /question /mark /should /have /a
/perpendicularity /control.




Consider /the /following /part /drawing. /The /perpendicularity /tolerance /of /the /protrusion /on /the
plate, /if /diameter /B /is /at /LMC, /is /diameter /__________ /units. /- /verified /answer(s)-✔✔0.3
/




Consider /the /following /part /drawing. /The /perpendicularity /tolerance /shown /is /diameter /0.1
units /if /datum /A /is /at /MMC /- /verified /answer(s)-✔✔False
/




Consider /the /following /part /drawing. /The /perpendicularity /tolerance /shown /is /diameter /0.1
units /if /diameter /B /is /at /MMC. /- /verified /answer(s)-✔✔True
/




The /radial /deviation /from /true /position /of /the /axis /of /a /pin /is /0.020 /in. /If /the /position
/tolerance /calls /for /a /diametral /tolerance /of /0.025 /in /@ /RFS, /is /the /actual /pin /located /within


position /tolerance? /Select /the /appropriate /answer /below. /- /verified /answer(s)-✔✔No
/




The /specification /for /position /for /the /three /holes /on /a /"Support /Plate" /are /as /shown /below.

From /the /above, /hole /# /1 /always /has /a /position /tolerance /of /0.006 /units /(diameterwise). /-
verified /answer(s)-✔✔False
/