NICET Level 2
Study online at https://quizlet.com/_gc8l9w
1. Where replacing residential sprinklers manufac- 5
tured prior to 2003 that are no longer available
from the manufacturer and are installed using a
design density less than 0.05 gpm/ft2, a residen-
tial sprinkler with an equivalent K-factor (+/- ______
percent) shall be permitted to be used provided the
currently listed coverage area for the replacement
sprinkler is not exceeded.
2. CONSIDER A STANDPIPE AND HOSE SYSTEM WITH Secured to the water supply
A HYDRAULIC DESIGN INFORMATION SIGN. WHEN control valves
INSPECTING THE INFORMATION SIGN, WHERE
SHOULD IT BE LOCATED FOR AUTOMATIC AND
SEMI AUTOMATIC SYSTEMS?
3. Dry barrel and wall hydrants shall be inspected Annually
______ and after each operation?
4. Which of the following would be considered non- B. A hose/hydrant house not
critical deficiency? (Select 3) fully equipped
A. A hose rack that only swings out of the cabinet C. A hose on standpipe that is
120 degrees not connected
B. A hose/hydrant house not fully equipped D. A hose connection on a
C. A hose on standpipe that is not connected pressure reducing valve with a
D. A hose connection on a pressure reducing valve missing cap
with a missing cap
5. When inspecting a diesel fire pump, the fuel tank Two thirds
shall be at least ______ full?
6. Consider a water storage tank with a low temper- Quarterly
ature alarm connected to a constantly attended
, NICET Level 2
Study online at https://quizlet.com/_gc8l9w
location. What is the inspection frequency for the
water temperature?
7. What is the visual inspection frequency of a room Quarterly
temperature supervisory signaling switch?
8. All pressure gauges used for hydrant testing Year
should be calibrated at least every _______ or more
frequently depending on use
9. While conducting a full flow trip test of a dry pipe NFPA 13 does not require wa-
system, the tester at the inspector's test valve ter delivery in 60 seconds for
notes the time when water flows steadily from the all systems
test connection. This time is noted for comparison
purposes for previous tests. Which of the following
is true regarding water delivery?
10. Each portable wooden ladder shall support at least 4
_____ times the maximum intended load?
11. A section of piping on a standpipe system has been 14
replaced. As a result, the system shall be hydrosta-
tically tested in conformance with NFPA ____?
12. When measuring the pitot pressure of a stream of one-half
practically uniform velocity, the orifice in the pitot
tube is held down stream approximately _____ the
diameter of the hydrant outlet or nozzle opening
and in the center of the stream
13. Which of the following conditions does not require C. Matriculation
sprinkler replacement?
A. loading
, NICET Level 2
Study online at https://quizlet.com/_gc8l9w
B. loss of fluid in the glass bulb
C. Matriculation
D. All of these conditions require replacement
14. Consider testing a low air pressure switch on a dry 10
pipe system. The procedure is to operate the switch
and verify receipt of the signal is obtained where
the required pressure is increased or decreased
a maximum _____ PSI from the required pressure
level?
15. The reading of a pressure gauge at the discharge of Total Discharge Head
the pump converted to feet of liquid, and referred
to datum, plus the velocity head at the point of
gauge attachment is defined as ______?
16. During an inspection, you notice in rack sprinklers D. no action is required
with material storage within 18 inches of the de-
flector, what action shall be taken?
A. the material shall be relocated more than 12
inches from the deflector
B. the material shall be relocated more than 18
inches from the deflector
C. The material shall be relocated more than 36
inches from the deflector
D. no action is required
17. A Class _____ standpipe system provides 2 1/2 inch I
hose connections to supply water for use by fire
department
18. Consider an electrically supervised control valve. 2
A distinctive signal shall indicate movement from
Study online at https://quizlet.com/_gc8l9w
1. Where replacing residential sprinklers manufac- 5
tured prior to 2003 that are no longer available
from the manufacturer and are installed using a
design density less than 0.05 gpm/ft2, a residen-
tial sprinkler with an equivalent K-factor (+/- ______
percent) shall be permitted to be used provided the
currently listed coverage area for the replacement
sprinkler is not exceeded.
2. CONSIDER A STANDPIPE AND HOSE SYSTEM WITH Secured to the water supply
A HYDRAULIC DESIGN INFORMATION SIGN. WHEN control valves
INSPECTING THE INFORMATION SIGN, WHERE
SHOULD IT BE LOCATED FOR AUTOMATIC AND
SEMI AUTOMATIC SYSTEMS?
3. Dry barrel and wall hydrants shall be inspected Annually
______ and after each operation?
4. Which of the following would be considered non- B. A hose/hydrant house not
critical deficiency? (Select 3) fully equipped
A. A hose rack that only swings out of the cabinet C. A hose on standpipe that is
120 degrees not connected
B. A hose/hydrant house not fully equipped D. A hose connection on a
C. A hose on standpipe that is not connected pressure reducing valve with a
D. A hose connection on a pressure reducing valve missing cap
with a missing cap
5. When inspecting a diesel fire pump, the fuel tank Two thirds
shall be at least ______ full?
6. Consider a water storage tank with a low temper- Quarterly
ature alarm connected to a constantly attended
, NICET Level 2
Study online at https://quizlet.com/_gc8l9w
location. What is the inspection frequency for the
water temperature?
7. What is the visual inspection frequency of a room Quarterly
temperature supervisory signaling switch?
8. All pressure gauges used for hydrant testing Year
should be calibrated at least every _______ or more
frequently depending on use
9. While conducting a full flow trip test of a dry pipe NFPA 13 does not require wa-
system, the tester at the inspector's test valve ter delivery in 60 seconds for
notes the time when water flows steadily from the all systems
test connection. This time is noted for comparison
purposes for previous tests. Which of the following
is true regarding water delivery?
10. Each portable wooden ladder shall support at least 4
_____ times the maximum intended load?
11. A section of piping on a standpipe system has been 14
replaced. As a result, the system shall be hydrosta-
tically tested in conformance with NFPA ____?
12. When measuring the pitot pressure of a stream of one-half
practically uniform velocity, the orifice in the pitot
tube is held down stream approximately _____ the
diameter of the hydrant outlet or nozzle opening
and in the center of the stream
13. Which of the following conditions does not require C. Matriculation
sprinkler replacement?
A. loading
, NICET Level 2
Study online at https://quizlet.com/_gc8l9w
B. loss of fluid in the glass bulb
C. Matriculation
D. All of these conditions require replacement
14. Consider testing a low air pressure switch on a dry 10
pipe system. The procedure is to operate the switch
and verify receipt of the signal is obtained where
the required pressure is increased or decreased
a maximum _____ PSI from the required pressure
level?
15. The reading of a pressure gauge at the discharge of Total Discharge Head
the pump converted to feet of liquid, and referred
to datum, plus the velocity head at the point of
gauge attachment is defined as ______?
16. During an inspection, you notice in rack sprinklers D. no action is required
with material storage within 18 inches of the de-
flector, what action shall be taken?
A. the material shall be relocated more than 12
inches from the deflector
B. the material shall be relocated more than 18
inches from the deflector
C. The material shall be relocated more than 36
inches from the deflector
D. no action is required
17. A Class _____ standpipe system provides 2 1/2 inch I
hose connections to supply water for use by fire
department
18. Consider an electrically supervised control valve. 2
A distinctive signal shall indicate movement from
