SENSE LEVEL 1 WELDING PROCESS CERTIFICATION TEST MODULE 9 WELDING INSPECTION AND TEST

SENSE LEVEL 1 WELDING PROCESS CERTIFICATION TEST
MODULE 9 WELDING INSPECTION AND TEST PRINCIPLESQ&A
which of the following is not a type of weld joint - CORRECT ANSWER✅✅✅fillet



the portion of the joint where the two pieces to be joined come closet together is called the - CORRECT
ANSWER✅✅✅joint root



a weld produced by filling an elongated hole in an overlapping member, fusing it to the member
beneath is called a - CORRECT ANSWER✅✅✅slot weld



a weld having a triangular cross section which is applied to a T-joint, corner joint or lap joint is called a -
CORRECT ANSWER✅✅✅fillet weld



a weld used to build up thin surfaces and to provide a layer of corrosion protection and/ or abrasion-
resistance is called - CORRECT ANSWER✅✅✅surfacing weld



the height of a weld above the metal in a groove weld is the - CORRECT ANSWER✅✅✅weld
reinforcement



a __________ fillet weld has the same leg and size dimensions - CORRECT ANSWER✅✅✅equal leg



a weld formed by progressing along the joint with a side-to-side motion is called - CORRECT
ANSWER✅✅✅weave bead



the base material next to the weld that is not melted, but that undergoes structural and metallurgical
changes is called - CORRECT ANSWER✅✅✅the heat affected zone



the problem occurring in weldments due to the non-uniform heating produced by welding is called -
CORRECT ANSWER✅✅✅distortion