1 promax - Stuvia US 2025/2026
SGE Chapter 2 Test Questions with Detailed Verified
Answers (100% Correct Answers) /Already Graded A+
T/F Pulling a wrench, rather than pushing, reduces the risk of knuckle and
hand injuries.
Ans: T
Torque specifications are often given in inch pounds, foot pounds, and
____________ parts.
Ans: critical
What do you use diagonal side-cutting pliers to cut?
Exampromax - Stuvia US
Ans: electrical wires
Approved By:
T/F Ball peen hammers have a flat face on one end, and a hemispherical
face on the other.
Ans: T
What type of file would be best for sharpening the teeth on a a chainsaw?
Ans: Tapered square file
When using a vise to hold a part that needs to be cut, where should you
position the area to be cut in order to prevent excessive vibration during the
cut?
Ans: close to the jaws
On a standard micrometer, each small mark on the sleeve represents
__________.
Ans: 0.025"
SGE Chapter 2 Test Questions with Detailed Verified
Answers (100% Correct Answers) /Already Graded A+
T/F Pulling a wrench, rather than pushing, reduces the risk of knuckle and
hand injuries.
Ans: T
Torque specifications are often given in inch pounds, foot pounds, and
____________ parts.
Ans: critical
What do you use diagonal side-cutting pliers to cut?
Exampromax - Stuvia US
Ans: electrical wires
Approved By:
T/F Ball peen hammers have a flat face on one end, and a hemispherical
face on the other.
Ans: T
What type of file would be best for sharpening the teeth on a a chainsaw?
Ans: Tapered square file
When using a vise to hold a part that needs to be cut, where should you
position the area to be cut in order to prevent excessive vibration during the
cut?
Ans: close to the jaws
On a standard micrometer, each small mark on the sleeve represents
__________.
Ans: 0.025"
