IRONWORKER NCCER QUESTIONS AND ANSWERS 100% GUARANTEED PASS!

IRONWORKER NCCER QUESTIONS AND ANSWERS 100% GUARANTEED PASS! THE ABILITY OF A STRUCTURAL STEEL COMPONENT TO RESIST PULLING FORCES IS KNOWN AS: - ANSWER -TENSILE STRENGHT WHAT TYPE OF DECKING HAS IMPRESSIONS FORMED ON ITS RIB? - ANSWER -COMPOSITE DECK THE GROUND FLOOR ELEVATION IS SHOWN AS +100.25. THE ROOF TOP ELEVATION IS SHOWN AS +130.50. WHAT IS THE DIFFERENCE IN ELEVATION? - ANSWER -30'3 IN WHAT DRAWING WOULD ONE FIND THE CORRECT BOLT SIZE FOR A BEAM BEING BOLTED? - ANSWER -DETAIL DRAWING WHAT SHOULD ALWAYS BE USED TO IGNITE A CUTTING TORCH? - ANSWER -STRIKER EQUILIZING THE WEIGHT OF THE LOAD AT VARIOUS LIFTING POINTS IS CALLED: - ANSWER -CONFIGURATION A COMBINATION SQUARE WITHOUT A PROTRACTOR HEAD IS USED TO LAYOUT: - ANSWER -45 DEGREE LINES PRIOR TO INSPECTION IT IS GOOD PRACTICE TO TEST ALL STUDS WITH WHAT METHOD? - ANSWER -PING TEST WHERE IS THE FULCRUM OR PIVOT POINT ON A FORKLIFT? - ANSWER -THE FRONT AXLE A DOCUMENT THAT OUTLINES WEIGHTS,CRANE CONFIGURATION AND RIGGING REQUIREMENTS FOR A LIFT IS CALLED AN: - ANSWER -LIFT PLAN WHERE CAN THE BOLTING METHODS REGARDING STRUCTURAL STEEL USUALLY BE FOUND ? - ANSWER -IN THE GENERAL NOTES OF THE STRUCTURAL DRAWINGS WHEN ESTABLISHING ELEVATIONS OF STRUCTURAL STEEL MEMBERS, THE REFERENCE POINT USED TO DETERMINE ALL OTHER ELEVATIONS IS CALLED? - ANSWER -THE BENCHMARK WHAT IS THE SURFACE AREA OF A RECTANGLE WITH THE DIMENSIONS OF 30'6" TALL AND 6 FEET WIDE? - ANSWER 183FT MEASUREMENTS FROM THE CENTER OF THE CRANES AXIS OF ROTATION TO THE CENTER OF THE LOAD LINE WITH THE LOAD APPLIED IS: - ANSWER -LOAD RADIUS WHICH OF THE FOLLOWING TOOLS WOULD BE USED TO PRY STEEL INTO PLACE? - ANSWER -SLEEVER BAR WHEN TRAVELING TO PICK UP A LOAD ALWAYS KEEP THE: - ANSWER -FORKS LOW WHAT TYPE OF DRAWING SHOWS THE PRECISE DIMENSIONS OF A SECTION OR PART OF THE LARGER PLAN? - ANSWER DETAIL WHAT IS THE PROPER WAT TO ATTACH TWO SLINGS TOGETHER? - ANSWER -USE A SHACKLE A FRICTION LIGHTER IS COMMONLY KNOWN AS A: - ANSWER -STRIKER HOW MANY PIECES OF CHECKERED PLATE CAN BE LIFTED WHEN USING PLATE GRABS? - ANSWER -NO MORE THAN ONE PLATE WHAT IS THE MAXIMUM ALLOWABLE DEVIATION FROM A PLUMB LINE FOR A SINGLE - COLUMN SHIPPING PIECE? - ANSWER -1/1500 THE PROCESS OF STACKING TIMBERS IN ALTERNATE TIERS TO SUPPORT A HEAVY WEIGHT IS CALLED: - ANSWER BLOCKING PLUMBING UP GUYS SHOULD BE INSTALLED TO PLUMB UP A STRUCTURE AFTER: - ANSWER -ALL STEEL IS ERECTED WHAT IS THE SURFACE AREA OF A TRIANGLE WITH A 12" BASE AND 10" HEIGHT? - ANSWER -60IN SQUARE A SKIDMORE TESTER IS A DEVICE THAT MEASURES A BOLTS: - ANSWER -YIELD PRESSURE