NCCER Electrical Level 1 Mod 1 Orientation
to the Electrical Trade Study
The NCCER electrical training program applies DOL standards and is a - Answer- four-year
program
Entry into an apprenticeship program is likely to require a(n) - Answer- GATB Form Test
The minimum standards for the safe installation of electrical systems can be found in - Answer-
the National Electrical Code (NEC)
OSHA standards for general industry are covered in - Answer- 29 CFR, Parts 1900-1910
The termination of devices and fixtures is completed during a construction phase known as -
Answer- trim-out
Which of the following is true with regard to commercial electrical work? - Answer- fire alarm
systems are commonly required.
In industrial facilities, the electrical systems are most likely maintained by - Answer- on-site
maintenance personnel
Employers of commercial electricians are generally electrical contractors who work as
subcontractors for - Answer- general contractors
Interior panels in residential wiring are typically installed during - Answer- rough-in
A residential wiring system typically uses - Answer- nonmetallic-sheathed cable
Commercial wiring is typically installed in - Answer- metal raceways
Which of the following would most likely require special knowledge of hazardous locations? -
Answer- Industrial wiring
Tract homes are typically wired by - Answer- residential electrician
Minimum standards for apprentice training programs are established by - Answer- the DOL
Which of the following is true with regard to your apprenticeship? - Answer- licensing requirements
vary from state to state
Which of the following is true with regard to tardiness and absenteeism? - Answer- if you must be
absent, call in early so that your employer can find a replacement
If you see a safety violation at your job site, you should - Answer- report it to your supervisor
The primary mission of OSHA is to - Answer- ensure that employers maintain a safe workplace
to the Electrical Trade Study
The NCCER electrical training program applies DOL standards and is a - Answer- four-year
program
Entry into an apprenticeship program is likely to require a(n) - Answer- GATB Form Test
The minimum standards for the safe installation of electrical systems can be found in - Answer-
the National Electrical Code (NEC)
OSHA standards for general industry are covered in - Answer- 29 CFR, Parts 1900-1910
The termination of devices and fixtures is completed during a construction phase known as -
Answer- trim-out
Which of the following is true with regard to commercial electrical work? - Answer- fire alarm
systems are commonly required.
In industrial facilities, the electrical systems are most likely maintained by - Answer- on-site
maintenance personnel
Employers of commercial electricians are generally electrical contractors who work as
subcontractors for - Answer- general contractors
Interior panels in residential wiring are typically installed during - Answer- rough-in
A residential wiring system typically uses - Answer- nonmetallic-sheathed cable
Commercial wiring is typically installed in - Answer- metal raceways
Which of the following would most likely require special knowledge of hazardous locations? -
Answer- Industrial wiring
Tract homes are typically wired by - Answer- residential electrician
Minimum standards for apprentice training programs are established by - Answer- the DOL
Which of the following is true with regard to your apprenticeship? - Answer- licensing requirements
vary from state to state
Which of the following is true with regard to tardiness and absenteeism? - Answer- if you must be
absent, call in early so that your employer can find a replacement
If you see a safety violation at your job site, you should - Answer- report it to your supervisor
The primary mission of OSHA is to - Answer- ensure that employers maintain a safe workplace
