24/25/26 Ust/ Icc-Vapour Recovery Ust Exam With Q&A Verified Answers 100% Guaranteed

24/25/26 UST/ ICC-Vapour Recovery UST EXAM WITH Q&A VERIFIED ANSWERS 100% GUARANTEED Which of the following is not considered "hanging hardware"? a. nozzle b. swivel c. whip hose d. shear valve d. shear valve Per Executive Order. VR-201-E, if the dispensing vacuum of the Healy VP-1000 pump is below __?__ inches of WC, the dispenser should be removed from service. A. 50 B. 60 C. 75 D. 100 B. 60 In a coaxial hose for a balance system, the product flows through the ____? A. the below B. the inner hose C. the outer hose D. both hoses B. the inner hose Per the Vapor Recovery Equipment Defects List (VRED), the ____ of any component required to be used by the system's EO. Is not considered a defect. A. absence B. proper installation C. disconnection D. improper installation B. proper installation The three elements in a fire triangle are ____? A. oxygen, fuel, & LEL B. fuel, fire, & carbon dioxide C. fuel, oxygen, & ignition source D. ignition source, carbon dioxide, & fuel C. fuel, oxygen, & ignition source According to PEI RP-300, a combustible gas indicator is used to? A. determine carbon dioxide levels B. monitor benzene, toluene, & ethyl benzene levels C. determine the (UEL) upper explosion limit of gasoline D. detect vapour leaks in the vapour recovery system D. detect vapour leaks in the vapour recovery system Per CP-201, liquid traps in the dispenser vapour piping are:? A. Not allowed B. Allowed only with an assist system C. Allowed if approved by CARB D. Allowed when hoses with liquid removal systems are used E. detect vapour leaks in the vapour recovery system A. Not allowed Which of the following is not an overfill device? A. ball-float B. spill-bucket C. tank overfill alarm D. drop-tube flapper valve B. spill-bucke t Piping should have a minimum and maximum slope of ____ inch. A. 1/16"-1/8" B. 1/8"-1/4" C. 1/8"-3/16" D. 1/4"-1/2" B. 1/8"-1/4" What is the appropriate way to clean up a small spill of gasoline? A. allow the product to evaporate from the area B. wash the spilt product from the area with water C Apply absorbent to the affected area and leave to soak up fuel D. apply absorbent to the affected area, then remove & dispose of absorbent by applicable requirements D. apply absorbent to the affected area, then remove & dispose of absorbent following applicable requirements Placing a bare copper wire from the __?__ to the __?__ with it's ends exposed is helpful with pipe run locating. A. tank monitor to emergency shut-off switch B. tank to turbine C. vapour recovery bucket to interstitial monitor D. dispenser pipe runs to the tank turbine D. dispenser pipe runs to the tank turbine One of the approved methods of overfill prevention is to have an overfill device that will automatically shut off fill into the tank when the tank is a maximum of __?__ % full. A. 80 B. 90 C. 95 D. 75 C. 95 In the PEI #300 manual, pressure decay, dynamic back pressure, and A/L testing satisfy who's testing requirements? A. CARB B. water resources C. environmental health D. fire department A. CARB When removing liquid from a sump or spill bucket and the liquid contains fuel, it must ____? A. be managed as hazardous waste B. pumped into a bucket to evaporate C. scooped or bailed onto the concrete pad to evaporate D. put into a sealed container, then put into the trash container A. be managed as hazardous waste Before working on any electrical circuits always de-energize and use?