ADDA Mechanical Drafter Certification Actual Exam Questions With
Reviewed 100% Correct Detailed Answers Guaranteed Pass!!
1. A gear that has 20 teeth has degrees between each 18
tooth.
2. The hatch for cast iron is usually equally-spaced lines 45
drawn at a degree angle.
3. The closest dimension line to the object view is drawn 3/8
inches away from the view.
4. Notes that pertain to the entire drawing are called general
notes.
5. An isometric drawing shows front and right sides an- 30
gled back at degrees to the horizontal.
6. A section in which the cutting plane line bends at an- aligned
gles less than 90 degrees is a(n) section.
7. Sketching requires only a(n) and a writing writing utensil
medium.
8. Sketching requires only a writing utensil and a(n) writing medium
.
9. The perimeter of a square measuring 4 inches per side 16
is inches.
10. and location are the two types of linear di- size
mensions.
11. Size and are the two types of linear dimen- location
sions.
12. There are bytes in 1 megabyte. 1,000,000
1/3
Reviewed 100% Correct Detailed Answers Guaranteed Pass!!
1. A gear that has 20 teeth has degrees between each 18
tooth.
2. The hatch for cast iron is usually equally-spaced lines 45
drawn at a degree angle.
3. The closest dimension line to the object view is drawn 3/8
inches away from the view.
4. Notes that pertain to the entire drawing are called general
notes.
5. An isometric drawing shows front and right sides an- 30
gled back at degrees to the horizontal.
6. A section in which the cutting plane line bends at an- aligned
gles less than 90 degrees is a(n) section.
7. Sketching requires only a(n) and a writing writing utensil
medium.
8. Sketching requires only a writing utensil and a(n) writing medium
.
9. The perimeter of a square measuring 4 inches per side 16
is inches.
10. and location are the two types of linear di- size
mensions.
11. Size and are the two types of linear dimen- location
sions.
12. There are bytes in 1 megabyte. 1,000,000
1/3
