J-STD-001E QUESTIONS AND ANSWERS
Hardware characteristics or conditions that do not conform to the requirements of this
specification are classified as ____________ - Answers :Hardware defects or hardware
process indicators.
The __________ always takes precedence over this standard, referenced standards
and drawings. - Answers :contract
When a clause in this document is referenced, - Answers :its subordinate clauses also
apply.
This drawing represents? - Answers :Wire overwrap.
During an audit an employee is found using tobacco products in the work area. this
would be? - Answers :D1D2D3
The IPC-T- 50 document provides _________ - Answers :terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - Answers :006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the
material or process involved is considered? - Answers :Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what
period of time? - Answers :2 years.
Component damage that exposes the component substrate or active element or affects
structural integrity is? - Answers :D1D2D3
Any violation of minimum electrical clearance as a result of conformance to defined
criteria is a ______ condition. - Answers :Defect
After cleaning, you observe particulate matter left on the assembly and correctly identify
the condition as _______ - Answers :D1D2D3
When an external flux is used in conjunction with flux cored solders, the fluxes shall be
________ - Answers :compatible.
A product classification where continued high performance of performance-on-demand
is critical describes a _______ product. - Answers :Class 3
A Class 1 Product includes product where ______ - Answers :the major requirement is
function of the completed assembly.
Hardware characteristics or conditions that do not conform to the requirements of this
specification are classified as ____________ - Answers :Hardware defects or hardware
process indicators.
The __________ always takes precedence over this standard, referenced standards
and drawings. - Answers :contract
When a clause in this document is referenced, - Answers :its subordinate clauses also
apply.
This drawing represents? - Answers :Wire overwrap.
During an audit an employee is found using tobacco products in the work area. this
would be? - Answers :D1D2D3
The IPC-T- 50 document provides _________ - Answers :terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - Answers :006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the
material or process involved is considered? - Answers :Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what
period of time? - Answers :2 years.
Component damage that exposes the component substrate or active element or affects
structural integrity is? - Answers :D1D2D3
Any violation of minimum electrical clearance as a result of conformance to defined
criteria is a ______ condition. - Answers :Defect
After cleaning, you observe particulate matter left on the assembly and correctly identify
the condition as _______ - Answers :D1D2D3
When an external flux is used in conjunction with flux cored solders, the fluxes shall be
________ - Answers :compatible.
A product classification where continued high performance of performance-on-demand
is critical describes a _______ product. - Answers :Class 3
A Class 1 Product includes product where ______ - Answers :the major requirement is
function of the completed assembly.
