SOLDERING PRACTICES MODULE 1 AND 2 TEST
Recertification of Certified IPC Specialists _____. - Answers :May be administered by
any currently certified Master IPC Trainer or Certified IPC Trainer
Which of the following IPC product classifications would include products where
continued performance and extended life is required, and for which uninterrupted
service is desired but not critical and typically the end-use environment would not cause
failures? - Answers :Class 2- Dedicated Service Electronic Products
All IPC certification programs for MIT, CIT, and CIS require recertification after what
period of time? - Answers :2 years
Illumination at the surface of workstations should be at least_____. - Answers :1000
lm/m²
All instructors, operators and all inspection personnel __________ be proficient in the
tasks to be performed. - Answers :Shall
A solder connection that exhibits poor wetting and that is characterized by a grayish
porous appearance defines? - Answers :Cold solder connection
A CIS candidate may challenge any of the workmanship skills training programs by
_____. - Answers :Completing the same requirements of those taking the classroom
course.
Any violation of minimum electrical clearance would be considered __________
condition for all three classes? - Answers :a Defect
Certified IPC Trainers are authorized to grant Certified IPC Specialist's a single
extension of certification up to _____days. - Answers :90
The magnification power inspection range for a soldered connection with a land width of
0.35mm is_____. - Answers :7.5X to 10X
Certification once attained belongs to the_________. - Answers :Individual who
completed the training
Adhesive material that is not properly cured is considered ________. - Answers
:D1D2D3
A clause of the J-STD-001G that is preceded by the symbol representing the
International Space Station (ISS) indicates ________ . - Answers :That there is a
difference between the base document and the space addendum
Recertification of Certified IPC Specialists _____. - Answers :May be administered by
any currently certified Master IPC Trainer or Certified IPC Trainer
Which of the following IPC product classifications would include products where
continued performance and extended life is required, and for which uninterrupted
service is desired but not critical and typically the end-use environment would not cause
failures? - Answers :Class 2- Dedicated Service Electronic Products
All IPC certification programs for MIT, CIT, and CIS require recertification after what
period of time? - Answers :2 years
Illumination at the surface of workstations should be at least_____. - Answers :1000
lm/m²
All instructors, operators and all inspection personnel __________ be proficient in the
tasks to be performed. - Answers :Shall
A solder connection that exhibits poor wetting and that is characterized by a grayish
porous appearance defines? - Answers :Cold solder connection
A CIS candidate may challenge any of the workmanship skills training programs by
_____. - Answers :Completing the same requirements of those taking the classroom
course.
Any violation of minimum electrical clearance would be considered __________
condition for all three classes? - Answers :a Defect
Certified IPC Trainers are authorized to grant Certified IPC Specialist's a single
extension of certification up to _____days. - Answers :90
The magnification power inspection range for a soldered connection with a land width of
0.35mm is_____. - Answers :7.5X to 10X
Certification once attained belongs to the_________. - Answers :Individual who
completed the training
Adhesive material that is not properly cured is considered ________. - Answers
:D1D2D3
A clause of the J-STD-001G that is preceded by the symbol representing the
International Space Station (ISS) indicates ________ . - Answers :That there is a
difference between the base document and the space addendum
