And Answers Rated A+
Bow - Correct Answer - Front of the vessel.
y y yy y y y y y
Stern - Correct Answer - Rear of the vessel.
y y yy y y y y y
Starboard - Correct Answer - Right side of the vessel.
y y yy y y y y y y
Port - Correct Answer - Left side of the vessel.
y y yy y y y y y y
Hull - Correct Answer - Body of the vessel.
y y yy y y y y y
Gunwale - Correct Answer - Upper edge of vessel's side.
y y yy y y y y y y
Cleat - Correct Answer - Metal fitting on which a rope can be fastened.
y y yy y y y y y y y y y y
Propeller - Correct Answer - Rotates and powers a boat forward or backward.
y y yy y y y y y y y y y
Beam - Correct Answer - Maximum width of a vessel.
y y yy y y y y y y
Freeboard - Correct Answer - Distance from water to lowest point of the boat where
y y yy y y y y y y y y y y y
water could come on board.
y y y y y
Draft - Correct Answer - Depth of the water needed to float a vessel.
y y yy y y y y y y y y y y
Keel - Correct Answer - Main centerline (backbone) of a vessel or the extension of hull
y y yy y y y y y y y y y y y y
that increases stability in the water.
y y y y y y
Hull - Correct Answer - Body of a vessel; basic structure or shell.
y y yy y y y y y y y y y
Personal watercraft - Correct Answer - A small vessel that uses an inboard jet drive as
y y y yy y y y y y y y y y y y
its primary source of propulsion, and is designed to be operated by a person or
y y y y y y y y y y y y y y y
persons sitting, standing, or kneeling on the vessel rather than inside the vessel.
y y y y y y y y y y y y y
Displacement Mode - Correct Answer - A planing hull, when operated at very slow
y y y yy y y y y y y y y y
speeds, will cut through the water like a displacement hull.
y y y y y y y y y y
,Plowing Mode - Correct Answer - As speed increases, a planing hull will have a raised
y y y yy y y y y y y y y y y y
bow, reducing the operator's vision and throwing a very large wake. Avoid
y y y y y y y y y y y y
maintaining a speed that puts your boat in plowing mode.
y y y y y y y y y y
Planing Mode - Correct Answer - Your boat is in planing mode when enough power is
y y y yy y y y y y y y y y y y
applied so that the hull glides on top of the water. Different boats reach planing mode
y y y y y y y y y y y y y y y y
at different speeds.
y y y
Bow - Correct Answer - Front of a vessel.
y y yy y y y y y
Length overall - Correct Answer - Length of the hull excluding any attachments.
y y y yy y y y y y y y y
Rudder - Correct Answer - Steering device, usually a vertical blade attached to a post
y y yy y y y y y y y y y y y
at, or near, the stern of the boat.
y y y y y y y y
Stern - Correct Answer - Rear of a vessel
y y yy y y y y y
Flat Bottom Hull Advantages - Correct Answer - This planing hull has a shallow draft,
y y y y y yy y y y y y y y y
which is good for fishing in small lakes and rivers.
y y y y y y y y y y
Deep Vee Hull Advantages - Correct Answer - This planing hull gives a smoother ride
y y y y y yy y y y y y y y y
than a flat bottom hull in rough water.
y y y y y y y y
Round Bottom Hull Advantages - Correct Answer - This typical displacement hull
y y y y y yy y y y y y
moves easily through the water even at slow speeds.
y y y y y y y y y
Multi Hull Advantages - Correct Answer - Another example of a displacement hull, the
y y y y yy y y y y y y y y
multi-hull has greater stability because of its wide beam.
y y y y y y y y y
Flat Bottom Hull Disadvantages - Correct Answer - Rides roughly and choppy in the
y y y y y yy y y y y y y y
waters.
y
Deep Vee Hull Disadvantages - Correct Answer - Takes more power to move at the
y y y y y yy y y y y y y y y
same speed as flat bottom hulls. May roll or bank in sharp turns.
y y y y y y y y y y y y y
Round Bottom Hull Disadvantages - Correct Answer - Has a tendency to roll unless it
y y y y y yy y y y y y y y y
has a deep keel or stabilizers.
y y y y y y
Multi Hull Disadvantages - Correct Answer - Needs a large area when turning.
y y y y yy y y y y y y y
Class A - Correct Answer - Less than 16 feet.
y y y yy y y y y y
Class 1 - Correct Answer - 16 feet less than 26 feet.
y y y yy y y y y y y y
Class 2 - Correct Answer - 26 feet less than 40 feet.
y y y yy y y y y y y y
Class 3 - Correct Answer - 40 feet to less than 65 feet.
y y y yy y y y y y y y y
,Propeller - Correct Answer - Rotating device that turns and powers a boat forward or
y y yy y y y y y y y y y y y
backward.
y
Tiller - Correct Answer - Lever used to turn a rudder to steer a boat.
y y yy y y y y y y y y y y y
Transform - Correct Answer - Vertical surface at the back of the hull.
y y yy y y y y y y y y y
Steering Control - Correct Answer - Means of controlling the steering nozzle.
y y y yy y y y y y y y
Safety Lanyard - Correct Answer - Short cord for attaching the ignition safety switch
y y y yy y y y y y y y y y
to the operators wrist or personal life vest.
y y y y y y y y
Throttle - Correct Answer - Lever. y y yy y y
Starboard - Correct Answer - Right side. y y yy y y y
Port - Correct Answer - Left side.
y y yy y y y
Fuel cap - Correct Answer - Where you put gas in on the left side of the seadoo.
y y y yy y y y y y y y y y y y y y
Draft - Correct Answer - Depth of water needed to float a vessel.
y y yy y y y y y y y y y
Intake - Correct Answer - Opening in the hull that draws water toward the impeller.
y y yy y y y y y y y y y y y
Intake grate - Correct Answer - Screening cover over the intake, which prevents large
y y y yy y y y y y y y y y
ydebris from entering. y y
Drive shaft - Correct Answer - The long stem connection between the motor and the
y y y yy y y y y y y y y y y
impeller.
y
Impeller - Correct Answer - Device used to pump and force water under pressure
y y yy y y y y y y y y y y
ythrough a steering nozzle at the rear of the vessel.
y y y y y y y y y
Steering nozzle - Correct Answer - Device used for directing the stream of water to
y y y yy y y y y y y y y y y
the left or right at the stern of the PWC, which steers the PWC
y y y y y y y y y y y y y y
Halyards - Correct Answer - Lines (ropes) used to raise and lower the sails.
y y yy y y y y y y y y y y
Sheets - Correct Answer - Lines (ropes) used to control the angle of the sails to the
y y yy y y y y y y y y y y y y y
wind.
y
Capsize - Correct Answer - To turn on the side or turn completely over.
y y yy y y y y y y y y y y
Swamp - Correct Answer - To fill with water.
y y yy y y y y y
Transom - Correct Answer - Vertical surface at the back of the hull.
y y yy y y y y y y y y y
What is the maximum person on a sail boat - Correct Answer - 7 people or 1050 lbs.
y y y y y y y y y y yy y y y y y y
, Bilge - Correct Answer - Interior of the hull below the floorboards; lowest part of a
y y yy y y y y y y y y y y y y
vessel's interior where the sides of the vessel curve in to form the bottom
y y y y y y y y y y y y y y
Coupler - Correct Answer - The part of the trailer that attaches to the ball hitch on a
y y yy y y y y y y y y y y y y y y
towing vehicle.
y y
Figure Eight Bend - Correct Answer - The figure-eight knot has several uses, including
y y y y yy y y y y y y y y
connecting two ropes to make a longer line or making a "stopper" knot in a single line
y y y y y y y y y y y y y y y y y
in order to prevent the line from slipping through a hole or a gap in a block or a cleat.
y y y y y y y y y y y y y y y y y y y y
Bowline Knot - Correct Answer - The bowline is a multi-purpose knot that is essential
y y y yy y y y y y y y y y y
for boat operators to know. Forming the knot creates a fixed loop on the end of the
y y y y y y y y y y y y y y y y y
rope or line—a loop that can be used for hitching, mooring, or lifting.
y y y y y y y y y y y y y
Anchor Bend Knot - Correct Answer - A type of hitching knot, the anchor bend is used
y y y y yy y y y y y y y y y y y
to secure a rope to an anchor or a ring. If additional security is needed, a half hitch
y y y y y y y y y y y y y y y y y y
can be tied at the end.
y y y y y y
Cleating Hitch - Correct Answer - Used to attach a line to a cleat on a dock, the
y y y yy y y y y y y y y y y y y y
cleating hitch is formed by wrapping the line around the base of the cleat, then
y y y y y y y y y y y y y y y
forming one or more figure eights around the cleat. The knot is secured with a half
y y y y y y y y y y y y y y y y
hitch.
y
Clove Hitch - Correct Answer - The clove hitch is handy for temporary fastening, such
y y y yy y y y y y y y y y y
as when tying up to a piling. It's particularly useful because—with experience—it can
y y y y y y y y y y y y y
be tied with only one hand. For extra fastening power or for longer periods of time,
y y y y y y y y y y y y y y y y
add two half hitches after tying the clove hitch.
y y y y y y y y y
Round Turn and Two Half Hitches - Correct Answer - Handy for tying down a bulky
y y y y y y y yy y y y y y y y
load or tying a boat to a mooring post, the round turn and two half hitches is versatile.
y y y y y y y y y y y y y y y y y y
It is a secure knot that does not jam and is easy to undo.
y y y y y y y y y y y y y y
Vessel - Correct Answer - Every kind of watercraft capable of being used as a means
y y yy y y y y y y y y y y y y
of transportation on water, including seaplanes.
y y y y y y
Give- way vessel - Correct Answer - The vessel that is required to take early and
y y y y yy y y y y y y y y y y
substantial action to keep well away from other vessels by stopping, slowing down or
y y y y y y y y y y y y y y
changing course.
y y
Stand-on vessel - Correct Answer - The vessel that must maintain its course and
y y y yy y y y y y y y y y
speed unless it becomes apparent that the give-way boat is not taking appropriate
y y y y y y y y y y y y y
action; if you must take action, do not turn toward the give-way boat or cross in front
y y y y y y y y y y y y y y y y y
of it.
y y
Leeward - Correct Answer - Direction toward which the wind is blowing, or downwind.
y y yy y y y y y y y y y y
Leeward vessel refers to the vessel that is downwind of the other.
y y y y y y y y y y y y