Massachusetts 1C Hoisting License
Terms in this set (89)
What equipment falls under a Hydraulic telescoping booms without wire ropes and forklifts
1C license?
Any mobile powered-propelled truck used to carry,
Definition of a forklift
push, lift, pull, stack or tier materials.
Types of forklifts Moving mast, fixed mast with telescoping reach, telescoping
boom with areal reach.
Off-road type of forklift Lull
Where should manuals be On the machine at all times
kept?
Danger signal word indicates Hazardous situation that WILL result in death or serious injury
Warning signal word indicates Hazardous situation that COULD result in death or serious injury
Caution signal word indicates Hazardous situation COULD result in MINOR or MODERATE injury
Notice signal word indicates Addresses practices not related to physical injury.
When should equipment be Prior to each use
inspected?
Equipment can be Never
modified from its original
configuration
Lifting a load over someone is Never
permitted
Wearing a seat-belt is Always, if a Roll Over Protective Structure is installed
required
Attachments must be Approved by the manufacturer
Free-rigging or suspending a With approval from the manufacturer
load can only be done
Loads should be carried As low as possible
Riders can be allowed Never
Lowering the forks to the ground, setting the break,
Shutdown procedures include
shutting off the engine, cycling the control levers,
and removing the key.
Load charts Must be displayed clearly on the machine at all times.
How should you proceed Stop before turning, sound horn and proceed slowly.
around blind corners?
Control configuration for Set breaks, controls neutral.
starting
If a condition causes loss of Stop motion and shut down machine in place. Apply a DO NOT
control, what should be OPERATE tag.
done?
, When is a slow moving When traveling on a public road.
vehicle placard required?
Maintain a 3-point contact with machine. Either two
To mount and dismount
hands and one foot or two feet and one hand.
Never use for points of Controls, steering wheel, petals
contact when
mounting/dismounting
Passing under a lifted boom is Never
okay.
When driving, the operator In the direction of travel
should look
If someone approaches the Stop immediately.
machine
No person should enter this Operating radius of the forklift
area when the machine is
operating
Before lifting the operator The rated load capacity
should know what about
the machine?
Before lifting the operator The weight and load center
should know or estimate what
two things about the load?
What should the operator Capacity chart of the machine
refer to determine the
operating range
If traveling over soft or Travel speed and weight of load
unstable ground what two
adjustments should be
made?
Terms in this set (89)
What equipment falls under a Hydraulic telescoping booms without wire ropes and forklifts
1C license?
Any mobile powered-propelled truck used to carry,
Definition of a forklift
push, lift, pull, stack or tier materials.
Types of forklifts Moving mast, fixed mast with telescoping reach, telescoping
boom with areal reach.
Off-road type of forklift Lull
Where should manuals be On the machine at all times
kept?
Danger signal word indicates Hazardous situation that WILL result in death or serious injury
Warning signal word indicates Hazardous situation that COULD result in death or serious injury
Caution signal word indicates Hazardous situation COULD result in MINOR or MODERATE injury
Notice signal word indicates Addresses practices not related to physical injury.
When should equipment be Prior to each use
inspected?
Equipment can be Never
modified from its original
configuration
Lifting a load over someone is Never
permitted
Wearing a seat-belt is Always, if a Roll Over Protective Structure is installed
required
Attachments must be Approved by the manufacturer
Free-rigging or suspending a With approval from the manufacturer
load can only be done
Loads should be carried As low as possible
Riders can be allowed Never
Lowering the forks to the ground, setting the break,
Shutdown procedures include
shutting off the engine, cycling the control levers,
and removing the key.
Load charts Must be displayed clearly on the machine at all times.
How should you proceed Stop before turning, sound horn and proceed slowly.
around blind corners?
Control configuration for Set breaks, controls neutral.
starting
If a condition causes loss of Stop motion and shut down machine in place. Apply a DO NOT
control, what should be OPERATE tag.
done?
, When is a slow moving When traveling on a public road.
vehicle placard required?
Maintain a 3-point contact with machine. Either two
To mount and dismount
hands and one foot or two feet and one hand.
Never use for points of Controls, steering wheel, petals
contact when
mounting/dismounting
Passing under a lifted boom is Never
okay.
When driving, the operator In the direction of travel
should look
If someone approaches the Stop immediately.
machine
No person should enter this Operating radius of the forklift
area when the machine is
operating
Before lifting the operator The rated load capacity
should know what about
the machine?
Before lifting the operator The weight and load center
should know or estimate what
two things about the load?
What should the operator Capacity chart of the machine
refer to determine the
operating range
If traveling over soft or Travel speed and weight of load
unstable ground what two
adjustments should be
made?
