CWB LEVEL 2 CLOSED BOOK STUDY GUIDE / ACTUAL QUESTIONS AND ANSWERS (A+ GUIDE SOLUTION) NEWEST

3/13/25, 12:39 PM CWB LEVEL 2 CLOSED BOOK STUDY GUIDE / ACTUAL QUESTIONS AND ANSWERS (A+ GUIDE SOLUTION) NEWEST Flas…




CWB LEVEL 2 CLOSED BOOK STUDY GUIDE /
ACTUAL QUESTIONS AND ANSWERS (A+ GUIDE
SOLUTION) NEWEST

Save




Terms in this set (25)


To measure the strength a) A transverse weld tension test.
of a welded joint what
mechanical test would you
prescribe?


a) A transverse weld
tension test.
b) A charpy test.
c) A CTOD test.
d) An all weld metal
tension test.
e) A side bend test.




https://quizlet.com/1017751633/cwb-level-2-closed-book-study-guide-actual-questions-and-answers-a-guide-solution-newest-flash-cards/?new 1/11

, 3/13/25, 12:39 PM CWB LEVEL 2 CLOSED BOOK STUDY GUIDE / ACTUAL QUESTIONS AND ANSWERS (A+ GUIDE SOLUTION) NEWEST Flas…


Select the cutting process e) Laser beam cutting
that would provide the
narrowest heat affected
zone when cutting 12.5
mm (0.5 in) thick carbon
steel.


a) Oxy-acetylene cutting.
b) Air-carbon arc cutting.
c) Oxy-propane cutting.
d) Plasma arc cutting.
e) Laser beam cutting

Which of the following b) 2G
refers to a welder test
where a pipe assembly is
placed vertically and the
joint welded in the
horizontal position without
rotating the assembly?


a) 1G
b) 2G
c) 3G
d) 5G
e) 6G

Which of the following b) Crack.
imperfections is normally
considered as
unacceptable regardless
of size or location?


a) Porosity.
b) Crack.
c) Inadequate penetration.
d) Lamination.
e) Burn-through.

https://quizlet.com/1017751633/cwb-level-2-closed-book-study-guide-actual-questions-and-answers-a-guide-solution-newest-flash-cards/?new 2/11