NC BLET FIREARMS VERSION 1 AND 2 EXAM NEWEST 2025 ACTUAL EXAM COMPLETE 150
5 components of semiautomatic pistols - (answer) magazine
barrel
slide
frame
spring
Bristle brush used to clean ____ and ____ on semiautomatic - (answer) frame, slide
___ to ___ drops of oil used when cleaning semiautomatic - (answer) 6-8
Typical gunfight lasts _ to _ seconds - (answer) 2, 3
4 Steps to drawing - (answer) grip, clear holster, bring to center, align with target
When clearing a semiautomatic - (answer) point in a safe direction, drop magazine, physically/visually
inspect, rack slide
cover vs concealment - (answer) cover stops bullets, concealment hides shooter
__% of shooting incidents involve more than one suspect - (answer) 40
the __ ___ of a vehicle affords the best protection when used as cover - (answer) engine block
2 flashlight techniques - (answer) Nonsupported and supported
Nonsupported flashlight techniques - (answer) FBI method, Puckett technique
Supported flashlight techniques - (answer) Harries, modified harries, stacked
, NC BLET FIREARMS VERSION 1 AND 2 EXAM NEWEST 2025 ACTUAL EXAM COMPLETE 150
When a misfire occurs with a revolver - (answer) keep pulling the trigger
Extra magazines in pouch should be placed: - (answer) with the round side forward/towards belt
buckle
Sight alignment - (answer) relationship of front sight to rear sight
Sight picture - (answer) the relationship of the aligned sights to the target
When cleaning, once the weapon has been reassembled, perform a - (answer) function check (such as
dry firing)
One drop of oil goes on a revolver, on the: - (answer) extraction rod
Barrel throat on a revolver can be more effectively cleaned by using - (answer) Lewis Lead Remover or
a .45 cal brush
cylinders on Smith and Wesson revolvers rotate - (answer) counterclockwise
cylinders on Colt revolvers rotate - (answer) clockwise
Hammer Block - (answer) prevents firing if the hammer on a revolver is struck accidentally or slips
during the cocking phase
Single action revolver - (answer) hammer must be pulled back with the thumb into a cocked position
and the trigger squeezed
double action revolver - (answer) fired same as single action or by squeezing trigger only, making the
hammer pull back and fall all in one motion
Misfire - (answer) primer fails to ignite the powder charge
5 components of semiautomatic pistols - (answer) magazine
barrel
slide
frame
spring
Bristle brush used to clean ____ and ____ on semiautomatic - (answer) frame, slide
___ to ___ drops of oil used when cleaning semiautomatic - (answer) 6-8
Typical gunfight lasts _ to _ seconds - (answer) 2, 3
4 Steps to drawing - (answer) grip, clear holster, bring to center, align with target
When clearing a semiautomatic - (answer) point in a safe direction, drop magazine, physically/visually
inspect, rack slide
cover vs concealment - (answer) cover stops bullets, concealment hides shooter
__% of shooting incidents involve more than one suspect - (answer) 40
the __ ___ of a vehicle affords the best protection when used as cover - (answer) engine block
2 flashlight techniques - (answer) Nonsupported and supported
Nonsupported flashlight techniques - (answer) FBI method, Puckett technique
Supported flashlight techniques - (answer) Harries, modified harries, stacked
, NC BLET FIREARMS VERSION 1 AND 2 EXAM NEWEST 2025 ACTUAL EXAM COMPLETE 150
When a misfire occurs with a revolver - (answer) keep pulling the trigger
Extra magazines in pouch should be placed: - (answer) with the round side forward/towards belt
buckle
Sight alignment - (answer) relationship of front sight to rear sight
Sight picture - (answer) the relationship of the aligned sights to the target
When cleaning, once the weapon has been reassembled, perform a - (answer) function check (such as
dry firing)
One drop of oil goes on a revolver, on the: - (answer) extraction rod
Barrel throat on a revolver can be more effectively cleaned by using - (answer) Lewis Lead Remover or
a .45 cal brush
cylinders on Smith and Wesson revolvers rotate - (answer) counterclockwise
cylinders on Colt revolvers rotate - (answer) clockwise
Hammer Block - (answer) prevents firing if the hammer on a revolver is struck accidentally or slips
during the cocking phase
Single action revolver - (answer) hammer must be pulled back with the thumb into a cocked position
and the trigger squeezed
double action revolver - (answer) fired same as single action or by squeezing trigger only, making the
hammer pull back and fall all in one motion
Misfire - (answer) primer fails to ignite the powder charge
