A smog technician is conducting an ASM smog test on a vehicle with a standard
transmission (stick). The engine size is 3.6L. What gear should the technician first try to
conduct the test and what RPM should he keep the engine within while conducting
the test?
Give this one a try later!
2nd gear with the RPM between 1250 and 2500
, The Smog inspector has entered all the data into the EIS. The EIS contacts the VID
and it returns a message "No Match" how should the inspector proceed with this
smog check?
Give this one a try later!
Verify the VIN and Plate number match the numbers on the DMV
paperwork, if so, complete the smog check inspection
The TAC (Thermostatic Air Control) helps heath the incoming air to the induction
system. This control is accomplished by a vacuum operated blend door in the air
cleaner snorkel. When the nine is not running (0° manifold vacuum), in what position is
the blend door?
Give this one a try later!
The "Hot air mode"
During the visual inspection the technician notices that the vehicle has a non OEM
aftermarket carburetor installed. What is the correct procedure to inspect the vehicle
Give this one a try later!
Check to see if the carburetor is approved as a street legal replacement
part
How often must you calibrate the BAR-97 EIS?
transmission (stick). The engine size is 3.6L. What gear should the technician first try to
conduct the test and what RPM should he keep the engine within while conducting
the test?
Give this one a try later!
2nd gear with the RPM between 1250 and 2500
, The Smog inspector has entered all the data into the EIS. The EIS contacts the VID
and it returns a message "No Match" how should the inspector proceed with this
smog check?
Give this one a try later!
Verify the VIN and Plate number match the numbers on the DMV
paperwork, if so, complete the smog check inspection
The TAC (Thermostatic Air Control) helps heath the incoming air to the induction
system. This control is accomplished by a vacuum operated blend door in the air
cleaner snorkel. When the nine is not running (0° manifold vacuum), in what position is
the blend door?
Give this one a try later!
The "Hot air mode"
During the visual inspection the technician notices that the vehicle has a non OEM
aftermarket carburetor installed. What is the correct procedure to inspect the vehicle
Give this one a try later!
Check to see if the carburetor is approved as a street legal replacement
part
How often must you calibrate the BAR-97 EIS?
