NICET LEVEL 1 EXAM WITH COMPLETE QUESTIONS
AND CORRECT VERIFIED ANSWERS(DETAILED
ANSWERS) ALREADY GRADED A+ 100%
GUARANTEED TO PASS CONCEPTS!!!
Two resistors are connected in parallel. Resister one measures 300 ohms and
resistor two measures 300 ohms. What is their equivalent resistance? - CORRECT
ANSWER-150 ohms
Fire warning equipment to be installed in residential occupancies shall produce
the audible emergency evacuation signal described in... - CORRECT ANSWER-
ANSI S3.41
The minimum number of restorable fixed temperature spot type heat detectors
that must be tested during each annual test is... - CORRECT ANSWER-Two
detectors or more on each initiating devices circuit
What is the color code requirement for a spot type heat detector rated at 200°F?
- CORRECT ANSWER-White
,Unless otherwise recommended by the manufacturer's published instructions,
single and multiple station smoke alarms installed in one and two family dwellings
shall be replaced every... - CORRECT ANSWER-10 years from the date of
manufacture
When testing a water level supervisory switch serving a pressure tank, a signal
shall indicate if the water level has changed from the required level by... -
CORRECT ANSWER-Rising or falling 3 inches
Fire alarm cables are permitted to be strapped to conduit to support the cable. -
CORRECT ANSWER-False
Fire Alarm Code? - CORRECT ANSWER-NFPA 72
National Electric Code? - CORRECT ANSWER-NFPA 70
AHJ? - CORRECT ANSWER-Authority Having Jurisdiction
Disconnecting means for fire alarm power shall be what color? - CORRECT
ANSWER-Red
If a combination audible visible appliance is installed, the location of the installed
appliance shall be determined by the requirements of... - CORRECT ANSWER-
The visible appliance
,Where non-powered limited wiring is installed exposed, it must be mechanically
protected within how many feet of the finished floor? - CORRECT ANSWER-7
feet
According to NFPA 72 visible notification appliances for non-sleeping areas must
be mounted between — and — inches above the finished floor? - CORRECT
ANSWER-80 & 96
If system impairment occurs, the owner must be notified — and within —? -
CORRECT ANSWER-In writing & 24 hours
Conductors returning to the fire alarm control panel from the last field device on
the circuit might indicate what type of circuit? - CORRECT ANSWER-Class A
Secondary power supplies for an EVAC fire alarm system shall be capable of
operating for a minimum of — of standby followed by — of alarm. - CORRECT
ANSWER-24 hours and 15 minutes
The secondary power supply for protected premises shall automatically provide
power within how many seconds when the primary power fails? - CORRECT
ANSWER-10 seconds
When the temperature exceeds how many degrees Fahrenheit should spot type
smoke detectors not be installed? - CORRECT ANSWER-Above 100°F
, Who is responsible for maintaining personal protective equipment? - CORRECT
ANSWER-The employee
What does GFCI stand for? - CORRECT ANSWER-Ground fault circuit interrupter
After initial installation, a fixed temperature non-restorable spot type heat
detector shall be tested after how many years? - CORRECT ANSWER-15
Heat detectors should be selected to operate at least how many degrees
Fahrenheit above the maximum expected ambient temperature at the ceiling of
the protected space? - CORRECT ANSWER-20°F
According to NFPA 72, testing records of the fire alarm system shall be kept until
the next test and... - CORRECT ANSWER-Every one year after
Who is responsible for storing and maintaining test records for the fire alarm
system? - CORRECT ANSWER-Owner of the system
Household fire alarm system smoke detectors shall be tested by a technician how
regularly? - CORRECT ANSWER-Annually
Inspection, testing, or maintenance of the fire alarm system shall be permitted to
be done by the building owner or another organization other than the building
owner if... - CORRECT ANSWER-Work is conducted under a written contract
AND CORRECT VERIFIED ANSWERS(DETAILED
ANSWERS) ALREADY GRADED A+ 100%
GUARANTEED TO PASS CONCEPTS!!!
Two resistors are connected in parallel. Resister one measures 300 ohms and
resistor two measures 300 ohms. What is their equivalent resistance? - CORRECT
ANSWER-150 ohms
Fire warning equipment to be installed in residential occupancies shall produce
the audible emergency evacuation signal described in... - CORRECT ANSWER-
ANSI S3.41
The minimum number of restorable fixed temperature spot type heat detectors
that must be tested during each annual test is... - CORRECT ANSWER-Two
detectors or more on each initiating devices circuit
What is the color code requirement for a spot type heat detector rated at 200°F?
- CORRECT ANSWER-White
,Unless otherwise recommended by the manufacturer's published instructions,
single and multiple station smoke alarms installed in one and two family dwellings
shall be replaced every... - CORRECT ANSWER-10 years from the date of
manufacture
When testing a water level supervisory switch serving a pressure tank, a signal
shall indicate if the water level has changed from the required level by... -
CORRECT ANSWER-Rising or falling 3 inches
Fire alarm cables are permitted to be strapped to conduit to support the cable. -
CORRECT ANSWER-False
Fire Alarm Code? - CORRECT ANSWER-NFPA 72
National Electric Code? - CORRECT ANSWER-NFPA 70
AHJ? - CORRECT ANSWER-Authority Having Jurisdiction
Disconnecting means for fire alarm power shall be what color? - CORRECT
ANSWER-Red
If a combination audible visible appliance is installed, the location of the installed
appliance shall be determined by the requirements of... - CORRECT ANSWER-
The visible appliance
,Where non-powered limited wiring is installed exposed, it must be mechanically
protected within how many feet of the finished floor? - CORRECT ANSWER-7
feet
According to NFPA 72 visible notification appliances for non-sleeping areas must
be mounted between — and — inches above the finished floor? - CORRECT
ANSWER-80 & 96
If system impairment occurs, the owner must be notified — and within —? -
CORRECT ANSWER-In writing & 24 hours
Conductors returning to the fire alarm control panel from the last field device on
the circuit might indicate what type of circuit? - CORRECT ANSWER-Class A
Secondary power supplies for an EVAC fire alarm system shall be capable of
operating for a minimum of — of standby followed by — of alarm. - CORRECT
ANSWER-24 hours and 15 minutes
The secondary power supply for protected premises shall automatically provide
power within how many seconds when the primary power fails? - CORRECT
ANSWER-10 seconds
When the temperature exceeds how many degrees Fahrenheit should spot type
smoke detectors not be installed? - CORRECT ANSWER-Above 100°F
, Who is responsible for maintaining personal protective equipment? - CORRECT
ANSWER-The employee
What does GFCI stand for? - CORRECT ANSWER-Ground fault circuit interrupter
After initial installation, a fixed temperature non-restorable spot type heat
detector shall be tested after how many years? - CORRECT ANSWER-15
Heat detectors should be selected to operate at least how many degrees
Fahrenheit above the maximum expected ambient temperature at the ceiling of
the protected space? - CORRECT ANSWER-20°F
According to NFPA 72, testing records of the fire alarm system shall be kept until
the next test and... - CORRECT ANSWER-Every one year after
Who is responsible for storing and maintaining test records for the fire alarm
system? - CORRECT ANSWER-Owner of the system
Household fire alarm system smoke detectors shall be tested by a technician how
regularly? - CORRECT ANSWER-Annually
Inspection, testing, or maintenance of the fire alarm system shall be permitted to
be done by the building owner or another organization other than the building
owner if... - CORRECT ANSWER-Work is conducted under a written contract
