QMED - Oiler Exam Prep ALREADY PASSED
If a bolt or stud were to break off flush at the surface, how do you remove it - =drill a hole in the
center of the stud
The number of screw threads per inch for Standard National Coarse 1/2 bolt is - =13
If a matching nut and bolt have class 4 or no. 4 fit they will - =be hard to turn by hand but easy
with a wrench
what basic dimensions are used in describing bolts - =diameter, length, and number of threads
per inch
The letters NC in 1/4-20NC indicates the bolt is - =threaded with national coarse threads
the term 5/16 - 24 desscribes - =bolt size and threads per inch
the best method of determining threads per inch of a bolt or screw would be through the use of -
=thread tool gage
if you have to abandon ship and enter a liferaft, your main course of action should be to -
=remain in the vicinity of the sinking vessel
the station bill shows each crew lifeboat station, their duties during abandonment, basic
instructions and - =all emergency signals
part of the required equipment for a lifeboat includes - =boathook, painter, whistle
which of the following events shall be conducted during a fire and boat drill - =all watertight
doors which are in use while the vessel is underway shall be operated
,you have abandoned ship and are in charge of a liferaft or lifeboat. How much water per day
should you permit each person after the first 24 hours - =1 pint
can freshwater be obtained from fish - =no
inflatable life rafts must be overhauled and inspected at a USCG approved servicing facility
every - =twelve months
a safety feature on all inflatable life rafts is - =the use of water stabilizing pockets
an inflatable life raft is floating in its container, attached to the ship by its painter, as the ship is
sinking rapidly. what action should be taken - =no action the pull on the painter will cause the
life raft to inflate
the operating cord on an inflatable life raft also serves as a - =painter
puncture leaks in the lower tubes, or bottom of an inflatable liferaft should first be stopped by
using - =sealing clamps
does an immersion suit reduce the rate of body cooling and increase the survival time in cold
water - =yes
most enclosed lifeboats or covered survival capsules will automatically right themselves if they
capsize. this will occur when - =all passengers are strapped in their seats
if the water level is rising in the bilge of a survival craft you should first - =check the bilge drain
plug
your survival craft is rolling in heavy seas, you can reduce the possibilty of capsizing by -
=rigging a sea anchor
, you are in a survival craft broadcasting a distress message, what information is essential to your
rescuers - =your latitude and longitude
using a sea anchor with the survival craft will - =reduce your drift rate
physical exertion on the part of a person who has fallen into cold water can - =increase your rate
of heat loss
once the daily ration of drinking water in a survival situation has been established, the drinking
routine should include - =one half the daily ration twice during the day
during an abandonment drill, the first person to arrive at the survival craft should - =prepare the
craft for boarding
if you have to abandon ship and enter a liferaft your main course of action should be to - =remain
in the vicinity of the sinking vessel
you can find the location of your abandon ship post by checking - =the station bill
while at your lifeboat station, a signal consisting of two short blasts of the ships whistle is
sounded. this indicates - =stop lowering the boats
true or false: a small leak in an immersion suit will destroy its protective qualities against
hypothermia - =false
the lights on the outside of the canopy of an inflatable life raft operate - =automatically when the
raft is inflated
if you hear a continous blast of the whistle and general alarm for more than 10 seconds you
should - =go to your fire station
If a bolt or stud were to break off flush at the surface, how do you remove it - =drill a hole in the
center of the stud
The number of screw threads per inch for Standard National Coarse 1/2 bolt is - =13
If a matching nut and bolt have class 4 or no. 4 fit they will - =be hard to turn by hand but easy
with a wrench
what basic dimensions are used in describing bolts - =diameter, length, and number of threads
per inch
The letters NC in 1/4-20NC indicates the bolt is - =threaded with national coarse threads
the term 5/16 - 24 desscribes - =bolt size and threads per inch
the best method of determining threads per inch of a bolt or screw would be through the use of -
=thread tool gage
if you have to abandon ship and enter a liferaft, your main course of action should be to -
=remain in the vicinity of the sinking vessel
the station bill shows each crew lifeboat station, their duties during abandonment, basic
instructions and - =all emergency signals
part of the required equipment for a lifeboat includes - =boathook, painter, whistle
which of the following events shall be conducted during a fire and boat drill - =all watertight
doors which are in use while the vessel is underway shall be operated
,you have abandoned ship and are in charge of a liferaft or lifeboat. How much water per day
should you permit each person after the first 24 hours - =1 pint
can freshwater be obtained from fish - =no
inflatable life rafts must be overhauled and inspected at a USCG approved servicing facility
every - =twelve months
a safety feature on all inflatable life rafts is - =the use of water stabilizing pockets
an inflatable life raft is floating in its container, attached to the ship by its painter, as the ship is
sinking rapidly. what action should be taken - =no action the pull on the painter will cause the
life raft to inflate
the operating cord on an inflatable life raft also serves as a - =painter
puncture leaks in the lower tubes, or bottom of an inflatable liferaft should first be stopped by
using - =sealing clamps
does an immersion suit reduce the rate of body cooling and increase the survival time in cold
water - =yes
most enclosed lifeboats or covered survival capsules will automatically right themselves if they
capsize. this will occur when - =all passengers are strapped in their seats
if the water level is rising in the bilge of a survival craft you should first - =check the bilge drain
plug
your survival craft is rolling in heavy seas, you can reduce the possibilty of capsizing by -
=rigging a sea anchor
, you are in a survival craft broadcasting a distress message, what information is essential to your
rescuers - =your latitude and longitude
using a sea anchor with the survival craft will - =reduce your drift rate
physical exertion on the part of a person who has fallen into cold water can - =increase your rate
of heat loss
once the daily ration of drinking water in a survival situation has been established, the drinking
routine should include - =one half the daily ration twice during the day
during an abandonment drill, the first person to arrive at the survival craft should - =prepare the
craft for boarding
if you have to abandon ship and enter a liferaft your main course of action should be to - =remain
in the vicinity of the sinking vessel
you can find the location of your abandon ship post by checking - =the station bill
while at your lifeboat station, a signal consisting of two short blasts of the ships whistle is
sounded. this indicates - =stop lowering the boats
true or false: a small leak in an immersion suit will destroy its protective qualities against
hypothermia - =false
the lights on the outside of the canopy of an inflatable life raft operate - =automatically when the
raft is inflated
if you hear a continous blast of the whistle and general alarm for more than 10 seconds you
should - =go to your fire station
