1|Page
ASNT LEVEL III BASIC EXAM NEWEST 2025
ACTUAL EXAM COMPLETE 300 QUESTIONS
AND CORRECT DETAILED ANSWERS
(VERIFIED ANSWERS) |ALREADY GRADED A+
CH2. 3 - When the near-distance vision acuity examination is
given using a jaeger reading card, it must be given: - CORRECT
ANSWER-a. in accordance with a procedure
CH2. 4 - As required in CP-189, Level I Practical examinations
are intended to be: - CORRECT ANSWER-c. given using one or
more test samples for each technique
CH2. 5 - The Practical Examination shall address the technical
and practical competency of the examinee when following
prepared NDT procedures for: - CORRECT ANSWER-d. Levels
I and II
CH3. 1 - ASNT NDT Level III certification is a requirement of:
- CORRECT ANSWER-b. CP-189
,2|Page
CH3. 2 - A currently valid ASNT NDT Level III certificate
indicates: - CORRECT ANSWER-d. that the certificate holder
has satisfied the Basic and Method exam requirements as set
forth in SNT-TC-1A
CH3. 3 - ASNT NDT Level III certification: - CORRECT
ANSWER-c. makes an individual potentially eligible to become
an employer's Level III
CH3. 4 - The ASNT NDT Level III Basic Examination covers
all of the following except: - CORRECT ANSWER-d.
knowledge of international certification programs
CH3. 5 - To recertify by application, an ADNT NDT Level III
must: - CORRECT ANSWER-a. demonstrate continued NDT
activity and Level III employment
CH3. 6 - To be eligible to sit for the ASNT NDT Level III
exams, a candidate with two years of passing grades in
engineering or science study at a university or technical school
must have: - CORRECT ANSWER-b. two additional years of
experience beyond the Level II requirements in NDT in an
assignment at least comparable to that of NDT Level II in the
applicable NDT method(s)
,3|Page
CH4 (AE). 1 - The most common range of acoustic emission
testing is: - CORRECT ANSWER-b. 100-300 kHz
CH4 (AE). 2 - Discontinuities that are not readily detectable by
acoustic emission testing are: - CORRECT ANSWER-d.
rounded inclusions
CH4 (AE). 3 - The total energy loss of a propagating wave is
called: - CORRECT ANSWER-d. attenuation
CH4 (AE). 4 - The kaiser effect refers to: - CORRECT
ANSWER-c. the behavior where emission from a source will
not occur until the previous load is exceeded
CH4 (AE). 5 - The felicity effect is useful in evaluating: -
CORRECT ANSWER-a. fiber-reinforced plastic components
CH4 (AE). 6 - The kaiser effect is useful in distinguishing: -
CORRECT ANSWER-c. mechanical noise from growing
discontinuities
, 4|Page
CH4 (AE). 7 - The term "counts" refers to the: - CORRECT
ANSWER-a. number of times a signal crosses a preset threshold
CH4 (AE). 8 - The acoustic emission signal amplitude is related
to: - CORRECT ANSWER-b. the intensity of the source
CH4 (AE). 9 - Threshold settings are determined by the: -
CORRECT ANSWER-d. background noise level
CH4 (AE). 10 - Background noise can be reduced by: -
CORRECT ANSWER-a. electronic filtering
CH4 (ET). 1 - Eddy currents are circulating electrical currents
induced in conductive materials by: - CORRECT ANSWER-c.
an altering magnetic field
CH4 (ET). 2 - The method used to generate eddy currents in a
test specimen by means of a coil can most closely be compared
with the action of a: - CORRECT ANSWER-a. transformer
CH4 (ET). 3 - Electromagnetic testing relies on the principle of:
- CORRECT ANSWER-b. electromagnetic induction
ASNT LEVEL III BASIC EXAM NEWEST 2025
ACTUAL EXAM COMPLETE 300 QUESTIONS
AND CORRECT DETAILED ANSWERS
(VERIFIED ANSWERS) |ALREADY GRADED A+
CH2. 3 - When the near-distance vision acuity examination is
given using a jaeger reading card, it must be given: - CORRECT
ANSWER-a. in accordance with a procedure
CH2. 4 - As required in CP-189, Level I Practical examinations
are intended to be: - CORRECT ANSWER-c. given using one or
more test samples for each technique
CH2. 5 - The Practical Examination shall address the technical
and practical competency of the examinee when following
prepared NDT procedures for: - CORRECT ANSWER-d. Levels
I and II
CH3. 1 - ASNT NDT Level III certification is a requirement of:
- CORRECT ANSWER-b. CP-189
,2|Page
CH3. 2 - A currently valid ASNT NDT Level III certificate
indicates: - CORRECT ANSWER-d. that the certificate holder
has satisfied the Basic and Method exam requirements as set
forth in SNT-TC-1A
CH3. 3 - ASNT NDT Level III certification: - CORRECT
ANSWER-c. makes an individual potentially eligible to become
an employer's Level III
CH3. 4 - The ASNT NDT Level III Basic Examination covers
all of the following except: - CORRECT ANSWER-d.
knowledge of international certification programs
CH3. 5 - To recertify by application, an ADNT NDT Level III
must: - CORRECT ANSWER-a. demonstrate continued NDT
activity and Level III employment
CH3. 6 - To be eligible to sit for the ASNT NDT Level III
exams, a candidate with two years of passing grades in
engineering or science study at a university or technical school
must have: - CORRECT ANSWER-b. two additional years of
experience beyond the Level II requirements in NDT in an
assignment at least comparable to that of NDT Level II in the
applicable NDT method(s)
,3|Page
CH4 (AE). 1 - The most common range of acoustic emission
testing is: - CORRECT ANSWER-b. 100-300 kHz
CH4 (AE). 2 - Discontinuities that are not readily detectable by
acoustic emission testing are: - CORRECT ANSWER-d.
rounded inclusions
CH4 (AE). 3 - The total energy loss of a propagating wave is
called: - CORRECT ANSWER-d. attenuation
CH4 (AE). 4 - The kaiser effect refers to: - CORRECT
ANSWER-c. the behavior where emission from a source will
not occur until the previous load is exceeded
CH4 (AE). 5 - The felicity effect is useful in evaluating: -
CORRECT ANSWER-a. fiber-reinforced plastic components
CH4 (AE). 6 - The kaiser effect is useful in distinguishing: -
CORRECT ANSWER-c. mechanical noise from growing
discontinuities
, 4|Page
CH4 (AE). 7 - The term "counts" refers to the: - CORRECT
ANSWER-a. number of times a signal crosses a preset threshold
CH4 (AE). 8 - The acoustic emission signal amplitude is related
to: - CORRECT ANSWER-b. the intensity of the source
CH4 (AE). 9 - Threshold settings are determined by the: -
CORRECT ANSWER-d. background noise level
CH4 (AE). 10 - Background noise can be reduced by: -
CORRECT ANSWER-a. electronic filtering
CH4 (ET). 1 - Eddy currents are circulating electrical currents
induced in conductive materials by: - CORRECT ANSWER-c.
an altering magnetic field
CH4 (ET). 2 - The method used to generate eddy currents in a
test specimen by means of a coil can most closely be compared
with the action of a: - CORRECT ANSWER-a. transformer
CH4 (ET). 3 - Electromagnetic testing relies on the principle of:
- CORRECT ANSWER-b. electromagnetic induction
