FDOT ASPHALT PAVING LEVEL 1 EXAM NEWEST
ACTUAL EXAM COMPLETE QUESTIONS AND
CORRECT DETAILED ANSWERS (VERIFIED ANSWERS)
|ALREADY GRADED A+
S to N - (ANSWER)Downstation
W to E - (ANSWER)Downstation
Stationing - (ANSWER)Starts at 0+00
Stationing Measurement - (ANSWER)1+00 is 100 feet
Straight Edge is the - (ANSWER)Measurement of Pavement smoothness with a 15
foot 4.573 m rolling straightedge
Straight Edge is used to - (ANSWER)identify problems
Random sampling - (ANSWER)Are random numbers generated usually by a VT for
cores to be extracted from the roadway
How often should you calibrate a Straight edge - (ANSWER)Calibrate at the start
of each working period
, Using the manual straight edge you find what kind of spot to place the rolling
straightedge? - (ANSWER)Locate a flat area with the manual straightedge and
place the rolling straightedge next to the manual straightedge and the gauge
should read 0
The 3/16 and the 3/8 shims go under which wheels during calibration -
(ANSWER)The outside wheels to measure the low and the center to measure the
high. Gauge should read 3/16 on the 3/16 shim and vice versa for the 3/8 shims.
Make sure the center wheel moves up and down freely.
Calibration materials for Straightedge - (ANSWER)Rolling Straightedge
Manual Straightedge
Manual Measurement (ruler)
x4 3/16 shims 5mm thick
x4 3/8 shims 10mm thick
When to perform final straightedge - (ANSWER)After an entire lane has been
paved
When to perform final straightedge - (ANSWER)Pavement should be an ambient
temperature
You cannot use the straightedge until it has been properly - (ANSWER)calibrated
ACTUAL EXAM COMPLETE QUESTIONS AND
CORRECT DETAILED ANSWERS (VERIFIED ANSWERS)
|ALREADY GRADED A+
S to N - (ANSWER)Downstation
W to E - (ANSWER)Downstation
Stationing - (ANSWER)Starts at 0+00
Stationing Measurement - (ANSWER)1+00 is 100 feet
Straight Edge is the - (ANSWER)Measurement of Pavement smoothness with a 15
foot 4.573 m rolling straightedge
Straight Edge is used to - (ANSWER)identify problems
Random sampling - (ANSWER)Are random numbers generated usually by a VT for
cores to be extracted from the roadway
How often should you calibrate a Straight edge - (ANSWER)Calibrate at the start
of each working period
, Using the manual straight edge you find what kind of spot to place the rolling
straightedge? - (ANSWER)Locate a flat area with the manual straightedge and
place the rolling straightedge next to the manual straightedge and the gauge
should read 0
The 3/16 and the 3/8 shims go under which wheels during calibration -
(ANSWER)The outside wheels to measure the low and the center to measure the
high. Gauge should read 3/16 on the 3/16 shim and vice versa for the 3/8 shims.
Make sure the center wheel moves up and down freely.
Calibration materials for Straightedge - (ANSWER)Rolling Straightedge
Manual Straightedge
Manual Measurement (ruler)
x4 3/16 shims 5mm thick
x4 3/8 shims 10mm thick
When to perform final straightedge - (ANSWER)After an entire lane has been
paved
When to perform final straightedge - (ANSWER)Pavement should be an ambient
temperature
You cannot use the straightedge until it has been properly - (ANSWER)calibrated
