AMMO CDC’S SET B VOLUME 1 WITH VERIFIED ANSWERS.
(001) Before using an electric drill, what is the first thing you should do? - ANSWER
Make sure the diameter of the hole is to be drilled is within the capacity of the drill.
(001) The purpose of cutting lubricant in most drilling operations is to increase the -
ANSWER Drilling speed and the drill bit life
(001) Which minimum articles of safety gear must be worn when using a bench
grinder? - ANSWER Eye and Face Protection.
(001) An electric saw blade must be operating at what speed before it contacts the
material being cut? - ANSWER Full.
(002) How many pounds per square inch (PSI) of clean, dry air is required at the tool
end of the air hose to ensure the tool is operating safely and efficiently? - ANSWER
90.
(003) What condition would prevent an operator from applying power to a hoist or
other powered lifting device? - ANSWER An AF Form 979 is attached to the unit.
(003) What should be worn anytime there is a potential for injury from overhead
objects during a lifting operation? - ANSWER Protective Helmets.
(003) What is the most common type of lifting sling used in the munitions career
field? - ANSWER Wire Rope.
(003) The following are all good safety practices to follow when using a lifting sling
except - ANSWER Inspecting the sling by passing your bare hand over the body of
the sling.
(004) The annunciators displayed on the Fluke 8025-series multimeter are used to
distinguish among... - ANSWER Ohms, Kilohms, and Megohms.
(004) What are the two operational modes of the Fluke 8025-series multimeter? -
ANSWER Range and Hold.
(005) The steering system on the MHU-141/M trailer has a turning radius of how
many inches? - ANSWER 200.
(005) When the MHU-141 trailer is loaded or towed with the hinged deck panels
open, what must be done? - ANSWER The deck-panel supports must be properly
positioned and held in place with quick-release pins.
(006) What is the maximum load capacity of the MHU-110/M trailer? - ANSWER
15,000 pounds.
(006) The parking brake on the MHU-110/M is applied by - ANSWER Pulling either
one of two hand levers located on each side of the front trailer.
(007) How many openings (hinged door panels) are on the deck of the MHU-226
trailer? - ANSWER Three.
, AMMO CDC’S SET B VOLUME 1 WITH VERIFIED ANSWERS.
(007) What type of steering aids the MHU-226 in a tighter steering radius? -
ANSWER Four-wheeled double Ackerman.
(008) After 463L pallets are positioned on a rollerized trailer, what can you use to
secure the pallets to the trailer? - ANSWER MB-1 chain assemblies and/or tie-down
straps.
(008) What kind of movement supports on-base activities to or from the flightline? -
ANSWER Operational.
(009) What munitions item is not loaded into transport modules by munitions
personnel? - ANSWER 20 MM.
(009) What transport module used for decoy munitions has a maximum capacity of
30 magazines? - ANSWER ALE-50.
(009) How often should the positive locking devices on the doors of munitions
transport modules be checked? - ANSWER After loading, unloading, and
periodically between stops.
(010) The purpose of the transport beam beneath the lift arm assemblies on the MJ-
1-series lift truck is to - ANSWER Provide added support and to relieve hydraulic
pressure from the lift arms when carrying loads for distances.
(010) What is the lifting capacity of the MJ-1 series lift truck? - ANSWER 3,000
pounds.
(010) What is the lifting capacity of the MHU-83-series lift truck? - ANSWER 7,000
pounds.
(010) When using the MHU-83-series lift truck with fork adapters, you immediately -
ANSWER Reduce its lifting capability by 1,000 pounds.
(010) What happens when you release the accelerator pedal on a vehicle driven with
a hydrostatic transmission? - ANSWER The unit coasts to a stop very quickly.
(010) What is the primary drawback to using the hydraulic hand pump to build
hydraulic pressure on the MHU-83 series lift truck? - ANSWER Extremely slow way
to build hydraulic pressure.
(010) How is the yaw positioning from the cradle or boom controls of an MJ-1 lift
truck adjusted? - ANSWER Manually.
(011) What category or categories are Air Force air compressors classified? -
ANSWER High or Low pressure.
(012) The primary difference between a bobtail and a pickup truck is the - ANSWER
Bobtail's back end is shortened by about one-half.
(001) Before using an electric drill, what is the first thing you should do? - ANSWER
Make sure the diameter of the hole is to be drilled is within the capacity of the drill.
(001) The purpose of cutting lubricant in most drilling operations is to increase the -
ANSWER Drilling speed and the drill bit life
(001) Which minimum articles of safety gear must be worn when using a bench
grinder? - ANSWER Eye and Face Protection.
(001) An electric saw blade must be operating at what speed before it contacts the
material being cut? - ANSWER Full.
(002) How many pounds per square inch (PSI) of clean, dry air is required at the tool
end of the air hose to ensure the tool is operating safely and efficiently? - ANSWER
90.
(003) What condition would prevent an operator from applying power to a hoist or
other powered lifting device? - ANSWER An AF Form 979 is attached to the unit.
(003) What should be worn anytime there is a potential for injury from overhead
objects during a lifting operation? - ANSWER Protective Helmets.
(003) What is the most common type of lifting sling used in the munitions career
field? - ANSWER Wire Rope.
(003) The following are all good safety practices to follow when using a lifting sling
except - ANSWER Inspecting the sling by passing your bare hand over the body of
the sling.
(004) The annunciators displayed on the Fluke 8025-series multimeter are used to
distinguish among... - ANSWER Ohms, Kilohms, and Megohms.
(004) What are the two operational modes of the Fluke 8025-series multimeter? -
ANSWER Range and Hold.
(005) The steering system on the MHU-141/M trailer has a turning radius of how
many inches? - ANSWER 200.
(005) When the MHU-141 trailer is loaded or towed with the hinged deck panels
open, what must be done? - ANSWER The deck-panel supports must be properly
positioned and held in place with quick-release pins.
(006) What is the maximum load capacity of the MHU-110/M trailer? - ANSWER
15,000 pounds.
(006) The parking brake on the MHU-110/M is applied by - ANSWER Pulling either
one of two hand levers located on each side of the front trailer.
(007) How many openings (hinged door panels) are on the deck of the MHU-226
trailer? - ANSWER Three.
, AMMO CDC’S SET B VOLUME 1 WITH VERIFIED ANSWERS.
(007) What type of steering aids the MHU-226 in a tighter steering radius? -
ANSWER Four-wheeled double Ackerman.
(008) After 463L pallets are positioned on a rollerized trailer, what can you use to
secure the pallets to the trailer? - ANSWER MB-1 chain assemblies and/or tie-down
straps.
(008) What kind of movement supports on-base activities to or from the flightline? -
ANSWER Operational.
(009) What munitions item is not loaded into transport modules by munitions
personnel? - ANSWER 20 MM.
(009) What transport module used for decoy munitions has a maximum capacity of
30 magazines? - ANSWER ALE-50.
(009) How often should the positive locking devices on the doors of munitions
transport modules be checked? - ANSWER After loading, unloading, and
periodically between stops.
(010) The purpose of the transport beam beneath the lift arm assemblies on the MJ-
1-series lift truck is to - ANSWER Provide added support and to relieve hydraulic
pressure from the lift arms when carrying loads for distances.
(010) What is the lifting capacity of the MJ-1 series lift truck? - ANSWER 3,000
pounds.
(010) What is the lifting capacity of the MHU-83-series lift truck? - ANSWER 7,000
pounds.
(010) When using the MHU-83-series lift truck with fork adapters, you immediately -
ANSWER Reduce its lifting capability by 1,000 pounds.
(010) What happens when you release the accelerator pedal on a vehicle driven with
a hydrostatic transmission? - ANSWER The unit coasts to a stop very quickly.
(010) What is the primary drawback to using the hydraulic hand pump to build
hydraulic pressure on the MHU-83 series lift truck? - ANSWER Extremely slow way
to build hydraulic pressure.
(010) How is the yaw positioning from the cradle or boom controls of an MJ-1 lift
truck adjusted? - ANSWER Manually.
(011) What category or categories are Air Force air compressors classified? -
ANSWER High or Low pressure.
(012) The primary difference between a bobtail and a pickup truck is the - ANSWER
Bobtail's back end is shortened by about one-half.
