Welding 1, Module 9 Exam 2025 Questions & Answers with 100% Correct Answers | Verified

When overlapping stringer beads, use a work angle of ______ to _____ degrees toward the first stringer bead to obtain proper tie-in. - 10-15 The general rule is that the arc length should be _________________ when striking an arc in SMAW welding. - same as the rod. Concentrated magnetic fields in the base metal cause the arc to __________. - deflect Use a __________ motion to control the weld puddle when depositing an E6010 electrode stringer bead. - whipping A ________ bead is a weld bead that is made with a side-to-side motion of the electrode. - 6010 Arc strikes are left on the base metal by the _________ method of striking an arc. - scratching Arc length is measured from the end to the electrode ________________________________. - to the base metal. The most common fillet welds made up are in _______ and ______ joints. - lap and T The weld ___________ is the point at which the back of the weld intersects the base metal. - root The best method of striking an arc when using a transformer DC welding machine is the _______________ method. - tapping Use a wire brush or grinder to ________ the coupons before welding coupons made of 1/4" to 3/4" mild steel. - remove