POST GR1 AE 210S TEST LATEST UPDATE
What is the relationship between thrust available and power available? - ANSWER
Power available is thrust available multiplied by velocity.
Which of the following statements correctly describes the relationship between the
speed for minimum thrust required and the speed for minimum power required? -
ANSWER Minimum thrust required occurs at a higher speed than the speed for minimum
power required.
Maximum velocity on power available/required vs. velocity curve occurs at the same
speed as the max velocity on that same aircraft's thrust and drag vs. velocity curve. -
ANSWER True
An F-16 has just completed aerial refueling, increasing its weight by 6,000 lb. Assume
altitude and aircraft configuration did not change. Compared with its speed for (L/D)max
prior to refueling, how would you expect its speed for (L/D)max after refueling to differ? -
ANSWER The speed for (L/D)max would be higher.
A Global Hawk aircraft must fly a mission that has the maximum possible duration.
Therefore, it must fly at its speed for (L/D)max . At the same time, its operators wish to
have it fly as far as possible while maintaining its (L/D)max airspeed. What altitude would
you recommend for this mission? - ANSWER Fly as high as possible for maximum true
airspeed while flying at the airspeed for (L/D)max.
A 12,000-lb T-38 is flying at M = 0.5 at 10,000 ft using military power. Based on the power
available and power required chart on page 602 of your textbook what is the aircraft's
specific excess power, that is, the quantity (power available minus power required)
divided by the aircraft weight for these conditions? - ANSWER 100 ft/s
Which of the following statements about jet engines is true? (there are two correct
answers. Pick either one) - ANSWER Jet engines make thrust by pushing air out the
back of the engine at a higher speed than the speed at which the air came in the front
What would be the best engine choice if you were designing an aircraft that will be
operating primarily at 300 KTAS and 30,000 feet? (Hint: Refer to Figure 5.4) - ANSWER
Turboprop
What is Thrust Specific Fuel Consumption (TSFC)? - ANSWER Fuel flow rate (lbs/hr) per
pound of output thrust (lbs)
If you were designing an aircraft to fly at M = 0.8, what would be the most fuel efficient
engine you could choose? (Hint: refer to Figure 5.3 and lower TSFC is better...) -
ANSWER High-bypass turbofan
Afterburners are a fuel-efficient way of increasing thrust? - ANSWER False
, If you were designing an aircraft to fly at M = 0.5 and you wanted the engine with the
highest thrust-to-weight ratio, which engine would you choose (Assume that a rocket is
not an option)? (Hint: refer to Figure 5.2) - ANSWER Afterburning turbofan
You are flying in your F-22 from Tyndall AFB, FL practicing intercepts. You receive a
radio call stating that a dense fog bank has unexpectedly closed Tyndall and your
alternate, Eglin AFB. The closest airfield with acceptable weather is Barksdale AFB, LA,
some 500 NM away. Your digital mission planner indicates that you are already at the
optimum cruise altitude, but that the maximum possible range you can achieve with the
fuel on board is 400 NM. What should you do? - ANSWER Find a tanker
A tanker is also on its way to Barksdale, and is about 300 NM ahead of you, but they are
low on gas, too. They agree to orbit at their present position and altitude and let you
catch up. What speed should you maintain on your way to the rendezvous with the
tanker? - ANSWER Max range airspeed
What speed should the tanker maintain while they orbit waiting for you to arrive? -
ANSWER Maximum L/D airspeed.
If your F-22's drag polar is given by CD = 0.0148 + 0.133 CL2, what lift coefficient should
you maintain en route to the rendezvous point? Look carefully at the relationships
between CD and CL at the desired performance point, max endurance or max range.
Solve for the CL at that desired performance point. - ANSWER 0.193
Again, your F-22's drag polar is given by CD = 0.0148 + 0.133 CL2. Its wing area is 830
ft2 and it weighs 50,000 lbs at the moment. Assuming that you are flying at the
tropopause on a standard day, you maintain M = 0.8 en route to the rendezvous point
300 nm away, and your TSFC at this Mach and altitude is 1.095/hr, how much gas will
you burn to get there? This one will take some thought, but look at what you need.
Pounds of fuel. That will come from the TSFC. Carefully review the units of TSFC and
decide how you can cancel out terms to get to pounds of fuel. Consider calculating
average drag and using Eq 5.39. - ANSWER 3,300 lb
You are flying with your buddy who has challenged you on spot landings, in which you
reduce power on downwind and maneuver to land without power. If you add power, you
lose the bet. The one who lands closest to the approach end of the runway wins. Today
you reduce power early and roll out on final lower than normal. You establish the normal
(L/D)max for gear down, no flaps final approach glide speed and discover that your
plane is going to land short of the runway. What should you do? - ANSWER Add power
and go around. You lose the bet again.
You are in a glide at (L/D)max, what effect will decreasing your weight (dropping
payload or ejecting your back seater) have on your glide? Glide range will____________.
The velocity to fly at (L/D)max will_____________ - ANSWER not change, decrease
An 12,000 lb T-38 is in a steady climb passing 10,000 ft at 0.5 Mach on a Standard Day.
What is its rate of climb using military thrust? - ANSWER 100 ft/s = 6,000 ft/min
What is the relationship between thrust available and power available? - ANSWER
Power available is thrust available multiplied by velocity.
Which of the following statements correctly describes the relationship between the
speed for minimum thrust required and the speed for minimum power required? -
ANSWER Minimum thrust required occurs at a higher speed than the speed for minimum
power required.
Maximum velocity on power available/required vs. velocity curve occurs at the same
speed as the max velocity on that same aircraft's thrust and drag vs. velocity curve. -
ANSWER True
An F-16 has just completed aerial refueling, increasing its weight by 6,000 lb. Assume
altitude and aircraft configuration did not change. Compared with its speed for (L/D)max
prior to refueling, how would you expect its speed for (L/D)max after refueling to differ? -
ANSWER The speed for (L/D)max would be higher.
A Global Hawk aircraft must fly a mission that has the maximum possible duration.
Therefore, it must fly at its speed for (L/D)max . At the same time, its operators wish to
have it fly as far as possible while maintaining its (L/D)max airspeed. What altitude would
you recommend for this mission? - ANSWER Fly as high as possible for maximum true
airspeed while flying at the airspeed for (L/D)max.
A 12,000-lb T-38 is flying at M = 0.5 at 10,000 ft using military power. Based on the power
available and power required chart on page 602 of your textbook what is the aircraft's
specific excess power, that is, the quantity (power available minus power required)
divided by the aircraft weight for these conditions? - ANSWER 100 ft/s
Which of the following statements about jet engines is true? (there are two correct
answers. Pick either one) - ANSWER Jet engines make thrust by pushing air out the
back of the engine at a higher speed than the speed at which the air came in the front
What would be the best engine choice if you were designing an aircraft that will be
operating primarily at 300 KTAS and 30,000 feet? (Hint: Refer to Figure 5.4) - ANSWER
Turboprop
What is Thrust Specific Fuel Consumption (TSFC)? - ANSWER Fuel flow rate (lbs/hr) per
pound of output thrust (lbs)
If you were designing an aircraft to fly at M = 0.8, what would be the most fuel efficient
engine you could choose? (Hint: refer to Figure 5.3 and lower TSFC is better...) -
ANSWER High-bypass turbofan
Afterburners are a fuel-efficient way of increasing thrust? - ANSWER False
, If you were designing an aircraft to fly at M = 0.5 and you wanted the engine with the
highest thrust-to-weight ratio, which engine would you choose (Assume that a rocket is
not an option)? (Hint: refer to Figure 5.2) - ANSWER Afterburning turbofan
You are flying in your F-22 from Tyndall AFB, FL practicing intercepts. You receive a
radio call stating that a dense fog bank has unexpectedly closed Tyndall and your
alternate, Eglin AFB. The closest airfield with acceptable weather is Barksdale AFB, LA,
some 500 NM away. Your digital mission planner indicates that you are already at the
optimum cruise altitude, but that the maximum possible range you can achieve with the
fuel on board is 400 NM. What should you do? - ANSWER Find a tanker
A tanker is also on its way to Barksdale, and is about 300 NM ahead of you, but they are
low on gas, too. They agree to orbit at their present position and altitude and let you
catch up. What speed should you maintain on your way to the rendezvous with the
tanker? - ANSWER Max range airspeed
What speed should the tanker maintain while they orbit waiting for you to arrive? -
ANSWER Maximum L/D airspeed.
If your F-22's drag polar is given by CD = 0.0148 + 0.133 CL2, what lift coefficient should
you maintain en route to the rendezvous point? Look carefully at the relationships
between CD and CL at the desired performance point, max endurance or max range.
Solve for the CL at that desired performance point. - ANSWER 0.193
Again, your F-22's drag polar is given by CD = 0.0148 + 0.133 CL2. Its wing area is 830
ft2 and it weighs 50,000 lbs at the moment. Assuming that you are flying at the
tropopause on a standard day, you maintain M = 0.8 en route to the rendezvous point
300 nm away, and your TSFC at this Mach and altitude is 1.095/hr, how much gas will
you burn to get there? This one will take some thought, but look at what you need.
Pounds of fuel. That will come from the TSFC. Carefully review the units of TSFC and
decide how you can cancel out terms to get to pounds of fuel. Consider calculating
average drag and using Eq 5.39. - ANSWER 3,300 lb
You are flying with your buddy who has challenged you on spot landings, in which you
reduce power on downwind and maneuver to land without power. If you add power, you
lose the bet. The one who lands closest to the approach end of the runway wins. Today
you reduce power early and roll out on final lower than normal. You establish the normal
(L/D)max for gear down, no flaps final approach glide speed and discover that your
plane is going to land short of the runway. What should you do? - ANSWER Add power
and go around. You lose the bet again.
You are in a glide at (L/D)max, what effect will decreasing your weight (dropping
payload or ejecting your back seater) have on your glide? Glide range will____________.
The velocity to fly at (L/D)max will_____________ - ANSWER not change, decrease
An 12,000 lb T-38 is in a steady climb passing 10,000 ft at 0.5 Mach on a Standard Day.
What is its rate of climb using military thrust? - ANSWER 100 ft/s = 6,000 ft/min