BMW MEMBERS EXAM GUIDE
QUESTIONS AND ANSWERS
When you press the brake pedal in and it releases the brake booster hard. What could
be the cause? - Answer-Vent port
A diagram shows 50 on one end and 110 on the other with different alignment angles.
What would it cause? - Answer-Pulling to the left
Does a vehicle always pull to the most positive caster and negative camber. True or
false? - Answer-False
A bent strut mount can affect camber angle/alignment. True or false? - Answer-True
A vehicle comes in with a engine over heating concern during load but goes away at
idle. What could be the cause? - Answer-Restriction in coolant radiator hose.
what is used to measure key off battery drain ? - Answer-Amp clamp
Vanos solenoid can cause a no start. True or false? - Answer-False
What can be the cause of clunking noise in front of the car? - Answer-Worn or
Damaged stabilizer link
Tech a says over torqued ball joint nut can cause damage to the ball joint stud , Tech B
says that out of round knuckle hole can cause damage to ball joint stud - Answer-Both
Bucking on freeway concerns can be caused by? - Answer-Fuel delivery
steering wheel Jerks every half of a turn. What can be the cause? - Answer-Faulty
steering column U Joint
Cooling system overheats after servicing. What can be the cause - Answer-Air in the
system
infinite resistance on wheel speed sensor and
constant 12v by wheel speed means that they are - Answer-Faulty
AC circuit blows fuse right away. What can be the cause? - Answer-Shorted AC clutch
Tech A says DSC uses steering wheel angle as input, Tech b says DSC uses brake
light switch as input - Answer-Both
ECT temperature gauge not working. What can be the cause? - Answer-Faulty KOMBI
QUESTIONS AND ANSWERS
When you press the brake pedal in and it releases the brake booster hard. What could
be the cause? - Answer-Vent port
A diagram shows 50 on one end and 110 on the other with different alignment angles.
What would it cause? - Answer-Pulling to the left
Does a vehicle always pull to the most positive caster and negative camber. True or
false? - Answer-False
A bent strut mount can affect camber angle/alignment. True or false? - Answer-True
A vehicle comes in with a engine over heating concern during load but goes away at
idle. What could be the cause? - Answer-Restriction in coolant radiator hose.
what is used to measure key off battery drain ? - Answer-Amp clamp
Vanos solenoid can cause a no start. True or false? - Answer-False
What can be the cause of clunking noise in front of the car? - Answer-Worn or
Damaged stabilizer link
Tech a says over torqued ball joint nut can cause damage to the ball joint stud , Tech B
says that out of round knuckle hole can cause damage to ball joint stud - Answer-Both
Bucking on freeway concerns can be caused by? - Answer-Fuel delivery
steering wheel Jerks every half of a turn. What can be the cause? - Answer-Faulty
steering column U Joint
Cooling system overheats after servicing. What can be the cause - Answer-Air in the
system
infinite resistance on wheel speed sensor and
constant 12v by wheel speed means that they are - Answer-Faulty
AC circuit blows fuse right away. What can be the cause? - Answer-Shorted AC clutch
Tech A says DSC uses steering wheel angle as input, Tech b says DSC uses brake
light switch as input - Answer-Both
ECT temperature gauge not working. What can be the cause? - Answer-Faulty KOMBI
