© EVERLY 2025 ALL RIGHTS RESERVED.
Module 2 Welding Safety Exam Questions
And Answers 100% Pass.
In the SMAW method, what kind of consumable electrode is used to place the weld? -
Answer✔flux coated
What is the most common fuel gas used for oxyfuel cutting? - Answer✔acetylene
The Department of Labor's ______________________ sets the minimum standards for training
programs across the country. These must be registered with the US Dept. of Labor. -
Answer✔Office of Apprenticeship
Welders should never wear clothing made from _____________________ or other synthetic
fibers. - Answer✔polyester
While welding, __________________________ offer the most protection, but capes are cooler. -
Answer✔full jackets
_____________________ are the most common form of hearing protection used in welding. -
Answer✔disposable earplugs
To reduce the risk of flash burn, welders should wear a ____________________ with a properly
tinted lens (shades 9-14) over their safety glasses. - Answer✔welding helmet
What organization publishes "Safety in Welding, Cutting, and Allied Processes"? -
Answer✔ANSI Z49.1
Foot and vehicle traffic on the job site becomes more congested and a potential hazard at
_____________________. - Answer✔starting and quitting times
When welding outside of a welding booth, _____________________ should be used to protect
other personnel from the bright glare of the arc. They also help to prevent drafts that interfere
with the stability of the arc. - Answer✔portable screens
What is the most common welding accident? - Answer✔burned hands and arms
A hot work permit is an official authorization from the site manager to perform work that may
pose a _____________________. - Answer✔fire hazard
For safe working conditions, the oxygen level in a confined space must range between 19.5%
and 23.5% by volume, with _______________________ being considered the normal level.
NOT more than 23.5%. - Answer✔21.5%
1|Page
Module 2 Welding Safety Exam Questions
And Answers 100% Pass.
In the SMAW method, what kind of consumable electrode is used to place the weld? -
Answer✔flux coated
What is the most common fuel gas used for oxyfuel cutting? - Answer✔acetylene
The Department of Labor's ______________________ sets the minimum standards for training
programs across the country. These must be registered with the US Dept. of Labor. -
Answer✔Office of Apprenticeship
Welders should never wear clothing made from _____________________ or other synthetic
fibers. - Answer✔polyester
While welding, __________________________ offer the most protection, but capes are cooler. -
Answer✔full jackets
_____________________ are the most common form of hearing protection used in welding. -
Answer✔disposable earplugs
To reduce the risk of flash burn, welders should wear a ____________________ with a properly
tinted lens (shades 9-14) over their safety glasses. - Answer✔welding helmet
What organization publishes "Safety in Welding, Cutting, and Allied Processes"? -
Answer✔ANSI Z49.1
Foot and vehicle traffic on the job site becomes more congested and a potential hazard at
_____________________. - Answer✔starting and quitting times
When welding outside of a welding booth, _____________________ should be used to protect
other personnel from the bright glare of the arc. They also help to prevent drafts that interfere
with the stability of the arc. - Answer✔portable screens
What is the most common welding accident? - Answer✔burned hands and arms
A hot work permit is an official authorization from the site manager to perform work that may
pose a _____________________. - Answer✔fire hazard
For safe working conditions, the oxygen level in a confined space must range between 19.5%
and 23.5% by volume, with _______________________ being considered the normal level.
NOT more than 23.5%. - Answer✔21.5%
1|Page
