MIS 4123 Exam 3 Compilation
Study Guide
The term "domain controller" is a name commonly used to refer to a Microsoft directory
services server - ANSWER True
Each of the full duplex circuits connected to a switch is a separate _______________
circuit connecting
the switch to a device on the network. - ANSWER Point-to-point
A ___ has a set of high-speed storage devices and servers that are networked together
using a very high
speed network - ANSWER Storage area network
Which of the following is not a purpose for using hubs in a network? - ANSWER To act as
a communications server
A collision on a bus circuit means that two computers on that circuit have transmitted at
the same time - ANSWER True
Switch-based Ethernet: - ANSWER Usually enables all attached circuits to send or
receive packets simultaneously
A site survey is not an important component of a WLAN design. - ANSWER False
The ___________ is where the organization housing its primary servers - ANSWER Data
center
A switch uses a _____________ that is very similar to a routing table used in a router -
ANSWER Forwarding table
One of the most important functions of Network Operating System (NOS) is a directory
service - ANSWER True
Breaking a network into smaller parts is called network - ANSWER Segmentation
Which of the following is not a basic LAN component? - ANSWER PAD
With _____________, the AP permits the owner to provide a list of valid addresses that can
connect - ANSWER MAC address filtering
Point Coordination Function requires that each station that wishes to transmit on the
wireless network
,sends a request-to-transmit (RTS) packet to the access point and waits for a
clear-to-send (CTS) packet
from the AP before it can communicate with other nodes on the network - ANSWER True
The Network Interface Card (NIC) permits a computer to be physically connected to a
network's cable - ANSWER True
How many channels does 802.11g provide for communication with clients? - ANSWER 3
A(n) ____________ allows many users to share the same set of files on a common, shared
disk drive - ANSWER File server
Wi-Fi Protected Access (WPA) uses the same key for every packet that is transmitted to
the client - ANSWER False
A switch always broadcasts all the packets it receives to all the computers that are
connected to the
switch - ANSWER False
Most access points (AP) deployed in wireless LANs use directional antennas - ANSWER
False
Physical topology refers to the geometric layout of the network and describes how the
computers are
interconnected - ANSWER True
A(n) _____________ is not a common type of dedicated server - ANSWER Collision server
The data link layer protocols used by wireless LANs are similar to the ones used on
Ethernet LANs - ANSWER True
Wired Ethernet is becoming a _______________ technology for small SOHO devices,
meaning that
manufacturers are no longer creating new products - ANSWER Legacy
Which of the following standards is backward compatible with IEEE802.11a, b, and g? -
ANSWER 802.11n
A hierarchical tree of active directory domains within one organization that is linked to
other trees in the
organization is called a ___________. - ANSWER Forest
802.11n LANs operate at speeds up to 600 Mbps. - ANSWER True
STP cable is the least costly type of cable used in today's networks and is the most
commonly used cable
,type in connecting computers to switches. - ANSWER False
LANs that run on radio frequencies use a type of wired media. - ANSWER False
Hubs: - ANSWER Usually incorporate repeaters or amplifiers
_____________ refers to practice of writing symbols in chalk on sidewalks and walls to
indicate the
presence of an unsecured WLAN - ANSWER Warchalking
Store and forward switching may only be used when the incoming and outgoing data
circuit have the
same data rate. - ANSWER False
A(n) _____________ is used in a computer to connect it to a WLAN - ANSWER Wireless
NIC
One difference between a switch and a router is that a router will only process
messages
addressed to the router (at layer 2), while a switch processes all messages. - ANSWER
True
A routed backbone tends to be used more for large networks than VLANs, although
VLAN
high speed switches and this new type of LAN-BN architecture are now being
considered. - ANSWER True
VLANs provide faster performance compared to switched, collapsed or routed
backbone
architectures. - ANSWER True
Associated with a switched backbone, MDF is an acronym for: - ANSWER Main
distribution facility
Two primary disadvantages to the ______ BN type are that the routers in the network
impose time delays, and routers are typically more expensive and require more
management
than switches. - ANSWER Routed backbone
Computers can be assigned to a VLAN based on the ________. - ANSWER Physical port
on the switch
The _________ is the part of the backbone that connects the different backbones
together. - ANSWER Core layer
, VLANs prioritize traffic based on the ______ - ANSWER IEEE 802.1q
One basic component of a backbone network is the hardware device that connects
other
networks to the backbone - ANSWER True
The _______ is the part of the backbone that connects the LANs together - ANSWER
Distribution layer
A subnetted or hierarchical backbone can also be called - ANSWER Routed backbone
Which of the following is not a type of hardware device that can be used to interconnect
networks? - ANSWER Dumb terminal
Which of the following is not true about Layer-3 switches? - ANSWER They can only
switch messages based on their data link layer addresses
A hardware device that operates at the application layer is a router - ANSWER False
Which of the following is not true about multi-switch VLANs? - ANSWER VLAN
configurations are limited to spanning over no more than two switches
A VLAN requires the computer manager to reconfigure the physical cables to the switch
if a
computer is moved from one port to another port on a switch - ANSWER False
A backbone network is a high-speed network that connects many networks - ANSWER
True
Most backbone devices are store-and-forward devices. One simple way to improve
performance is to ensure that they have ________________. - ANSWER Sufficient memory
Backbone networks typically use lower speed circuits to interconnect a series of LANs
and
provide connections to other backbone networks - ANSWER False
Using ______ capabilities, network managers can connect VOIP phones directly into a
VLAN switch and configure the switch to reserve sufficient network capacity so that
they
will always be able to send and receive voice messages. - ANSWER QoS
Routers can only connect the same type of cable - ANSWER False
The primary advantage of a routed backbone is that it clearly segments each part of the
Study Guide
The term "domain controller" is a name commonly used to refer to a Microsoft directory
services server - ANSWER True
Each of the full duplex circuits connected to a switch is a separate _______________
circuit connecting
the switch to a device on the network. - ANSWER Point-to-point
A ___ has a set of high-speed storage devices and servers that are networked together
using a very high
speed network - ANSWER Storage area network
Which of the following is not a purpose for using hubs in a network? - ANSWER To act as
a communications server
A collision on a bus circuit means that two computers on that circuit have transmitted at
the same time - ANSWER True
Switch-based Ethernet: - ANSWER Usually enables all attached circuits to send or
receive packets simultaneously
A site survey is not an important component of a WLAN design. - ANSWER False
The ___________ is where the organization housing its primary servers - ANSWER Data
center
A switch uses a _____________ that is very similar to a routing table used in a router -
ANSWER Forwarding table
One of the most important functions of Network Operating System (NOS) is a directory
service - ANSWER True
Breaking a network into smaller parts is called network - ANSWER Segmentation
Which of the following is not a basic LAN component? - ANSWER PAD
With _____________, the AP permits the owner to provide a list of valid addresses that can
connect - ANSWER MAC address filtering
Point Coordination Function requires that each station that wishes to transmit on the
wireless network
,sends a request-to-transmit (RTS) packet to the access point and waits for a
clear-to-send (CTS) packet
from the AP before it can communicate with other nodes on the network - ANSWER True
The Network Interface Card (NIC) permits a computer to be physically connected to a
network's cable - ANSWER True
How many channels does 802.11g provide for communication with clients? - ANSWER 3
A(n) ____________ allows many users to share the same set of files on a common, shared
disk drive - ANSWER File server
Wi-Fi Protected Access (WPA) uses the same key for every packet that is transmitted to
the client - ANSWER False
A switch always broadcasts all the packets it receives to all the computers that are
connected to the
switch - ANSWER False
Most access points (AP) deployed in wireless LANs use directional antennas - ANSWER
False
Physical topology refers to the geometric layout of the network and describes how the
computers are
interconnected - ANSWER True
A(n) _____________ is not a common type of dedicated server - ANSWER Collision server
The data link layer protocols used by wireless LANs are similar to the ones used on
Ethernet LANs - ANSWER True
Wired Ethernet is becoming a _______________ technology for small SOHO devices,
meaning that
manufacturers are no longer creating new products - ANSWER Legacy
Which of the following standards is backward compatible with IEEE802.11a, b, and g? -
ANSWER 802.11n
A hierarchical tree of active directory domains within one organization that is linked to
other trees in the
organization is called a ___________. - ANSWER Forest
802.11n LANs operate at speeds up to 600 Mbps. - ANSWER True
STP cable is the least costly type of cable used in today's networks and is the most
commonly used cable
,type in connecting computers to switches. - ANSWER False
LANs that run on radio frequencies use a type of wired media. - ANSWER False
Hubs: - ANSWER Usually incorporate repeaters or amplifiers
_____________ refers to practice of writing symbols in chalk on sidewalks and walls to
indicate the
presence of an unsecured WLAN - ANSWER Warchalking
Store and forward switching may only be used when the incoming and outgoing data
circuit have the
same data rate. - ANSWER False
A(n) _____________ is used in a computer to connect it to a WLAN - ANSWER Wireless
NIC
One difference between a switch and a router is that a router will only process
messages
addressed to the router (at layer 2), while a switch processes all messages. - ANSWER
True
A routed backbone tends to be used more for large networks than VLANs, although
VLAN
high speed switches and this new type of LAN-BN architecture are now being
considered. - ANSWER True
VLANs provide faster performance compared to switched, collapsed or routed
backbone
architectures. - ANSWER True
Associated with a switched backbone, MDF is an acronym for: - ANSWER Main
distribution facility
Two primary disadvantages to the ______ BN type are that the routers in the network
impose time delays, and routers are typically more expensive and require more
management
than switches. - ANSWER Routed backbone
Computers can be assigned to a VLAN based on the ________. - ANSWER Physical port
on the switch
The _________ is the part of the backbone that connects the different backbones
together. - ANSWER Core layer
, VLANs prioritize traffic based on the ______ - ANSWER IEEE 802.1q
One basic component of a backbone network is the hardware device that connects
other
networks to the backbone - ANSWER True
The _______ is the part of the backbone that connects the LANs together - ANSWER
Distribution layer
A subnetted or hierarchical backbone can also be called - ANSWER Routed backbone
Which of the following is not a type of hardware device that can be used to interconnect
networks? - ANSWER Dumb terminal
Which of the following is not true about Layer-3 switches? - ANSWER They can only
switch messages based on their data link layer addresses
A hardware device that operates at the application layer is a router - ANSWER False
Which of the following is not true about multi-switch VLANs? - ANSWER VLAN
configurations are limited to spanning over no more than two switches
A VLAN requires the computer manager to reconfigure the physical cables to the switch
if a
computer is moved from one port to another port on a switch - ANSWER False
A backbone network is a high-speed network that connects many networks - ANSWER
True
Most backbone devices are store-and-forward devices. One simple way to improve
performance is to ensure that they have ________________. - ANSWER Sufficient memory
Backbone networks typically use lower speed circuits to interconnect a series of LANs
and
provide connections to other backbone networks - ANSWER False
Using ______ capabilities, network managers can connect VOIP phones directly into a
VLAN switch and configure the switch to reserve sufficient network capacity so that
they
will always be able to send and receive voice messages. - ANSWER QoS
Routers can only connect the same type of cable - ANSWER False
The primary advantage of a routed backbone is that it clearly segments each part of the