Carpentry 2 Module 8 Exam Questions
and Answers 100% Solved | Graded A+
. For Levels 3, 4, and 5, it is recommended that the prepared
surface be coated with a drywall - ✔✔primer
Drywall requires different levels of finish depending on lighting
conditions, decorative treatment, and - ✔✔location
The highest level of finish that is recommended for gloss,
semigloss, enamel, or nontextured flat paints is - ✔✔Level 5
The highest level of finish at which tool marks and ridges are
considered acceptable is Level - ✔✔Level 2
The metal control hardware used to relieve stresses caused by
expansion and contraction in large ceiling or
wall expanses in interior drywall systems is called a(n) - ✔✔d.
expansion joint
1
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
, The three types of reinforcing tape for drywall use are paper,
metal edge, and - ✔✔a. fiberglass mesh
A type of trim that can be used as an edging or border on an
arched opening is - ✔✔a. reveal trim
One disadvantage of using premix compound is that it must be
kept from - ✔✔a. freezing
The type of compound commonly called 20-minute mud, 30-
minute mud, or hot mud is _____ compound - ✔✔c. quickset
When mixing dry mix with a powered device, such as an electric
drill, the rotation speed should be slow,
typically - ✔✔c. 300 to 500 rpm
Using unsafe tools can not only cause injury, they can also -
✔✔b. ruin finishing work
Finishing knives range from a narrow putty knife to an extremely
wide taping knife with a - ✔✔c. cause environmental pollution
2
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
and Answers 100% Solved | Graded A+
. For Levels 3, 4, and 5, it is recommended that the prepared
surface be coated with a drywall - ✔✔primer
Drywall requires different levels of finish depending on lighting
conditions, decorative treatment, and - ✔✔location
The highest level of finish that is recommended for gloss,
semigloss, enamel, or nontextured flat paints is - ✔✔Level 5
The highest level of finish at which tool marks and ridges are
considered acceptable is Level - ✔✔Level 2
The metal control hardware used to relieve stresses caused by
expansion and contraction in large ceiling or
wall expanses in interior drywall systems is called a(n) - ✔✔d.
expansion joint
1
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
, The three types of reinforcing tape for drywall use are paper,
metal edge, and - ✔✔a. fiberglass mesh
A type of trim that can be used as an edging or border on an
arched opening is - ✔✔a. reveal trim
One disadvantage of using premix compound is that it must be
kept from - ✔✔a. freezing
The type of compound commonly called 20-minute mud, 30-
minute mud, or hot mud is _____ compound - ✔✔c. quickset
When mixing dry mix with a powered device, such as an electric
drill, the rotation speed should be slow,
typically - ✔✔c. 300 to 500 rpm
Using unsafe tools can not only cause injury, they can also -
✔✔b. ruin finishing work
Finishing knives range from a narrow putty knife to an extremely
wide taping knife with a - ✔✔c. cause environmental pollution
2
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
