ACTUAL EXAM COMPREHENSIVE
QUESTIONS AND VERIFIED ANSWERS
GRADED A+ | 100% PASS | 2025 UPDATE!
The names of the devices and channels in dante are - ✔✔✔ Correct
Answer > user definable and remembered by devices
what type of switches does dante use? - ✔✔✔ Correct Answer >
standard
what is latency - ✔✔✔ Correct Answer > latency is the audio signal
delay in any audio system
does a dante network require a special configuration for clocking -
✔✔✔ Correct Answer > no, a clock master is always automatically
elected by dante
if a network is only used for dante and has only one network switch
then - ✔✔✔ Correct Answer > the network does not require a
managed switch
, where do dante settings reside - ✔✔✔ Correct Answer > on the
individual dante devices
when should fiber be used for an ethernet connection - ✔✔✔ Correct
Answer > when runs over 100 m are required
does dante require special networking cabling? - ✔✔✔ Correct
Answer > regular CAT5E ethernet cable is recommended, dante is built
to run on standard IP networks, using standard ip equipment and
cables
dante works best with [blank] switches - ✔✔✔ Correct Answer >
Gigabit
aprox how much bandwidth is consumed by 64 channels of audio at
48kHz/ (excluding network overhead) - ✔✔✔ Correct Answer > 74
mbits/sec
which of the following are diagnostic features of dante controller -
✔✔✔ Correct Answer > Latency and clock monitoring
a connection between dante audio channels is called - ✔✔✔ Correct
Answer > a subscription