C
NICET LEVEL 1 STUDY GUIDE
LO
EXAM QUESTIONS AND
CORRECT DETAILED /
YC
VERIFIED ANSWERS LATEST
UPDATE
D
U
ST
, When testing a water level supervisory switch serving a pressure tank a signal shall indicate if
the water level _____________from the required level
(NFPA 72, Table 14.4.3.2 17 (j) (4) - ANS rises or falls over 3 inches
If combination audible/visible appliances are installed the location of the installed appliance shall
be determined by the requirements of _______.
(Nfpa 72 18.4.8.1) - ANS the visible appliance
K
What is the maximum number of 12 gauge THHN wires that can be installed in 1" EMT?
(Nec Annex C tables) - ANS 26
C
Two resistors are connected in parallel. R1 = 300 Ohms, R2 = 300 Ohms. What is their
equivalent resistance? - ANS 150 ohms
LO
A Room is 200' long and 150' wide and the 8' high ceiling is smooth and flat. A spot type heat
detector has been selected that is listed for a 50' maximum spacing between detectors.
According to NFPA 72 how many detectors will be needed to protect this room?
YC
x = - ANS 12
According to NFPA 72 the minimum number of restorable fixed temperature spot type heat
detectors that must be tested during each annual test is?
(NFPA 72 14.4.4.5.1) - ANS Two detectors or more on each initiating device circuit
D
According to NFPA 72 how many spot type heat detectors are required for a space that is 80'
long and 55 floor wide with a smooth 10' ceiling? the detector is listed for a maximum space
U
between detectors of 30' - ANS 6
What color code requirement for a spot type heat detector rated at 200゚F - ANS White (NFPA
ST
72, Table 17.6.2.1)
Unless otherwise recommended by the manufacturers published instructions single and multiple
stations smoke alarms installed in one and 2 family dwellings shall be replaced every - ANS 10
years from the day-of manufacture. (NFPA 72, 14.4.7.1)
Fire alarm cables are permitted to be strapped to conduit to support the cable - ANS False
(NEC 760.143)
Where non power limited wiring is installed exposed it must be mechanically protected
within_____of the finished floor - ANS 7' ft