Texas State Inspector Safety cert
One of the required procedures in the inspection of the steering is: - answer Turning the
steering wheel from full left to full right
Conventional brakes or non-power brakes must have a minimum pedal reserve of: -
answer2 inch
Any tire with wear bar indicators would be rejected for the following reason: - answer
Tread wear indicators contact the road on any two adjacent major grooves in the center
of the middle of the tire
LED tail lamps may have no more than ______ of diodes malfunctioning to pass
inspection. - answer50%
When performing a road test on the service brakes, a truck weighing over 10,000 lbs
GVW (this would include larger trucks but not truck-trailer combinations) should be
driven at a speed of 20 mph and should stop within: - answer40 feet
The vehicle owner/operator should be present when the inspector is checking CNG tank
located in the trunk of the car. - answerTrue
Glass coating or sun screening materials on windshield may not extend down past the
AS-1 line or more than ____ inches, whichever is closer to the top of the windshield: -
answer5 inches
Brakes would be rejected if: - answerThere is obvious metal to metal contact when
brakes are applied.
When issuing a Vehicle Inspection Report to a vehicle, the VIN will be taken from the: -
answerVehicle
Proof of financial responsibility is not required on motor vehicles prior to the model year
1988. - answerFalse
When is a vehicle required to be inspected for seat belts? - answerAnchorages were
part of the manufactures original equipment
The turn signal selector switch must lock in the proper position when applied on: -
answerAll vehicles
One of the required procedures in the inspection of the steering is: - answer Turning the
steering wheel from full left to full right
Conventional brakes or non-power brakes must have a minimum pedal reserve of: -
answer2 inch
Any tire with wear bar indicators would be rejected for the following reason: - answer
Tread wear indicators contact the road on any two adjacent major grooves in the center
of the middle of the tire
LED tail lamps may have no more than ______ of diodes malfunctioning to pass
inspection. - answer50%
When performing a road test on the service brakes, a truck weighing over 10,000 lbs
GVW (this would include larger trucks but not truck-trailer combinations) should be
driven at a speed of 20 mph and should stop within: - answer40 feet
The vehicle owner/operator should be present when the inspector is checking CNG tank
located in the trunk of the car. - answerTrue
Glass coating or sun screening materials on windshield may not extend down past the
AS-1 line or more than ____ inches, whichever is closer to the top of the windshield: -
answer5 inches
Brakes would be rejected if: - answerThere is obvious metal to metal contact when
brakes are applied.
When issuing a Vehicle Inspection Report to a vehicle, the VIN will be taken from the: -
answerVehicle
Proof of financial responsibility is not required on motor vehicles prior to the model year
1988. - answerFalse
When is a vehicle required to be inspected for seat belts? - answerAnchorages were
part of the manufactures original equipment
The turn signal selector switch must lock in the proper position when applied on: -
answerAll vehicles
