OSHA 510 EXAM 2024 /2025 ACTUAL COMPLETE 400 REAL
EXAM QUESTIONS WITH CORRECTDETAILED ANSWERS
(VERIFIED ANSWERS) BRAND NEW!! / ALREADY GRADED A+
Type C: cohesive soils with an unconfined compressive strength
of __ tsf or less
- ANSWER -0.5
tsf
Type A can be sloped at a ratio of __ if the excavation will be
open for less than
24 hours and is less than 12 feet in depth -
ANSWER -1/2 : 1
Any excavation more than __ feet in depth requires a qualified
person to design
the protection - ANSWER -
20 feet
The purpose of an OSHA compliance directive (CPL) is to
insure - ANSWER -
consistent enforcement of OSHA
regulations
,the four types of and definitions of employers in a multi-
employer situation are -
ANSWER -1. creating
employer
2. exposing
employer
3.
correcting
4.
controlling
Creating Employer - ANSWER -employer that created or caused
the hazard
Exposing employer - ANSWER -employer whose own employees
were exposed
Correcting employer - ANSWER -employer responsible for
correcting hazard
Controlling employer - ANSWER -general supervisory authority
with the power to
require
correction
, For an employer to provide a defense against a citation in a
multi-employer situation, the employer must show the following:
- ANSWER -1. employer did not cause the hazard to exist
2. employer did not directly control conditions causing the
hazards
3. employer has taken reasonable steps to notify the party(s)
charged with cause and control of the problem
4. employer has taken reasonable steps to keep his/her
employees away from the hazard
Inspections must be done by a _____ person. - ANSWER -
competent
The four steps in conducting a JSA are - ANSWER -1.
identify job to be
examined
2. identify steps/ tasks
of job
3. identify the hazard of each
key step
4. identify control(s) address each
hazard
A safety audit is __ in nature while inspections are __ - ANSWER
-quantitative;
qualitative
EXAM QUESTIONS WITH CORRECTDETAILED ANSWERS
(VERIFIED ANSWERS) BRAND NEW!! / ALREADY GRADED A+
Type C: cohesive soils with an unconfined compressive strength
of __ tsf or less
- ANSWER -0.5
tsf
Type A can be sloped at a ratio of __ if the excavation will be
open for less than
24 hours and is less than 12 feet in depth -
ANSWER -1/2 : 1
Any excavation more than __ feet in depth requires a qualified
person to design
the protection - ANSWER -
20 feet
The purpose of an OSHA compliance directive (CPL) is to
insure - ANSWER -
consistent enforcement of OSHA
regulations
,the four types of and definitions of employers in a multi-
employer situation are -
ANSWER -1. creating
employer
2. exposing
employer
3.
correcting
4.
controlling
Creating Employer - ANSWER -employer that created or caused
the hazard
Exposing employer - ANSWER -employer whose own employees
were exposed
Correcting employer - ANSWER -employer responsible for
correcting hazard
Controlling employer - ANSWER -general supervisory authority
with the power to
require
correction
, For an employer to provide a defense against a citation in a
multi-employer situation, the employer must show the following:
- ANSWER -1. employer did not cause the hazard to exist
2. employer did not directly control conditions causing the
hazards
3. employer has taken reasonable steps to notify the party(s)
charged with cause and control of the problem
4. employer has taken reasonable steps to keep his/her
employees away from the hazard
Inspections must be done by a _____ person. - ANSWER -
competent
The four steps in conducting a JSA are - ANSWER -1.
identify job to be
examined
2. identify steps/ tasks
of job
3. identify the hazard of each
key step
4. identify control(s) address each
hazard
A safety audit is __ in nature while inspections are __ - ANSWER
-quantitative;
qualitative
