VIVINT SHP PRACTICE EXAM
QUESTIONS AND VERIFIED
ANSWERS
True or false? The firefighter may be positioned adjacent to a solo battery-
powered smoke detector - False.
True or false: When doing a comprehensive system test, you can bypass any
open doors or windows. - Answer: False
When programming with SKEY1, you must: - Answer. Always enable the
emergency key.
True or false: when running power to the take-345, polarity does not matter -
ANSWER False
When programming the emergency key for SKEY1, which zone/sensor types
are recommended to use? - ANSWER. Audible alarm 07, auxiliary alarm 08
True or false: When installing an SMKT3, you must use the accompanying
screws and anchors. - ANSWER True
True or false, while installing the firefighter, it is needed to test the customer's
current smoke detectors.
When installing a DW 21, where is the approved location for the sensor? -
Answer 6 inches (15 cm) to 2 inches (61 cm) from the floor.
When placing a DW11 on a vinyl or metal frame, what should you primarily
use to mount the sensor— ANSWER Provided double-sided tape.
Which of the following materials can be used to group several ground terminals
in the takeover module? ANSWER B connectors/beans and wire caps.
QUESTIONS AND VERIFIED
ANSWERS
True or false? The firefighter may be positioned adjacent to a solo battery-
powered smoke detector - False.
True or false: When doing a comprehensive system test, you can bypass any
open doors or windows. - Answer: False
When programming with SKEY1, you must: - Answer. Always enable the
emergency key.
True or false: when running power to the take-345, polarity does not matter -
ANSWER False
When programming the emergency key for SKEY1, which zone/sensor types
are recommended to use? - ANSWER. Audible alarm 07, auxiliary alarm 08
True or false: When installing an SMKT3, you must use the accompanying
screws and anchors. - ANSWER True
True or false, while installing the firefighter, it is needed to test the customer's
current smoke detectors.
When installing a DW 21, where is the approved location for the sensor? -
Answer 6 inches (15 cm) to 2 inches (61 cm) from the floor.
When placing a DW11 on a vinyl or metal frame, what should you primarily
use to mount the sensor— ANSWER Provided double-sided tape.
Which of the following materials can be used to group several ground terminals
in the takeover module? ANSWER B connectors/beans and wire caps.
