LATEST 2024 GENERAL CRANE SAFETY TEST REAL
QUESTIONS AND CORRECT VERIFIED ANSWERS (FULL
REVISED EXAM) A NEW UPDATED VERSION |RATED A+
GUARANTEED PASS A+ (BRAND NEW!!)
What OSHA regulation cover cranes and derricks in construction ? - ANSWER:
1926.1400
When working on outriggers, the only time they should be less than fully extended is
: - ANSWER: There is a load chart for this operation
When should a tagline be used ? - ANSWER: When rotation of the Load would be
dangerous
When an operator arrives at a jobsite, and the crane is already erected, how would
he check the hoists brakes ? - ANSWER: Lift a load a few inches and apply the brake
Load radius is the distance from the center of gravity of a freely suspended load to
the : - ANSWER: Center of rotation of the crane
Capacities of a crawler crane are based on what percentage of a cranes structural
design ? - ANSWER: 75 %
All hazards and potential problems should be discovered during the : - ANSWER:
Daily Inspection
How many broken wires are allowed in rotation resistant rope within a distance of
30 times the diameter ? - ANSWER: 3
In a range diagram, boom length and angle can be used to determine : - ANSWER:
Load radius
The angles listed in a cranes load chart : - ANSWER: Are based on a loaded boom
What is the primary reason for using a jib : - ANSWER: Increase tip height
What is the safety factor for non-rotating rope when used on a personnel basket -
ANSWER: 10:1
If a bold line is shown on a load chart, the capacities above the line : - ANSWER: Are
based on the structural strength of the crane
Truck cranes capacities are generally greater over the : - ANSWER: rear
QUESTIONS AND CORRECT VERIFIED ANSWERS (FULL
REVISED EXAM) A NEW UPDATED VERSION |RATED A+
GUARANTEED PASS A+ (BRAND NEW!!)
What OSHA regulation cover cranes and derricks in construction ? - ANSWER:
1926.1400
When working on outriggers, the only time they should be less than fully extended is
: - ANSWER: There is a load chart for this operation
When should a tagline be used ? - ANSWER: When rotation of the Load would be
dangerous
When an operator arrives at a jobsite, and the crane is already erected, how would
he check the hoists brakes ? - ANSWER: Lift a load a few inches and apply the brake
Load radius is the distance from the center of gravity of a freely suspended load to
the : - ANSWER: Center of rotation of the crane
Capacities of a crawler crane are based on what percentage of a cranes structural
design ? - ANSWER: 75 %
All hazards and potential problems should be discovered during the : - ANSWER:
Daily Inspection
How many broken wires are allowed in rotation resistant rope within a distance of
30 times the diameter ? - ANSWER: 3
In a range diagram, boom length and angle can be used to determine : - ANSWER:
Load radius
The angles listed in a cranes load chart : - ANSWER: Are based on a loaded boom
What is the primary reason for using a jib : - ANSWER: Increase tip height
What is the safety factor for non-rotating rope when used on a personnel basket -
ANSWER: 10:1
If a bold line is shown on a load chart, the capacities above the line : - ANSWER: Are
based on the structural strength of the crane
Truck cranes capacities are generally greater over the : - ANSWER: rear
